TZTeng Zhang

Teng Zhang

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Teng Zhang has a total of 17 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Enhancing the Performance of Dye-Sensitized Solar Cells with a Three-Layer Photoanode

    by Zhou Li, Lihua Bai, Yuan Zhang, Zhangyang Zhou, Teng Zhang

    Dye-sensitized solar cells (DSCs) have garnered significant attention due to their high power conversion efficiency and low production cost-effectiveness. In this study, we developed a hierarchically structured three-layer TiO2 photoanode via hydrothermal synthesis to significantly enhance DSC performance. The optimized device achieved a short-circuit current density of 16.92 mA/cm2 and a photoelectric conversion efficiency of 8.34%, representing improvements of 15.67% and 20.5%, respectively, compared to traditional DSCs with a single-layer TiO2 photoanode in our study. The significance lies in the rational design principle rather than absolute efficiency. This performance enhancement stems from the complementary functions of each architectural layer: (1) a bottom layer of TiO2 nanocrystals providing high surface area for dye adsorption, (2) an intermediate layer of vertically aligned TiO2 nanorods enabling efficient electron transport, and (3) a top layer of TiO2 microspheres simultaneously boosting dye loading and light harvesting through enhanced light scattering. Our findings demonstrate that rational design of multi-layered photoanode architectures can effectively address the competing demands of surface area, charge transport, and light management in high-performance DSCs.

  • Microstructural and nonlinear optical properties of quaternary gallium-titanium-zinc-oxide transparent conductive semiconductor thin films

    by Zhen Yu, Jiying Yu, Yuan Zhang, Dahua Ren, Jinqiao Yi, Qiang Li, Teng Zhang

    Transparent and conductive quaternary gallium-titanium-zinc-oxide films were grown on glass substrates by radio-frequency magnetron sputtering. The effects of growth temperature on structure, morphology, electrical, and nonlinear optical properties of the films were investigated systematically. All the deposited films possess hexagonal wurtzite structure with (002) preferred crystallographic orientation. The obtained optical bandgaps of the deposited films are larger than that of pure zinc oxide, which is ascribed to the reduction in band tail width. The film deposited at growth temperature of [ ]C exhibits the optimum crystalline quality with the lowest dislocation density of [ ] nm[ ], the highest visible light transparency of 82.06%, the minimum sheet resistance of 11.2 [ ]/sq, and the maximum figure-of-merit of [ ] [ ][ ]. The present findings indicate that the gallium-titanium-zinc-oxide films are promisingly utilized as transparent conductive layer. The refractive index and extinction coefficient of the deposited films were estimated by using spectrum fitting approach. A normal optical dispersion behavior was observed in visible region, while an anomalous dispersion behavior appeared in ultraviolet region. In addition, the nonlinear optical parameters were obtained. This first-hand information is useful for future rational design of multicomponent zinc oxide semiconductor materials for optoelectronic applications.

  • Open Access

    Sub-5 nm Gate-Length Monolayer Selenene Transistors

    by Qiang Li, Xingyi Tan, Yongming Yang, Xiaoyong Xiong, Teng Zhang, Zhulin Weng

    Two-dimensional (2D) semiconductors are being considered as alternative channel materials as silicon-based field-effect transistors (FETs) have reached their scaling limits. Recently, air-stable 2D selenium nanosheet FETs with a gate length of 5 µm were experimentally produced. In this study, we used an ab initio quantum transport approach to simulate sub-5 nm gate-length double-gate monolayer (ML) selenene FETs. When considering negative-capacitance technology and underlap, we found that 3 nm gate-length p-type ML selenene FETs can meet the 2013 ITRS standards for high-performance applications along the armchair and zigzag directions in the 2028 horizon. Therefore, ML selenene has the potential to be a channel material that can scale Moore’s law down to a gate length of 3 nm.