Toshitsugu Moroizumi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Toshitsugu Moroizumi has a total of 2 co-authors. Here are the top co-authors by number of shared publications:
Haruhiko Horino
College of Agriculture, Osaka Prefecture University 1‐1 Gakuen‐town Sakai‐city Osaka 599‐8531 Japan
2 shared publicationsYumi Sasaki
Graduate School of Environmental Science, Okayama Univ. 3‐1‐1 Tsushima‐naka Okayama 700‐8530 Japan
1 shared publication
Latest Publications
- 1 November 2008
- Published by Wiley in Soil Science Society of America Journal
- Vol. 72 (6) , 1520-1526
Estimating the Nonaqueous‐Phase Liquid Content in Saturated Sandy Soil Using Amplitude Domain Reflectometry
Groundwater contamination by nonaqueous‐phase liquids (NAPLs) has become a serious environmental issue. Therefore, it is necessary to estimate the NAPL content (θ NAPL ) in saturated soil to detect and monitor the NAPL contamination in groundwater. The objective of this study was to investigate three estimation methods for the θ NAPL in saturated sandy soil, namely, the noncalibration method (NCM), the permittivity regression method (PRM), and the best‐fit α method (BFαM). These methods utilize the permittivity (K) measured by amplitude domain reflectometry (ADR) and two dielectric mixing models: a theoretical Maxell–de Loor (MD) model and an empirical α model. The NCM applies the measured K to the models directly. The PRM applies the measured K to the models indirectly using the regression equation between the measured and estimated K The RMSEs of the NCM for the α model were 0.038 m 3 m −3 for light NAPL (LNAPL) and 0.015 m 3 m −3 for dense NAPL (DNAPL) when the constant α value was set at 0.5. The RMSEs of the MD model, however, were 0.090 m 3 m −3 for LNAPL and 0.070 m 3 m −3 for DNAPL. Using the PRM, the RMSEs of the MD model became much better than those of the NCM. The RMSEs for θ NAPL estimated by the BFαM were 0.007 m 3 m −3 for LNAPL and 0.018 m 3 m −3 for DNAPL. These results demonstrate that θ NAPL was estimated easily and with sufficient accuracy with the α model and the PRM.
- 1 November 2008
- Published by Wiley in Soil Science Society of America Journal
- Vol. 72 (6) , 1520-1526
Estimating the Nonaqueous‐Phase Liquid Content in Saturated Sandy Soil Using Amplitude Domain Reflectometry
Groundwater contamination by nonaqueous‐phase liquids (NAPLs) has become a serious environmental issue. Therefore, it is necessary to estimate the NAPL content (θ NAPL ) in saturated soil to detect and monitor the NAPL contamination in groundwater. The objective of this study was to investigate three estimation methods for the θ NAPL in saturated sandy soil, namely, the noncalibration method (NCM), the permittivity regression method (PRM), and the best‐fit α method (BFαM). These methods utilize the permittivity (K) measured by amplitude domain reflectometry (ADR) and two dielectric mixing models: a theoretical Maxell–de Loor (MD) model and an empirical α model. The NCM applies the measured K to the models directly. The PRM applies the measured K to the models indirectly using the regression equation between the measured and estimated K The RMSEs of the NCM for the α model were 0.038 m 3 m −3 for light NAPL (LNAPL) and 0.015 m 3 m −3 for dense NAPL (DNAPL) when the constant α value was set at 0.5. The RMSEs of the MD model, however, were 0.090 m 3 m −3 for LNAPL and 0.070 m 3 m −3 for DNAPL. Using the PRM, the RMSEs of the MD model became much better than those of the NCM. The RMSEs for θ NAPL estimated by the BFαM were 0.007 m 3 m −3 for LNAPL and 0.018 m 3 m −3 for DNAPL. These results demonstrate that θ NAPL was estimated easily and with sufficient accuracy with the α model and the PRM.
- 1 July 2004
- Published by Wiley in Soil Science Society of America Journal
- Vol. 68 (4) , 1138-1144
Tillage Effects on Subsurface Drainage
Tillage near the soil surface may greatly influence drainage discharge and pressure head values in the subsurface zone. In this study, a controlled comparative experiment was conducted in the field under natural weather conditions, using a tilled and an untilled column, to evaluate the effects of tillage on subsurface drainage discharge and pressure head values. There were no significant differences between the two columns in subsurface drainage before tillage treatment before the study, as checked by a preliminary experiment. After tilling one column of the two columns, cumulative subsurface drainage discharge was larger and occurred earlier for the tilled column than for the untilled column. The measured drainage discharge and pressure head values were evaluated using the water movement model, HYDRUS version 6.0, which numerically solves the Richards equation. The HYDRUS model reproduced measured values well for subsurface drainage discharge and pressure head values after the tillage, as determined by root mean squared error (RMSE), mean bias error (MBE), and R 2 Therefore, it is concluded that the model, which includes the effects of tillage on the hydraulic properties, can explain the reasons for differences in observed drainage in the two columns. Moreover, the effects of tillage depth on subsurface drainage discharge were simulated. The results implied that the effect of tillage on subsurface drainage were induced by the conditions of pressure head just before the first rainfall, and this effect was equal to, or greater than, the effects of changes in hydraulic properties due to tillage.
- 1 July 2004
- Published by Wiley in Soil Science Society of America Journal
- Vol. 68 (4) , 1138-1144
Tillage Effects on Subsurface Drainage
Tillage near the soil surface may greatly influence drainage discharge and pressure head values in the subsurface zone. In this study, a controlled comparative experiment was conducted in the field under natural weather conditions, using a tilled and an untilled column, to evaluate the effects of tillage on subsurface drainage discharge and pressure head values. There were no significant differences between the two columns in subsurface drainage before tillage treatment before the study, as checked by a preliminary experiment. After tilling one column of the two columns, cumulative subsurface drainage discharge was larger and occurred earlier for the tilled column than for the untilled column. The measured drainage discharge and pressure head values were evaluated using the water movement model, HYDRUS version 6.0, which numerically solves the Richards equation. The HYDRUS model reproduced measured values well for subsurface drainage discharge and pressure head values after the tillage, as determined by root mean squared error (RMSE), mean bias error (MBE), and R 2 Therefore, it is concluded that the model, which includes the effects of tillage on the hydraulic properties, can explain the reasons for differences in observed drainage in the two columns. Moreover, the effects of tillage depth on subsurface drainage discharge were simulated. The results implied that the effect of tillage on subsurface drainage were induced by the conditions of pressure head just before the first rainfall, and this effect was equal to, or greater than, the effects of changes in hydraulic properties due to tillage.
- 1 August 2002
- Published by Wolters Kluwer Health in Soil Science
- Vol. 167 (8) , 548-559
THE EFFECTS OF TILLAGE ON SOIL TEMPERATURE AND SOIL WATER
Tillage in farmland plays an important role not only as a soil management tool for improving the plant root environment, but also as a factor that impacts the hydrological cycle and the energy balance in a region. This is because tillage affects soil moisture and soil temperature greatly in the unsaturated soil zone near the surface, which acts as an interface between the subsurface and the low atmosphere boundary. In this study, field experiments were conducted under natural weather conditions using two columns of a volcanic ash (andosol) soil to estimate the effects of tillage on soil temperature, pressure head, and evaporation in the unsaturated soil zone. The experimental results were compared with simulated pressure head and soil temperature values in the unsaturated soil zone. A one-dimensional model for simultaneous heat and water transport, based on the theory proposed by P. C. D. Milly in 1982 and 1984, was used. The governing equations were solved by the Galerkin finite element method. The simulated soil temperatures were in good agreement with the measured soil temperatures at most of the soil depths for both columns. After tillage, however, the simulated soil temperatures of the tilled column were higher than those of the untilled column for depths of 4, 9, and 14 cm in the daytime. The simulated pressure head values were in agreement with the measured values up to the tillage in the tilled column. After the tillage treatment for the tilled column and 60 h of elapsed time for the untilled column, the simulated pressure head values were in poorer agreement with the measured ones. After the tillage, however, the simulated pressure head values were greater for the tilled column than for the untilled column for depths of 5, 10, and 25 cm. This reflects the same results as with the measured pressure head results.
- 1 August 2002
- Published by Wolters Kluwer Health in Soil Science
- Vol. 167 (8) , 548-559
THE EFFECTS OF TILLAGE ON SOIL TEMPERATURE AND SOIL WATER
Tillage in farmland plays an important role not only as a soil management tool for improving the plant root environment, but also as a factor that impacts the hydrological cycle and the energy balance in a region. This is because tillage affects soil moisture and soil temperature greatly in the unsaturated soil zone near the surface, which acts as an interface between the subsurface and the low atmosphere boundary. In this study, field experiments were conducted under natural weather conditions using two columns of a volcanic ash (andosol) soil to estimate the effects of tillage on soil temperature, pressure head, and evaporation in the unsaturated soil zone. The experimental results were compared with simulated pressure head and soil temperature values in the unsaturated soil zone. A one-dimensional model for simultaneous heat and water transport, based on the theory proposed by P. C. D. Milly in 1982 and 1984, was used. The governing equations were solved by the Galerkin finite element method. The simulated soil temperatures were in good agreement with the measured soil temperatures at most of the soil depths for both columns. After tillage, however, the simulated soil temperatures of the tilled column were higher than those of the untilled column for depths of 4, 9, and 14 cm in the daytime. The simulated pressure head values were in agreement with the measured values up to the tillage in the tilled column. After the tillage treatment for the tilled column and 60 h of elapsed time for the untilled column, the simulated pressure head values were in poorer agreement with the measured ones. After the tillage, however, the simulated pressure head values were greater for the tilled column than for the untilled column for depths of 5, 10, and 25 cm. This reflects the same results as with the measured pressure head results.