RGRajeev Gupta

Rajeev Gupta

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Rajeev Gupta has a total of 15 co-authors. Here are the top co-authors by number of shared publications:

  • Richa Sharma

    Department of Physics Dev Bhoomi Uttarakhand University Dehradun India

    2 shared publications
  • Ajay Singh Verma

    Division of Research & Innovation, School of Applied and Life Sciences, Uttaranchal University, Uttarakhand, Dehradun, 248007, Uttrakhand, India

    1 shared publication
  • Aniruddha Mondal

    Department of Physics National Institute of Technology Durgapur Durgapur West Bengal India

    1 shared publication
  • Bhanu Priya

    Department of Nanoscience & Materials, Central University of Jammu, Jammu, 181143, India

    1 shared publication
  • Divya Pratap Singh

    Department of Physics, School of Engineering, UPES, Dehradun, 248001, Uttrakhand, India

    1 shared publication
  • Fouran Singh

    Materials Science Group, Inter University Accelerator Centre, Aruna Asaf Ali Marg, New Delhi 110 067, India

    1 shared publication

Latest Publications

  • Open Access

    Influence of Nitrogen Ion Implantation on the Structural, Morphological and Optical Properties of Al‐Doped ZnO [AZO] Thin Films for High‐Performance Optoelectronic Applications

    by Richa Sharma, Fouran Singh, Jag Mohan Singh Rana, Tanuj Kumar, Ratnesh K. Pandey, Aniruddha Mondal, Pankaj Chamoli, Rajeev Gupta

    The work reports the near‐surface doping of N ions, and post implantation effects on the structural, morphological, optical, and electrical properties of Al‐doped ZnO [AZO] thin film deposited by the Radion Frequency (RF) magnetron sputtering method, investigated at room temperature. The Grazing Incidence X‐ray diffraction (GIXRD) studies revealed the structural modifications caused by the implanted ions. The field emission scanning electron microscopy (FE‐SEM) micrographs showed the morphological modifications in the AZO thin film due to implantation. The crystallinity of the thin film structure was preserved even after high ion implantation of 1 × 10 16 ions/cm 2 . Optical analysis revealed a noticeable decrease in average transmittance in the wavelength range of 350 to 500 nm. An increase in electrical resistivity value was witnessed as a post‐implantation effect.The Fourier Transform Infra Red (FTIR) spectroscopy was employed to study the ion implantation on the vibrational properties. The study shows that the ion implantation method can effectively be used to dope N ions into AZO thin films to tailor their various properties. Nitrogen‐doped AZO thin films, with reduced transmittance in the 350–500 nm range and mid‐gap states, exhibit enhanced ultraviolet (UV) sensitivity, making them ideal for optoelectronic applications.


  • Effects of 300 keV N+ Ion Irradiation on Radio-Frequency Sputtered Al-ZnO Thin Films for a Low Energy Regime

    by Richa Sharma, Himanshi Gupta, Fouran Singh, J. M. S. Rana, Navjot Hothi, Bhanu Priya, Tanuj Kumar, Divya Pratap Singh, Ajay Singh Verma, Rajeev Gupta

    The experimentally observed effects induced by ion irradiation in AZO thin films are discussed in limited articles. Here, in the present study, we report the results of ion irradiation by 300 keV Nitrogen ions. To study the structural, morphological, and optical properties of thin film, XRD, FE-SEM, and UV visible spectroscopy were used and it was confirmed by the structural investigation that the ion irradiation resulted in changes in different calculated structural parameters. Furthermore, different dopant concentrations are examined in relation to the effects of irradiation. The polar crystal growth orientation mechanism is initiated over nonpolar crystal growth orientation, as the 2%AZO thin films are presented to ion beam irradiation. The transition in the stress of thin film after N ion irradiation is also discussed. The phenomena responsible for the morphological changes is discussed. The observed morphological changes are correlated with structural changes. The change in the colour of the thin films after irradiation is explained. The other alterations in the thin films’ optical properties are also discussed. The systematics study of the irradiated thin films may be helpful for device fabrication.