Antonio Dell'Aquila
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Antonio Dell'Aquila has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
- Marco Liserre
Dept. of Electrotecnichal and Electronic Eng., 70125-Bari, Italy
4 shared publications - Alberto Pigazo
Department of Computer Science and Electronics, Universidad de Cantabria, Santander, Spain
2 shared publications - Rosa Anna Mastromauro
Department of Information Engineering, University of Florence, Florence, Italy
2 shared publications - Victor M. Moreno
Dept. of Electronics and Computers, University of Cantabria, Santander, Spain
2 shared publications - A. Lecci
Dept. of Electrotechnical and Electronic Eng., Polytechnic of Bari, Via. E. Orabona 4, 70125-Bari, Italy
1 shared publication - Carlo Cecati
Department of Information Engineering, Computer Science and Mathematics, University of L’Aquila, L’Aquila, Italy
1 shared publication
Latest Publications
- 1 June 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 21635137,p. 2409-2413
Wavelet-Based Islanding Detection Algorithm for Single-Phase Photovoltaic (PV) Distributed Generation Systems
Distributed Generation (DG) systems based on inverters connected to low-voltage electrical grids, such as low power PV systems in buildings, require reliable islanding detection algorithms in order to determine the electrical grid status and operate the inverter properly. Passive and active islanding detection methods are local detection techniques which have been presented and analyzed in literature. The first approach is based on current and voltage measurements at the inverter side of the point of common coupling (PCC) between the electrical grid, the local load and the DG system. Active methods introduce a disturbance at the PCC in order to reveal the islanding condition. This paper proposes a new hybrid detection algorithm based on monitoring of high-frequency components of the DG system output power due to PWM, the output LCL filter and the employed current controller. Wavelet analysis is applied to obtain time localization of the islanding operation mode. Simulation results show the performance of the proposed detection algorithm.
- 1 June 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 21635137,p. 2409-2413
Wavelet-Based Islanding Detection Algorithm for Single-Phase Photovoltaic (PV) Distributed Generation Systems
Distributed Generation (DG) systems based on inverters connected to low-voltage electrical grids, such as low power PV systems in buildings, require reliable islanding detection algorithms in order to determine the electrical grid status and operate the inverter properly. Passive and active islanding detection methods are local detection techniques which have been presented and analyzed in literature. The first approach is based on current and voltage measurements at the inverter side of the point of common coupling (PCC) between the electrical grid, the local load and the DG system. Active methods introduce a disturbance at the PCC in order to reveal the islanding condition. This paper proposes a new hybrid detection algorithm based on monitoring of high-frequency components of the DG system output power due to PWM, the output LCL filter and the employed current controller. Wavelet analysis is applied to obtain time localization of the islanding operation mode. Simulation results show the performance of the proposed detection algorithm.
- 1 January 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1396-1401
Frequency Domain Analysis of Inductor Saturation in Current Controlled Grid Converters
In this paper the effects of non-linear inductance on the performance of current controllers designed to track periodic signals and/or to compensate periodic disturbances are investigated with a frequency-domain model. When the inductance has a non-linear behavior a distorted current waveform is produced; if the saturation is symmetric, the current spectrum contains only odd harmonics. A current-dependent model of the non-linear inductance has been developed using the Volterra series expansion. The model allows proving formally how harmonic compensation provided by resonant and repetitive controllers can also mitigate the effects of the inductance saturation. This result is the main contribution of the paper and it is also substantiated with experimental evidence. It has been proven that the resonant and repetitive controllers are able to reduce harmonic distortion introduced by non-linearities. Moreover the repetitive controller is able to comply with the harmonic limits reported in IEEE 1547 and IEC 61727 even in very hard saturation conditions.
- 1 January 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1396-1401
Frequency Domain Analysis of Inductor Saturation in Current Controlled Grid Converters
In this paper the effects of non-linear inductance on the performance of current controllers designed to track periodic signals and/or to compensate periodic disturbances are investigated with a frequency-domain model. When the inductance has a non-linear behavior a distorted current waveform is produced; if the saturation is symmetric, the current spectrum contains only odd harmonics. A current-dependent model of the non-linear inductance has been developed using the Volterra series expansion. The model allows proving formally how harmonic compensation provided by resonant and repetitive controllers can also mitigate the effects of the inductance saturation. This result is the main contribution of the paper and it is also substantiated with experimental evidence. It has been proven that the resonant and repetitive controllers are able to reduce harmonic distortion introduced by non-linearities. Moreover the repetitive controller is able to comply with the harmonic limits reported in IEEE 1547 and IEC 61727 even in very hard saturation conditions.
- 1 November 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IECON 2006 - 32nd Annual Conference on IEEE Industrial Electronics
- No. 1553572X,p. 1639-1642
Multilevel Phase-Shifting Carrier PWM Technique in case of Non-Equal dc-Link Voltages
This paper analyzes the phase-shifting carrier PWM techniques in case of multilevel cascaded H-bridges with non-equal DC-link voltages. In the past it has been demonstrated that these techniques succeed in cancelling the sideband harmonics in the produced multilevel voltage only if the DC-link voltages are equal. Two different approaches can be used to modulate the reference signal in multilevel converters when the DC-link voltages are different and in a non-integer ratio: the theory of symmetric polynomials and resultants, and the generalized hybrid modulation (GHM) technique, which extends the hybrid modulation technique to non-integer DC-link ratio. This paper extends the original PSC-PWM technique proposing a method to obtain the proper shifting angles in view of reducing the overall output voltage WTHD under every possible de-link voltages. The proposed new approach is compared, in simulation with the original phase-shifted cascaded multilevel technique
- 1 November 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IECON 2006 - 32nd Annual Conference on IEEE Industrial Electronics
- No. 1553572X,p. 1639-1642
Multilevel Phase-Shifting Carrier PWM Technique in case of Non-Equal dc-Link Voltages
This paper analyzes the phase-shifting carrier PWM techniques in case of multilevel cascaded H-bridges with non-equal DC-link voltages. In the past it has been demonstrated that these techniques succeed in cancelling the sideband harmonics in the produced multilevel voltage only if the DC-link voltages are equal. Two different approaches can be used to modulate the reference signal in multilevel converters when the DC-link voltages are different and in a non-integer ratio: the theory of symmetric polynomials and resultants, and the generalized hybrid modulation (GHM) technique, which extends the hybrid modulation technique to non-integer DC-link ratio. This paper extends the original PSC-PWM technique proposing a method to obtain the proper shifting angles in view of reducing the overall output voltage WTHD under every possible de-link voltages. The proposed new approach is compared, in simulation with the original phase-shifted cascaded multilevel technique
- 1 November 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 1553572X,p. 1394-1399
A Two-phase Induction Motor Back-to-back Drive
This paper investigates a two-phase induction motor drive with active front-end. The aim is to conjugate high efficiency (through active shaping the grid current), high performance (implementing vector control) and low cost (using a common six-transistors bridge). The main theoretical aspects of the two-phase induction motor drive are pointed out and the possibility to adopt more complex converter and control structures are investigated. Particularly, the paper proposes a double current controller, with the goal of torque ripple optimization. Numerical results demonstrate the effectiveness of the proposed controller
- 1 November 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 1553572X,p. 1394-1399
A Two-phase Induction Motor Back-to-back Drive
This paper investigates a two-phase induction motor drive with active front-end. The aim is to conjugate high efficiency (through active shaping the grid current), high performance (implementing vector control) and low cost (using a common six-transistors bridge). The main theoretical aspects of the two-phase induction motor drive are pointed out and the possibility to adopt more complex converter and control structures are investigated. Particularly, the paper proposes a double current controller, with the goal of torque ripple optimization. Numerical results demonstrate the effectiveness of the proposed controller
- 1 July 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 2 (21635137) , 1498-1503
Study of the effects of non-linear inductance on the performance of resonant and repetitive controllers
Resonant and repetitive controllers are well suited for single-phase photovoltaic systems due to the optimum tracking and harmonics rejection capability. In this paper the effects of non-linear inductance on the performance of current controllers based on the IMP are investigated. When the inductance is non-linear a distorted current waveform is produced; it contain only odd harmonics if the saturation is symmetric. A detailed time-varying model of non-linear inductor has been developed considering two different non-linearities: saturation for high currents and a light non-linearity which occurs in the first portion of the magnetization curve for very low currents. The robustness of the current controllers has been tested. Experimental results have been obtained with two different inductors of two main families: powdered metal core and ferrite core. It has been proven that the resonant and repetitive controllers are able to mitigate harmonic distortion introduced by the non-linearities and to ensure the IEEE 929 standard compliance
- 1 July 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 2 (21635137) , 1498-1503
Study of the effects of non-linear inductance on the performance of resonant and repetitive controllers
Resonant and repetitive controllers are well suited for single-phase photovoltaic systems due to the optimum tracking and harmonics rejection capability. In this paper the effects of non-linear inductance on the performance of current controllers based on the IMP are investigated. When the inductance is non-linear a distorted current waveform is produced; it contain only odd harmonics if the saturation is symmetric. A detailed time-varying model of non-linear inductor has been developed considering two different non-linearities: saturation for high currents and a light non-linearity which occurs in the first portion of the magnetization curve for very low currents. The robustness of the current controllers has been tested. Experimental results have been obtained with two different inductors of two main families: powdered metal core and ferrite core. It has been proven that the resonant and repetitive controllers are able to mitigate harmonic distortion introduced by the non-linearities and to ensure the IEEE 929 standard compliance