Bappa Roy

Maximum Power Point Tracking (MPPT) is essential for maximizing the efficiency of solar photovoltaic (PV) systems. While numerous MPPT methods exist, practical implementations often lean towards conventional techniques due to their simplicity. However, these traditional methods can struggle with rapid fluctuations in solar irradiance and temperature. This paper introduces a novel deep learning-based MPPT algorithm that leverages a Long Short-Term Memory (LSTM) deep neural network (DNN) to effectively track maximum power from solar PV panels, utilizing real-world data. The simulations of three algorithms—Perturb and Observe (P&O), Artificial Neural Network (ANN), and the proposed LSTM-based MPPT—were conducted using MATLAB (2021b) and RT_LAB (24.3.3) with an OPAL-RT simulator for real-time analysis. The data used for this study were sourced from NASA/POWER’s Native Resolution Daily Data of solar irradiation and temperature specific to Imphal, Manipur, India. The obtained results demonstrate that the LSTM-based MPPT system achieves a superior power tracking accuracy under changing solar conditions, producing an average output of 74 W. In comparison, the ANN and P&O methods yield average outputs of 57 W and 62 W, respectively. This significant improvement, i.e., 20–30%, underscores the effectiveness of the LSTM technique in enhancing the power output of solar PV systems. By incorporating real-world data, valuable insights into solar power generation specific to the selected location are provided. Furthermore, the outputs of the model were verified through real-time simulations using the OPAL-RT simulator OP4510, showcasing the practical applicability of this approach in real-world scenarios.

In this article, a maiden attempt have been taken for the online detection of faults, classification of faults, and identification of the fault locations of a grid-connected Micro-grid (MG) system. A deep learning algorithm-based Long Short Term Memory (LSTM) network is proposed, for the first time, for the online detection of faults and their classifications of the considered MG system to overcome the issues that persist in the existing algorithms. Also, a combination of an LSTM network and feed-forward neural network (FFNN) with a back-propagation algorithm (BPA) is proposed to identify the exact locations of the faults since the identification of fault locations is more challenging than fault categorizations. To select a suitable deep learning network with multiple hidden layers for achieving the aforesaid objectives, a rigorous analysis has been done. To study the accuracy of the proposed techniques, different types of faults with different parameters are considered in this paper. An extensive simulation has been done in MATLAB/Simulink platform to study the performance of the system with the proposed techniques. To validate the effectiveness of the proposed techniques, the entire system is implemented in the real-time platform using the OPAL-RT digital simulator. Comparison has also been done for the results obtained using ANN and proposed techniques. The results show that the proposed techniques based on the deep learning network effectively detect, classify, and identify the location of different faults of an MG system with acceptable performances.

In this paper, the performance of a Unified Power Quality Conditioner (UPQC) is studied under nonlinear and unbalanced linear loads and also during symmetrical and asymmetrical faults. Two control schemes are used to regulate the UPQC. One of the control schemes are used for injecting/absorbing the requited amount of voltage into/from the line to maintain rated voltage during voltage sag/swell conditions whereas other is used for injecting current into the line to reduce harmonics during non-linear loads. Simulation is done using MATLAB/Simulink software and simulink results are analyzed.