Arnab Manna
Research Subjects
Arnab Manna has a total of 61 co-authors. Here are the top co-authors by number of shared publications:
- Arka Majumdar
University of Washington
11 shared publications - David Sharp
Department of Physics, University of Washington, Seattle, USA
6 shared publications - Christopher Munley
Department of Physics, University of Washington, Seattle, Washington 98195, United States
4 shared publications Hannah Rarick
Department of Electrical & Computer Engineering
3 shared publicationsAbhinav Kala
Department of Electrical and Computer Engineering
2 shared publications- Brandi Michelle Cossairt
University of Washington
2 shared publications
Latest Publications
- 29 March 2026
- Published by American Chemical Society (ACS) in ACS Photonics
- Vol. 13 (8) , 2182-2188
All-Dielectric Metasurface with a Two-Dimensional Locally Flat Photonic Band
- 29 March 2026
- Published by American Chemical Society (ACS) in ACS Photonics
- Vol. 13 (8) , 2182-2188
All-Dielectric Metasurface with a Two-Dimensional Locally Flat Photonic Band
- Open Access
- 24 December 2025
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry A
- Vol. 130 (1) , 298-307
Single-Particle Photothermal Microscopy Using On-Chip Silicon Nitride Microring Resonators
Optical microresonators confine light in time and space, enabling high sensitivity for the detection of small thermal perturbations. We utilized these properties and investigated on-chip integrated silicon nitride microring resonators (MRRs) for single-particle photothermal microscopy. We calibrate the technique using individual nonphotoluminescent carbon nanotubes and determine values for absorption cross-section per atom that agree with literature values. Finite-element simulations are performed to track all relevant thermal gradients. The combination of experiment and simulation allows for discussion of the benefits and drawbacks of the planar MRR geometry for single-particle microscopy.
- 24 December 2025
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry A
- Vol. 130 (1) , 298-307
Open AccessSingle-Particle Photothermal Microscopy Using On-Chip Silicon Nitride Microring Resonators
Optical microresonators confine light in time and space, enabling high sensitivity for the detection of small thermal perturbations. We utilized these properties and investigated on-chip integrated silicon nitride microring resonators (MRRs) for single-particle photothermal microscopy. We calibrate the technique using individual nonphotoluminescent carbon nanotubes and determine values for absorption cross-section per atom that agree with literature values. Finite-element simulations are performed to track all relevant thermal gradients. The combination of experiment and simulation allows for discussion of the benefits and drawbacks of the planar MRR geometry for single-particle microscopy.
- 10 April 2025
- Published by American Chemical Society (ACS) in ACS Nano
- Vol. 19 (15) , 14557-14578
Opportunities and Challenges of Solid-State Quantum Nonlinear Optics
Nonlinear interactions between photons are fundamentally weak as the photons do not interact directly with each other, and any interaction is mediated by matter. This has motivated researchers over many decades to search for strongly nonlinear materials (by controlling electronic properties) and optical resonators with strong spatial and temporal confinement of light. An extreme form of nonlinear optics is quantum nonlinear optics, where we can realize nonlinear interaction between single photons. Such quantum nonlinear optics is at the heart of any photonic quantum information system including analog quantum simulation and fault-tolerant quantum computing. While engineering light-matter interactions can effectively create photon-photon interactions, the required photon number to observe any nonlinearity are normally very high, where any quantum-mechanical signature disappears. However, with emerging low-dimensional materials and engineered photonic resonators, the photon number can be reduced to reach the quantum nonlinear optical regime. In this review paper, we discuss different mechanisms exploited in solid-state platforms to attain quantum nonlinear optics. We review emerging materials and optical resonator architectures with different dimensionalities. We also present future research directions and open problems in this field.
- 10 April 2025
- Published by American Chemical Society (ACS) in ACS Nano
- Vol. 19 (15) , 14557-14578
Opportunities and Challenges of Solid-State Quantum Nonlinear Optics
Nonlinear interactions between photons are fundamentally weak as the photons do not interact directly with each other, and any interaction is mediated by matter. This has motivated researchers over many decades to search for strongly nonlinear materials (by controlling electronic properties) and optical resonators with strong spatial and temporal confinement of light. An extreme form of nonlinear optics is quantum nonlinear optics, where we can realize nonlinear interaction between single photons. Such quantum nonlinear optics is at the heart of any photonic quantum information system including analog quantum simulation and fault-tolerant quantum computing. While engineering light-matter interactions can effectively create photon-photon interactions, the required photon number to observe any nonlinearity are normally very high, where any quantum-mechanical signature disappears. However, with emerging low-dimensional materials and engineered photonic resonators, the photon number can be reduced to reach the quantum nonlinear optical regime. In this review paper, we discuss different mechanisms exploited in solid-state platforms to attain quantum nonlinear optics. We review emerging materials and optical resonator architectures with different dimensionalities. We also present future research directions and open problems in this field.
- 2 November 2024
- Published by American Chemical Society (ACS) in ACS Photonics
- Vol. 11 (11) , 4635-4641
Enhanced Second-Harmonic Generation in a Monolayer Tungsten Diselenide Integrated Silicon Nitride Nanocavity
- 2 November 2024
- Published by American Chemical Society (ACS) in ACS Photonics
- Vol. 11 (11) , 4635-4641
Enhanced Second-Harmonic Generation in a Monolayer Tungsten Diselenide Integrated Silicon Nitride Nanocavity
- 8 May 2024
- Published by American Chemical Society (ACS) in ACS Photonics
- Vol. 11 (6) , 2465-2470
Nanolaser Using Colloidal Quantum Wells Deterministically Integrated on a Nanocavity
- 8 May 2024
- Published by American Chemical Society (ACS) in ACS Photonics
- Vol. 11 (6) , 2465-2470
Nanolaser Using Colloidal Quantum Wells Deterministically Integrated on a Nanocavity
- 19 April 2024
- Published by American Chemical Society (ACS) in ACS Nano
- Vol. 18 (17) , 11245-11256
Nonvolatile Phase-Only Transmissive Spatial Light Modulator with Electrical Addressability of Individual Pixels
Active metasurfaces with tunable subwavelength-scale nanoscatterers are promising platforms for high-performance spatial light modulators (SLMs). Among the tuning methods, phase-change materials (PCMs) are attractive because of their nonvolatile, threshold-driven, and drastic optical modulation, rendering zero-static power, crosstalk immunity, and compact pixels. However, current electrically controlled PCM-based metasurfaces are limited to global amplitude modulation, which is insufficient for SLMs. Here, an individual-pixel addressable, transmissive metasurface is experimentally demonstrated using the low-loss PCM Sb2Se3 and doped silicon nanowire heaters. The nanowires simultaneously form a diatomic metasurface, supporting a high-quality-factor (∼406) quasi-bound-state-in-the-continuum mode. A global phase-only modulation of ∼0.25π (∼0.2π) in simulation (experiment) is achieved, showing ten times enhancement. A 2π phase shift is further obtained using a guided-mode resonance with enhanced light-Sb2Se3 interaction. Finally, individual-pixel addressability and SLM functionality are demonstrated through deterministic multilevel switching (ten levels) and tunable far-field beam shaping. Our work presents zero-static power transmissive phase-only SLMs, enabled by electrically controlled low-loss PCMs and individual meta-molecule addressable metasurfaces.
- 19 April 2024
- Published by American Chemical Society (ACS) in ACS Nano
- Vol. 18 (17) , 11245-11256
Nonvolatile Phase-Only Transmissive Spatial Light Modulator with Electrical Addressability of Individual Pixels
Active metasurfaces with tunable subwavelength-scale nanoscatterers are promising platforms for high-performance spatial light modulators (SLMs). Among the tuning methods, phase-change materials (PCMs) are attractive because of their nonvolatile, threshold-driven, and drastic optical modulation, rendering zero-static power, crosstalk immunity, and compact pixels. However, current electrically controlled PCM-based metasurfaces are limited to global amplitude modulation, which is insufficient for SLMs. Here, an individual-pixel addressable, transmissive metasurface is experimentally demonstrated using the low-loss PCM Sb2Se3 and doped silicon nanowire heaters. The nanowires simultaneously form a diatomic metasurface, supporting a high-quality-factor (∼406) quasi-bound-state-in-the-continuum mode. A global phase-only modulation of ∼0.25π (∼0.2π) in simulation (experiment) is achieved, showing ten times enhancement. A 2π phase shift is further obtained using a guided-mode resonance with enhanced light-Sb2Se3 interaction. Finally, individual-pixel addressability and SLM functionality are demonstrated through deterministic multilevel switching (ten levels) and tunable far-field beam shaping. Our work presents zero-static power transmissive phase-only SLMs, enabled by electrically controlled low-loss PCMs and individual meta-molecule addressable metasurfaces.
- 30 March 2024
- Published by Wiley in Advanced Materials Technologies
- Vol. 9 (10)
Electrohydrodynamic Printing‐Based Heterointegration of Quantum Dots on Suspended Nanophotonic Cavities
Nanophotonic structures are a foundation for the growing field of light‐based quantum networks and devices enabled by their ability to couple with and manipulate photons. Colloidal quantum dots (QDs) are uniquely suited to complement this range of devices due to their solution‐processability, broad tuneability, and near‐unity photoluminescence quantum yields in some cases. To bridge the gap between them, electrohydrodynamic inkjet (EHDIJ) printing serves as a highly precise and scalable nanomanufacturing method for deterministic positioning and deposition of attoliter‐scale QD droplets. This includes heterointegration in devices that are challenging to create by conventional subtractive semiconductor processing, such as QDs emitters coupled to substrate‐decoupled nanoscale resonant structures. In this work, the first successful application of EHDIJ printing for the integration of these colloidal QDs into suspended nanophotonic cavities is demonstrated, achieving selective single‐cavity deposition for cavity pairs as close as 100 nm apart. These results motivate the development of future suspended hetero‐integrated devices that utilize EHDIJ printing as a sustainable, additive, and scalable method for quantum photonics nanomanufacturing.
- 30 March 2024
- Published by Wiley in Advanced Materials Technologies
- Vol. 9 (10)
Electrohydrodynamic Printing‐Based Heterointegration of Quantum Dots on Suspended Nanophotonic Cavities
Nanophotonic structures are a foundation for the growing field of light‐based quantum networks and devices enabled by their ability to couple with and manipulate photons. Colloidal quantum dots (QDs) are uniquely suited to complement this range of devices due to their solution‐processability, broad tuneability, and near‐unity photoluminescence quantum yields in some cases. To bridge the gap between them, electrohydrodynamic inkjet (EHDIJ) printing serves as a highly precise and scalable nanomanufacturing method for deterministic positioning and deposition of attoliter‐scale QD droplets. This includes heterointegration in devices that are challenging to create by conventional subtractive semiconductor processing, such as QDs emitters coupled to substrate‐decoupled nanoscale resonant structures. In this work, the first successful application of EHDIJ printing for the integration of these colloidal QDs into suspended nanophotonic cavities is demonstrated, achieving selective single‐cavity deposition for cavity pairs as close as 100 nm apart. These results motivate the development of future suspended hetero‐integrated devices that utilize EHDIJ printing as a sustainable, additive, and scalable method for quantum photonics nanomanufacturing.
- 8 August 2023
- Published by American Chemical Society (ACS) in ACS Photonics
- Vol. 10 (9) , 3242-3247
Cryo-Compatible In Situ Strain Tuning of 2D Material-Integrated Nanocavity
- 8 August 2023
- Published by American Chemical Society (ACS) in ACS Photonics
- Vol. 10 (9) , 3242-3247
Cryo-Compatible In Situ Strain Tuning of 2D Material-Integrated Nanocavity
- Open Access
- 20 June 2023
- Published by American Chemical Society (ACS) in ACS Photonics
- Vol. 10 (8) , 2456-2460
Visible Wavelength Flatband in a Gallium Phosphide Metasurface
- 20 June 2023
- Published by American Chemical Society (ACS) in ACS Photonics
- Vol. 10 (8) , 2456-2460
Open AccessVisible Wavelength Flatband in a Gallium Phosphide Metasurface