Canghai Liu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Canghai Liu has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Ato Kitagawa
Tokyo Tech
2 shared publications - Hideyuki Tsukagoshi
Tokyo Institute of Technology, Tokyo, Japan
2 shared publications - Haifan Wu
Wichita State University
1 shared publication - Monda Ido
Department of Mechanical and Control Engineering, Tokyo Institute of Technology, Tokyo, 152-8550, Japan
1 shared publication - Pingdong Wu
School of Mechanical and Electronic Engineering, Tianjin Polytechnic University, Box 300160, City, Tianjin
1 shared publication - Zhen Xiu
Department of Mechanical and Control Engineering, Tokyo Institute of Technology, Tokyo, 152-8550, Japan
1 shared publication
Latest Publications
- 1 October 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE) in 2007 IEEE International Conference on Control Applications
- No. 10851992,p. 1291-1296
Development of a Novel Pneumatic Power Assisted Lower Limb for Outdoor Walking by the Use of a Portable Pneumatic Power Source
In our previous research, a novel portable pneumatic power source, called a dry ice power cell, was proposed. In this paper, a novel pneumatic power assisted lower limb is developed by the use of the power of dry ice power cell. For those people whose muscle and balance remains in good condition but who have joint pain (hip or knee joint) in their leg and are unable to walk outdoors for long, the developed device can partially lift the patient in a comfortable way by pneumatic cylinder when the affected leg touches the floor, reducing the loads to which it is subject as well as the pain joint forces, thus relieving pain during walking. The developed device has the characteristics of a simple structure, low weight, easy to put on and take off and with sufficient capability to bear about 40% of the body weight during about 1000 steps of outdoor walking, using the power of dry ice power cell. The developed device can assist with outdoor walking not only over flat ground but also sloped and stair areas. In this paper, the structure and function and experiments involving the developed pneumatic power assisted lower limb are described in detail.
- 1 October 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE) in 2007 IEEE International Conference on Control Applications
- No. 10851992,p. 1291-1296
Development of a Novel Pneumatic Power Assisted Lower Limb for Outdoor Walking by the Use of a Portable Pneumatic Power Source
In our previous research, a novel portable pneumatic power source, called a dry ice power cell, was proposed. In this paper, a novel pneumatic power assisted lower limb is developed by the use of the power of dry ice power cell. For those people whose muscle and balance remains in good condition but who have joint pain (hip or knee joint) in their leg and are unable to walk outdoors for long, the developed device can partially lift the patient in a comfortable way by pneumatic cylinder when the affected leg touches the floor, reducing the loads to which it is subject as well as the pain joint forces, thus relieving pain during walking. The developed device has the characteristics of a simple structure, low weight, easy to put on and take off and with sufficient capability to bear about 40% of the body weight during about 1000 steps of outdoor walking, using the power of dry ice power cell. The developed device can assist with outdoor walking not only over flat ground but also sloped and stair areas. In this paper, the structure and function and experiments involving the developed pneumatic power assisted lower limb are described in detail.
- 1 October 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 5208-5213
Internet-based Tele-rehabilitatioon System --Bilateral Tele-control with Variable Time Delay
This paper discussed an Internet-based telerehabilitation sharing system, which aims to achieve the situation where multiple stay home patients in different places can share rehabilitation instruction of one physical therapist at the same time. After the introduction, three main problems are described in this paper. Firstly the stability problem of the master-slave system with variable time delay which is the biggest problem of the tele-control system is focused on, the time delay and its effect to the system is described and the control architecture is proposed; then the operation method of the whole system with single-master and multi-slave is described; After that, the wound-tube actuator and tail-wrist which will be used as slave in the tele-rehabilitation system is introduced
- 1 October 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 5208-5213
Internet-based Tele-rehabilitatioon System --Bilateral Tele-control with Variable Time Delay
This paper discussed an Internet-based telerehabilitation sharing system, which aims to achieve the situation where multiple stay home patients in different places can share rehabilitation instruction of one physical therapist at the same time. After the introduction, three main problems are described in this paper. Firstly the stability problem of the master-slave system with variable time delay which is the biggest problem of the tele-control system is focused on, the time delay and its effect to the system is described and the control architecture is proposed; then the operation method of the whole system with single-master and multi-slave is described; After that, the wound-tube actuator and tail-wrist which will be used as slave in the tele-rehabilitation system is introduced