JYJ.B. Yang

J.B. Yang

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


J.B. Yang has a total of 4 co-authors. Here are the top co-authors by number of shared publications:

  • M. Hasegawa

    Institute for Materials Research, Tohoku University , Sendai, Miyagi, 980-8577, Japan ; The Oarai Center , Institute for Materials Research, Tohoku University , Oarai, Ibaraki, 311-1313, Japan

    2 shared publications
  • Yasuyoshi Nagai

    Institute for Materials Research, Tohoku University, Oarai, Japan

    2 shared publications
  • Yu.N. Osetsky

    Materials Science and Technology Division , ORNL , One Bethel Valley Road, P.O. Box 2008, MS-6138 Oak Ridge, TN 37831, USA

    1 shared publication
  • Z.G. Yang

    Department of Materials Science and Engineering , Tsinghua University , Beijing, 100084, P.R. China

    1 shared publication

Latest Publications

  • Atomic scale modeling of {110} twist grain boundaries in α-iron: Structure and energy properties

    by J.B. Yang, Y. Nagai, M. Hasegawa, Yu.N. Osetsky

    Atomic scale modeling was used to study the structure and energy of {110} twist grain boundaries (TWGBs) with various coincidence-site-lattice misorientations in α-iron. The small angle {110} TWGB contains a hexagonal dislocation network of two sets of 1/2⟨111⟩ and one set of ⟨001⟩ dislocation segments. The ⟨001⟩ segments are almost pure screw dislocations and the angle between the two 1/2⟨111⟩ segments varies from 83 to 109° for the rotation angle from 0.25 to 5.40°. This TWGB dislocation structure agrees well with an experimental observation that was not explained adequately so far. The large-angle TWGBs consist of periodic patterns rather than a dislocation network. The variation of the boundary energy with the rotation angle can be well fitted to the Read–Shockley equation in the low-angle range. An apparent cusp in the curve of the boundary energy against the rotation angle has been found and discussed.


  • Shape deformation by moving a glissile interface with one set of misfit dislocations

    by J.B. Yang, Z.G. Yang, Y. Nagai, M. Hasegawa

    Transformation and misfit dislocations are used to describe the motion of glissile interfaces with one set of misfit dislocations in the framework of the Frank−Bilby equation. The sweep of these glissile interfaces brings about an invariant-plane-strain type shape deformation. Our approach explains the glissile motion of martensitic interfaces and small-angle symmetrical tilt grain boundaries. It is consistent with the phenomenological theory of martensite crystallography but more flexible.