Christopher Palmstrom
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Christopher Palmstrom has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
A. K. Petford-Long
1 shared publicationB. D. Schultz
Department of Chemical Engineering and Materials Science, University of Minnesota, Minneapolis, Minnesota 55455, USA
1 shared publicationC. Adelmann
1 shared publicationJ. -P. Barnes
1 shared publicationJ. Q. Xie
1 shared publicationJ. Strand
1 shared publication
Latest Publications
- 1 May 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE) in 2007 IEEE 19th International Conference on Indium Phosphide & Related Materials
- No. 10928669,p. 497
Developments in Spintonic Materials
- 1 May 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE) in 2007 IEEE 19th International Conference on Indium Phosphide & Related Materials
- No. 10928669,p. 497
Developments in Spintonic Materials
- 28 June 2006
- Published by American Physical Society (APS) in Physical Review B
- Vol. 73 (24) , 241407
Embedded assembly mechanism of stable metal nanocrystals on semiconductor surfaces
The growth of ErAs on GaAs(001) surfaces occurs by an embedded growth mode encompassing three steps; (i) island nucleation within the substrate surface, (ii) lateral growth of embedded islands, and (iii) growth of the islands into a continuous film. This growth mode cannot be modeled in terms of epitaxial strain or surface, bulk, and interfacial energy differences, which have been used to explain most conventional growth modes. Instead the surface morphologies resulting from this growth mode are shown to depend on structural differences, thermodynamics, and diffusion.
- 28 June 2006
- Published by American Physical Society (APS) in Physical Review B
- Vol. 73 (24) , 241407
Embedded assembly mechanism of stable metal nanocrystals on semiconductor surfaces
The growth of ErAs on GaAs(001) surfaces occurs by an embedded growth mode encompassing three steps; (i) island nucleation within the substrate surface, (ii) lateral growth of embedded islands, and (iii) growth of the islands into a continuous film. This growth mode cannot be modeled in terms of epitaxial strain or surface, bulk, and interfacial energy differences, which have been used to explain most conventional growth modes. Instead the surface morphologies resulting from this growth mode are shown to depend on structural differences, thermodynamics, and diffusion.
- Open Access
Spin injection from the Heusler alloy Co_2MnGe into Al_0.1Ga_0.9As/GaAs heterostructures
Electrical spin injection from the Heusler alloy Co_2MnGe into a p-i-n Al_0.1Ga_0.9As/GaAs light emitting diode is demonstrated. A maximum steady-state spin polarization of approximately 13% at 2 K is measured in two types of heterostructures. The injected spin polarization at 2 K is calculated to be 27% based on a calibration of the spin detector using Hanle effect measurements. Although the dependence on electrical bias conditions is qualitatively similar to Fe-based spin injection devices of the same design, the spin polarization injected from Co_2MnGe decays more rapidly with increasing temperature.
Open AccessSpin injection from the Heusler alloy Co_2MnGe into Al_0.1Ga_0.9As/GaAs heterostructures
Electrical spin injection from the Heusler alloy Co_2MnGe into a p-i-n Al_0.1Ga_0.9As/GaAs light emitting diode is demonstrated. A maximum steady-state spin polarization of approximately 13% at 2 K is measured in two types of heterostructures. The injected spin polarization at 2 K is calculated to be 27% based on a calibration of the spin detector using Hanle effect measurements. Although the dependence on electrical bias conditions is qualitatively similar to Fe-based spin injection devices of the same design, the spin polarization injected from Co_2MnGe decays more rapidly with increasing temperature.