Franco Zanini
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Franco Zanini has a total of 46 co-authors. Here are the top co-authors by number of shared publications:
- Adriano Filipponi
Dipartimento di Scienze Fisiche e Chimiche, Università degli Studi dell'Aquila, I-67100 L'Aquila, Italy
2 shared publications C. H. Pruett
Synchrotron Radiation Center, University of Wisconsin—Madison, 3731 Schneider Drive, Stoughton, Wisconsin 53589
2 shared publicationsD. J. Wallace
Synchrotron Radiation Center, University of Wisconsin—Madison, 3731 Schneider Drive, Stoughton, Wisconsin 53589
2 shared publicationsE. L. Brodsky
Synchrotron Radiation Center, University of Wisconsin-Madison, 3731 Schneider Drive, Stoughton, Wisconsin 53589
2 shared publicationsF. K. Perkins
Synchrotron Radiation Center, University of Wisconsin—Madison, 3731 Schneider Drive, Stoughton, Wisconsin 53589
2 shared publications- Lucia Mancini
Slovenian National Building and Civil Engineering Institute
2 shared publications
Latest Publications
- 1 January 2014
- Published by Springer Nature
- p. 4878-4884
Microcomputerized Tomography (MicroCT) in Archaeology
- 1 January 2014
- Published by Springer Nature
- p. 4878-4884
Microcomputerized Tomography (MicroCT) in Archaeology
- Open Access
- 20 August 2011
- Published by PAGEPress Publications in Journal of Entomological and Acarological Research
- Vol. 43 (2) , 149-155
Synchrotron radiation microtomography of musical instruments: a non-destructive monitoring technique for insect infestations
Synchrotron radiation microtomography of musical instruments: a non-destructive monitoring technique for insect infestations
- 20 August 2011
- Published by PAGEPress Publications in Journal of Entomological and Acarological Research
- Vol. 43 (2) , 149-155
Open AccessSynchrotron radiation microtomography of musical instruments: a non-destructive monitoring technique for insect infestations
Synchrotron radiation microtomography of musical instruments: a non-destructive monitoring technique for insect infestations
- 10 February 2011
- Published by SPIE-Intl Soc Optical Eng
- Vol. 7870
Imaging using synchrotron radiation for forensic science
Forensic science is already taking benefits from synchrotron radiation (SR) sources in trace evidence analysis. In this contribution we show a multi-technique approach to study fingerprints from the morphological and chemical point of view using SR based techniques such as Fourier transform infrared microspectroscopy (FTIRMS), X-ray fluorescence (XRF), X-ray absorption structure (XAS), and phase contrast microradiography. Both uncontaminated and gunshot residue contaminated human fingerprints were deposited on lightly doped silicon wafers and on poly-ethylene-terephthalate foils. For the uncontaminated fingerprints an univariate approach of functional groups mapping to model FT-IRMS data was used to get the morphology and the organic compounds map. For the gunshot residue contaminated fingerprints, after a preliminary elemental analysis using XRF, microradiography just below and above the absorption edge of the elements of interest has been used to map the contaminants within the fingerprint. Finally, XAS allowed us to determine the chemical state of the different elements. The next step will be fusing the above information in order to produce an exhaustive and easily understandable evidence.
- 10 February 2011
- Published by SPIE-Intl Soc Optical Eng
- Vol. 7870
Imaging using synchrotron radiation for forensic science
Forensic science is already taking benefits from synchrotron radiation (SR) sources in trace evidence analysis. In this contribution we show a multi-technique approach to study fingerprints from the morphological and chemical point of view using SR based techniques such as Fourier transform infrared microspectroscopy (FTIRMS), X-ray fluorescence (XRF), X-ray absorption structure (XAS), and phase contrast microradiography. Both uncontaminated and gunshot residue contaminated human fingerprints were deposited on lightly doped silicon wafers and on poly-ethylene-terephthalate foils. For the uncontaminated fingerprints an univariate approach of functional groups mapping to model FT-IRMS data was used to get the morphology and the organic compounds map. For the gunshot residue contaminated fingerprints, after a preliminary elemental analysis using XRF, microradiography just below and above the absorption edge of the elements of interest has been used to map the contaminants within the fingerprint. Finally, XAS allowed us to determine the chemical state of the different elements. The next step will be fusing the above information in order to produce an exhaustive and easily understandable evidence.
- 1 February 1995
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 66 (2) , 1681-1683
Comparison of numerical and experimental simulation of a beryllium window under intense heat load
Synchrotron radiation emitted by insertion devices provides a much higher power density than that from conventional bending magnets. In this case thermal stress induced by absorbed radiation produces intense mechanical deformations which can break beryllium windows in very short times. Numerical and experimental results show that nonlinear analysis in the plastic region of beryllium is needed to predict failure of windows under intense heat load.
- 1 February 1995
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 66 (2) , 1681-1683
Comparison of numerical and experimental simulation of a beryllium window under intense heat load
Synchrotron radiation emitted by insertion devices provides a much higher power density than that from conventional bending magnets. In this case thermal stress induced by absorbed radiation produces intense mechanical deformations which can break beryllium windows in very short times. Numerical and experimental results show that nonlinear analysis in the plastic region of beryllium is needed to predict failure of windows under intense heat load.
- 1 July 1989
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 60 (7) , 1913-1916
New Synchrotron Radiation Center beamlines at Aladdin
In the past year, the Synchrotron Radiation Center (SRC) staff has installed five new beamlines at SRC. Three of these beamlines are ‘‘public’’ beamlines operated by SRC for experiments selected from peer‐reviewed proposals. Fifty to seventy‐five percent of the experimental time on the other two beamlines is managed by the SRC as a consequence of the SRC being a partner in participating research teams (PRTs). These new beamlines bring the number of VUV and soft x‐ray research beamlines installed on Aladdin to 17 as of August 1988. Including two storage ring optical diagnostic ports, there will be 20 ports in use on Aladdin by the end of 1988.
- 1 July 1989
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 60 (7) , 1913-1916
New Synchrotron Radiation Center beamlines at Aladdin
In the past year, the Synchrotron Radiation Center (SRC) staff has installed five new beamlines at SRC. Three of these beamlines are ‘‘public’’ beamlines operated by SRC for experiments selected from peer‐reviewed proposals. Fifty to seventy‐five percent of the experimental time on the other two beamlines is managed by the SRC as a consequence of the SRC being a partner in participating research teams (PRTs). These new beamlines bring the number of VUV and soft x‐ray research beamlines installed on Aladdin to 17 as of August 1988. Including two storage ring optical diagnostic ports, there will be 20 ports in use on Aladdin by the end of 1988.
- 1 July 1989
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 60 (7) , 2116-2119
High-resolution Czerny–Turner monochromator for application to undulators
- 1 July 1989
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 60 (7) , 2116-2119
High-resolution Czerny–Turner monochromator for application to undulators
- 1 July 1989
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 60 (7) , 2093-2096
6-m TGM implementation at the Wisconsin Synchrotron Radiation Center (SRC)
We recently commissioned the SRC/Vanderbilt University 6‐m toroidal grating monochromator beamline. The problems with mirror heating, signal normalization, monochromator control, and scattered light reduction have led to several innovations on this line, making for a better user interface and adding to the stability and reliability of the final image. We discuss these innovations, and how they affect the user. They include a built‐in laser alignment system, a sapphire windowed gate valve, entrance mirror temperature stabilization, computer automation and control, a beam‐chopper, and the capability of real‐time monitoring of the photon flux during the experiment. We have used noble gas resonance lines to carefully characterize the wavelength resolution of the beamline as a function of energy over a range of beamline parameters. The results demonstrate that by limiting the horizontal width of the image at the slits, and by masking outer portions of the gratings, the flux/bandwidth ratio can be improved at the points where the exit slit location does not coincide with the Rowland circle. These same resonance lines, in conjunction with accurate measurements of the grating rotation angle as a function of scan‐drive displacement, are used to correct for imperfections in the surface of the drive‐flat and thus obtain a precise and accurate determination of wavelength versus scan‐drive displacement.
- 1 July 1989
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 60 (7) , 2093-2096
6-m TGM implementation at the Wisconsin Synchrotron Radiation Center (SRC)
We recently commissioned the SRC/Vanderbilt University 6‐m toroidal grating monochromator beamline. The problems with mirror heating, signal normalization, monochromator control, and scattered light reduction have led to several innovations on this line, making for a better user interface and adding to the stability and reliability of the final image. We discuss these innovations, and how they affect the user. They include a built‐in laser alignment system, a sapphire windowed gate valve, entrance mirror temperature stabilization, computer automation and control, a beam‐chopper, and the capability of real‐time monitoring of the photon flux during the experiment. We have used noble gas resonance lines to carefully characterize the wavelength resolution of the beamline as a function of energy over a range of beamline parameters. The results demonstrate that by limiting the horizontal width of the image at the slits, and by masking outer portions of the gratings, the flux/bandwidth ratio can be improved at the points where the exit slit location does not coincide with the Rowland circle. These same resonance lines, in conjunction with accurate measurements of the grating rotation angle as a function of scan‐drive displacement, are used to correct for imperfections in the surface of the drive‐flat and thus obtain a precise and accurate determination of wavelength versus scan‐drive displacement.