ADAngela C. P. Duncke

Angela C. P. Duncke

*This is an algorithmically generated author record based on publicly available information.

Angela C. P. Duncke has a total of 14 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Coupled effects of sulfonated PAM concentration and degradation on separation kinetics of oil/water emulsions: interplay of flocculation, viscosity, and homogenization

    by Angela C.P. Duncke, Camila N.R. Amaral, Mônica Netto, Gabriel G. de Barros, Paulo R. de Souza Mendes, Aurora Pérez-Gramatges


  • Open Access

    Impact of Residual Zwitterionic Surfactants on Topside Water–Oil Separation of Pre-Salt Light Crude Oil Emulsions

    by Bruno G. Alvarenga, Angela C. P. Duncke, Aurora Pérez-Gramatges, Ana M. Percebom

    Zwitterionic surfactants have been used as foaming agents in Enhanced Oil Recovery due to their foamability, tolerance to reservoir conditions, low toxicity, and low adsorption on reservoir rocks. However, in the case of back-production, the impact of zwitterionic surfactants on water-in-crude oil (W/O) emulsions and produced water remains unclear, representing a knowledge gap in the field. The present study evaluated the effect of three commercial zwitterionic surfactants, at concentrations ranging from 50 to 1000 ppm, on water-oil separation using a Brazilian Pre-Salt crude oil. Emulsion formation, separation kinetics, and water quality were assessed through bottle tests, droplet size microscopy, and oil-in-water content analysis. At the lowest concentration (50 ppm), these surfactants promoted coalescence and sedimentation of W/O emulsions faster than traditional nonionic and anionic surfactants. Separation kinetics increased as surfactant concentration increased up to 200 ppm, but concentrations above 500 ppm induced the formation of multiple emulsions (W/O/W). After 72 h, these emulsions separated, and the aqueous phase still contained residual oil droplets, indicating potential challenges associated with the disposal or reuse of produced water. Surfactant hydrophobicity, reduction in interfacial tension, and critical micelle concentration were critical properties influencing the observed effects. The surfactant with higher hydrophobicity induced a more significant and rapid reduction in interfacial tension, resulting in faster W/O separation at low concentrations but compromising water quality at high concentrations. These results indicate that careful selection and monitoring of surfactants during EOR operations can optimize oil recovery efficiency while minimizing operational and environmental risks upstream.


  • Impact of hydrolysis on the quantification of sulfonated acrylamide copolymers by size exclusion chromatography with UV detection

    by Cecília C. R. Gonçalves, Angela C. P. Duncke, Luis Maqueira, Eduardo J. Creatto, Jones Limberger, Aurora Pérez‐Gramatges

    Size exclusion chromatography with UV detection (SEC‐UV) is a precise method for quantifying polyacrylamides in water. However, its accuracy can be compromised in complex matrices due to chemical degradation of the polymer. This study focuses on the impact of hydrolysis on quantifying sulfonated polyacrylamide copolymers (PAM‐AMPS) via SEC‐UV, analyzing key influencing factors. Using controlled hydrolysis, hydrolyzed copolymer (HPAM‐AMPS) standards with varying hydrolysis degree (HD) (HD = 7%–33%) were prepared without significant changes in polymer chain size. SEC‐UV analysis revealed that quantification accuracy is highly dependent on hydrolysis extent. Errors are minimal for HD up to 10%, but significantly higher for HDs of 22%–33%. Furthermore, this effect is modulated by polymer concentration. Our findings indicate that there are two compensating factors for the decrease in molar absorptivity due to amide‐to‐carboxylate substitution: the sulfonate group acting as an additional chromophore, and a redshift in absorption spectra due to hydrogen bonding at higher concentrations. This interplay between HD and concentration in this type of sulfonated polyacrylamide can help reduce quantification errors in complex aqueous samples prone to chemical degradation, like those found in environmental and subsurface applications.


  • Effect of kerosene aromaticity as a solvent on bulk and interfacial properties of Brazilian heavy crude oil with high asphaltene content

    by Lina M. Daza‐Barranco, Angela C. P. Duncke, Paulo R. de Souza Mendes, José G. Alvarado, Aurora Pérez‐Gramatges

    This study investigated the effect of solvent aromaticity on asphaltene stability and interfacial behaviour using typical diluted heavy oils, which better represent the chemical diversity of petroleum components than previous studies that used simple solvent mixtures with low asphaltene concentrations. A Brazilian crude with high viscosity and asphaltene content was diluted with two kerosenes, one containing only saturated compounds (KeS), and the other a saturates/aromatics mixture (KeSA) to maintain total aromaticity in the oil mixture upon dilution. Viscosity, asphaltene stability, interfacial tension, and elasticity of the oil mixtures were measured, and correlated with emulsion stability, regarding the differences in solvent aromaticity and aromatics/saturates ratio. The results showed that the different kerosene compositions affected bulk viscosity and asphaltene flocculation, but had a lesser effect on oil/brine interfacial tension due to the high asphaltene content in the diluted oil. The elastic modulus decreased at higher dilutions with KeS, while it remained consistent for KeSA mixtures, which supported the differences obtained in emulsion stability, at solvent concentrations within the optimal aromaticity ratio reported for simple solvent mixtures. Interfacial segregation of the aromatics in KeSA was also observed, which has not been reported in previous studies using complex solvents. These findings suggest that the trends reported with model oils, such as heptol with added asphaltenes, can also be applied to more realistic complex oil mixtures with higher asphaltene concentrations. Nevertheless, it was suggested that maintaining the aromatic content may not be enough to prevent asphaltene flocculation upon dilution, due to the concurrent increase in saturates.