Jiatian Lin

The heating rates and forming temperatures during the hot forming process of titanium alloys cause significant differences in phase transformation, grain size, and dislocation evolution. The formability and service performance of titanium alloy formed components are affected by these factors. This study investigated the hot flow behaviors of Ti-6Al-4V at temperatures ranging from 800 to 900 °C and heating rates ranging from 0.1 to 10 °C/s. These were tested via Gleeble hot tensile experiments, and the grain size and phase evolution were quantitatively characterized via EBSD and XRD. The results suggest that a higher heating rate decreases the β-phase transformation and dislocation density and inhibits grain coarsening, leading to better formability. The heating rate was introduced into the viscoplastic constitutive model for the first time to achieve accurate predictions of the microstructure and hot flow behavior under different heating rates. The prediction accuracy of the hot flow behavior and phase volume fraction reaches 92.93% and 94.97%. The current-assisted hot stamping experiments and finite element (FE) simulations of Ti-6Al-4V irregular cross-section components were carried out at temperatures of 800 and 900 °C and at heating rates of 1 and 3 °C/s. The results show that the rapidly heated formed components exhibit better thickness uniformity and yield strength. The FE simulation guided by the optimized constitutive model has achieved a 96.96% and 92.76% prediction accuracy for the thickness distribution and β-phase volume fraction, respectively.

This paper presents a systematic study of heating effects on the hot deformation and microstructure of dual-phase titanium alloy Ti-6Al-4V (TC4) under hot forming conditions. Firstly, hot flow behaviors of TC4 were characterized by conducting tensile tests at different heating temperatures ranging from 850 °C to 950 °C and heating rates ranging from 1 to 100 °C/s. Microstructure analysis, including phase and grain size, was carried out under the different heating conditions using SEM and EBSD. The results showed that when the heating temperature was lower than 900 °C, a lower heating rate could promote a larger degree of phase transformation from α to β, thus reducing the flow stress and improving the ductility. When the temperature reached 950 °C, a large heating rate effectively inhibited the grain growth and enhanced the formability. Subsequently, according to the mechanism of phase transformation during heating, a phenomenological phase model was established to predict the evolution of the phase volume fraction at different heating parameters with an error of 5.17%. Finally, a specific resistance heating device incorporated with an air-cooling set-up was designed and manufactured to deform TC4 at different heating parameters to determine its post-form strength. Particularly, the yield strength at the temperature range from 800 °C to 900 °C and the heating rate range from 30 to 100 °C/s were obtained. The results showed that the yield strength generally increased with the increase of heating temperature and the decrease of heating rate, which was believed to be dominated by the phase transformation.