Deshabrato Mukherjee
Deshabrato Mukherjee has a total of 36 co-authors. Here are the top co-authors by number of shared publications:
- Peter Petrik
Research Institute for Technical Physics and Materials Science
3 shared publications A Lengyel
Wigner Research Centre for Physics, Budapest, 1121, Konkoly-Thege Miklós út 29-33, Hungary
1 shared publicationA Németh
Wigner Research Centre for Physics, Budapest, 1121, Konkoly-Thege Miklós út 29-33, Hungary
1 shared publication- Alekszej Romanenko1 shared publication
- Andreas Popp
Leibniz-Institut für Kristallzüchtung (IKZ) , Max-Born-Str. 2, Berlin 12489
1 shared publication András Deák
1 shared publication
Latest Publications
- Open Access
- 14 November 2024
- Published by Elsevier in Sensors and Actuators B: Chemical
- Vol. 425
Optimized sensing on gold nanoparticles created by graded-layer magnetron sputtering and annealing
- 14 November 2024
- Published by Elsevier in Sensors and Actuators B: Chemical
- Vol. 425
Open AccessOptimized sensing on gold nanoparticles created by graded-layer magnetron sputtering and annealing
- Open Access
- 10 January 2024
- Published by Elsevier in Applied Surface Science
- Vol. 652
In-situ spectral reflectance investigation of hetero-epitaxially grown β-Ga2O3 thin films on c-plane Al2O3 via MOVPE process
- 10 January 2024
- Published by Elsevier in Applied Surface Science
- Vol. 652
Open AccessIn-situ spectral reflectance investigation of hetero-epitaxially grown β-Ga2O3 thin films on c-plane Al2O3 via MOVPE process
- Open Access
- 1 July 2023
- Published by IOP Publishing in Materials Research Express
- Vol. 10 (7) , 076101
Laser irradiation effects in FeRh thin film
The effect of laser irradiation in the energy range from 20 mW to 200 mW was investigated in 109 nm thick Fe51Rh49 film deposited on an MgO (100) substrate. The initial, A1 structure with fully paramagnetic magnetic ordering was achieved after irradiating the samples with 120 keV Ne+ ions with a fluence of 1 × 1016 ion cm−2, as it was confirmed by conversion-electron Mössbauer spectroscopy. At higher powers physical damage of the layer was observed, while in the lowest power case, magnetic force microscopy revealed a well-defined magnetic structure reflecting the laser irradiation pattern. The presented results have the potential to be employed for laser ablation or allows the fabrication of arbitrary ferromagnetic pattern within a homogeneous paramagnetic FeRh thin films.
- 1 July 2023
- Published by IOP Publishing in Materials Research Express
- Vol. 10 (7) , 076101
Open AccessLaser irradiation effects in FeRh thin film
The effect of laser irradiation in the energy range from 20 mW to 200 mW was investigated in 109 nm thick Fe51Rh49 film deposited on an MgO (100) substrate. The initial, A1 structure with fully paramagnetic magnetic ordering was achieved after irradiating the samples with 120 keV Ne+ ions with a fluence of 1 × 1016 ion cm−2, as it was confirmed by conversion-electron Mössbauer spectroscopy. At higher powers physical damage of the layer was observed, while in the lowest power case, magnetic force microscopy revealed a well-defined magnetic structure reflecting the laser irradiation pattern. The presented results have the potential to be employed for laser ablation or allows the fabrication of arbitrary ferromagnetic pattern within a homogeneous paramagnetic FeRh thin films.
- 18 March 2023
- Published by SPIE-Intl Soc Optical Eng
- Vol. 12395, 24-38
Ellipsometry monitoring of sensor processes based on gold nanoparticle bonded proteins
The aim of our work is to develop a heavy metal detection sensor that can be used in the field to easily and accurately test water samples at the range of the strict concentration levels set by international standards. The sensor is based on a gold thin-film electrode on a silicon substrate and a genetically modified bacterial flagellin protein deposited onto the gold thin-film electrode. To ensure that the surface is adequately covered, and the protein is attached to the electrode, additional gold nanoparticles were deposited to the surface. Changes on the sensor surface were investigated by in-situ ellipsometry and cyclic voltammetry. The determination of the exact surface morphology, as well as the validation of the ellipsometric measurements were done by using scanning electron microscope.
- 18 March 2023
- Published by SPIE-Intl Soc Optical Eng
- Vol. 12395, 24-38
Ellipsometry monitoring of sensor processes based on gold nanoparticle bonded proteins
The aim of our work is to develop a heavy metal detection sensor that can be used in the field to easily and accurately test water samples at the range of the strict concentration levels set by international standards. The sensor is based on a gold thin-film electrode on a silicon substrate and a genetically modified bacterial flagellin protein deposited onto the gold thin-film electrode. To ensure that the surface is adequately covered, and the protein is attached to the electrode, additional gold nanoparticles were deposited to the surface. Changes on the sensor surface were investigated by in-situ ellipsometry and cyclic voltammetry. The determination of the exact surface morphology, as well as the validation of the ellipsometric measurements were done by using scanning electron microscope.