Alexander Skabardonis
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Alexander Skabardonis has a total of 15 co-authors. Here are the top co-authors by number of shared publications:
- Eleni Vlahogianni
National Technical University of Athens
2 shared publications - Nikolas Geroliminis
Urban Transport Systems Laboratory (LUTS), Ecole Polytechnique Fédérale de Lausanne (EPFL), Lausanne, Switzerland
2 shared publications - Steven E. Shladover
University of California PATH Program
2 shared publications Charles L. Webber
Department of Physiology, Loyola University Chicago, Stritch School of Medicine, 2160 South First Avenue, Maywood, IL 60153, USA
1 shared publication- Eleni Christofa
Department of Civil and Environmental Engineering, University of Massachusetts, Amherst, MA
1 shared publication - Hariharan Krishnan
General Motors R&D, Warren, MI, USA
1 shared publication
Latest Publications
- 1 February 2025
- Published by American Society of Civil Engineers (ASCE) in Journal of Transportation Engineering, Part A: Systems
- Vol. 151 (2)
Evaluation of a Novel Methodology to Measure Bicycle Network Connectivity
- 1 February 2025
- Published by American Society of Civil Engineers (ASCE) in Journal of Transportation Engineering, Part A: Systems
- Vol. 151 (2)
Evaluation of a Novel Methodology to Measure Bicycle Network Connectivity
- 1 January 2013
- Published by SAGE Publications in Transportation Research Record: Journal of the Transportation Research Board
- Vol. 2366 (1) , 17-22
Estimating Queue Length under Connected Vehicle Technology
With the emergence of connected vehicle technology, the use of probe trajectory data to estimate queue length has recently received considerable attention. Unlike data collected by loop detectors, probe trajectory data can provide a lower bound on the queue length even if the market penetration rate is low. An event-based method is developed: it uses both probe trajectory and signal timing data to estimate queue length, and the estimation accuracy under different market penetration rates is examined. A data fusion method is developed: it combines probe trajectory data and loop detector data, and the situation in which the data fusion method is expected to work well is investigated. Case studies are conducted with microscopic simulation data, and some observations are made.
- 1 January 2013
- Published by SAGE Publications in Transportation Research Record: Journal of the Transportation Research Board
- Vol. 2366 (1) , 17-22
Estimating Queue Length under Connected Vehicle Technology
With the emergence of connected vehicle technology, the use of probe trajectory data to estimate queue length has recently received considerable attention. Unlike data collected by loop detectors, probe trajectory data can provide a lower bound on the queue length even if the market penetration rate is low. An event-based method is developed: it uses both probe trajectory and signal timing data to estimate queue length, and the estimation accuracy under different market penetration rates is examined. A data fusion method is developed: it combines probe trajectory data and loop detector data, and the situation in which the data fusion method is expected to work well is investigated. Case studies are conducted with microscopic simulation data, and some observations are made.
- 1 October 2011
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 21530009,p. 1767-1772
Estimation of measures of effectiveness based on Connected Vehicle data
Vehicle-infrastructure cooperation via the Connected Vehicle initiative is a promising mobile data source for improving real-time traffic management applications such as adaptive signal control. This paper focuses on developing estimation methods with the use of Connected Vehicle data for several measures of effectiveness (e.g., queue length, average speed, number of stops), essential for determining traffic conditions on urban signalized arterials for real-time applications. This research systematically determines minimum penetration rates that allow accurate estimates for a wide range of measures of effectiveness in undersaturated traffic conditions. The estimation of these measures and minimum penetration requirements has been tested using Next Generation Simulation (NGSIM) data.
- 1 October 2011
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 21530009,p. 1767-1772
Estimation of measures of effectiveness based on Connected Vehicle data
Vehicle-infrastructure cooperation via the Connected Vehicle initiative is a promising mobile data source for improving real-time traffic management applications such as adaptive signal control. This paper focuses on developing estimation methods with the use of Connected Vehicle data for several measures of effectiveness (e.g., queue length, average speed, number of stops), essential for determining traffic conditions on urban signalized arterials for real-time applications. This research systematically determines minimum penetration rates that allow accurate estimates for a wide range of measures of effectiveness in undersaturated traffic conditions. The estimation of these measures and minimum penetration requirements has been tested using Next Generation Simulation (NGSIM) data.
- Open Access
- 1 January 2010
- Published by SAGE Publications in Transportation Research Record: Journal of the Transportation Research Board
- Vol. 2189 (1) , 68-77
Microscopic Traffic Simulation of Vehicle-to-Vehicle Hazard Alerts on Freeway
Vehicle-to-vehicle (V2V) cooperative systems that alert drivers to roadway hazards are increasingly being studied to improve freeway safety and should be implemented by automakers in the near future. However, the impact of these systems on traffic operations has not been assessed. A methodology is described for modeling driver response to lane-blocking freeway incidents with and without the use of V2V hazard alerts. Driver response to assumed incidents and V2V safety messages is modeled microscopically with the NGSIM oversaturated freeway flow algorithm. The simulation results show how the V2V alerts could influence freeway traffic and provide initial estimates of their benefits.
- 1 January 2010
- Published by SAGE Publications in Transportation Research Record: Journal of the Transportation Research Board
- Vol. 2189 (1) , 68-77
Open AccessMicroscopic Traffic Simulation of Vehicle-to-Vehicle Hazard Alerts on Freeway
Vehicle-to-vehicle (V2V) cooperative systems that alert drivers to roadway hazards are increasingly being studied to improve freeway safety and should be implemented by automakers in the near future. However, the impact of these systems on traffic operations has not been assessed. A methodology is described for modeling driver response to lane-blocking freeway incidents with and without the use of V2V hazard alerts. Driver response to assumed incidents and V2V safety messages is modeled microscopically with the NGSIM oversaturated freeway flow algorithm. The simulation results show how the V2V alerts could influence freeway traffic and provide initial estimates of their benefits.
- 1 December 2008
- Published by American Society of Civil Engineers (ASCE) in Journal of Transportation Engineering
- Vol. 134 (12) , 512-522
Empirical and Analytical Investigation of Traffic Flow Regimes and Transitions in Signalized Arterials
The paper presents a methodological framework that integrates different data-driven techniques in order to detect the different traffic flow regimes (free flow, congested conditions, and so on) observed in signalized arterials as well as the manner traffic flow shifts from one regime to another (transitions). Traffic flow is determined by the joint consideration of the temporal evolution of volume and occupancy. The boundary conditions of the different regimes are identified via a fuzzy wavelet approach based on the volume-occupancy relationship. Moreover, a Bayesian network is developed in order to discover hidden associations between the observed shifts and the traffic flow conditions they occur. Results from the data-driven approach indicate the existence of four distinct traffic flow regimes; these regimes hold in arterials with different geometric and signalization characteristics. Finally, results are further discussed via an analytical model based on the kinematic wave theory; the comparative study...
- 1 December 2008
- Published by American Society of Civil Engineers (ASCE) in Journal of Transportation Engineering
- Vol. 134 (12) , 512-522
Empirical and Analytical Investigation of Traffic Flow Regimes and Transitions in Signalized Arterials
The paper presents a methodological framework that integrates different data-driven techniques in order to detect the different traffic flow regimes (free flow, congested conditions, and so on) observed in signalized arterials as well as the manner traffic flow shifts from one regime to another (transitions). Traffic flow is determined by the joint consideration of the temporal evolution of volume and occupancy. The boundary conditions of the different regimes are identified via a fuzzy wavelet approach based on the volume-occupancy relationship. Moreover, a Bayesian network is developed in order to discover hidden associations between the observed shifts and the traffic flow conditions they occur. Results from the data-driven approach indicate the existence of four distinct traffic flow regimes; these regimes hold in arterials with different geometric and signalization characteristics. Finally, results are further discussed via an analytical model based on the kinematic wave theory; the comparative study...
- 1 December 2007
- Published by Elsevier in Transportation Research Part C: Emerging Technologies
- Vol. 15 (6) , 392-403
Statistical characteristics of transitional queue conditions in signalized arterials
- 1 December 2007
- Published by Elsevier in Transportation Research Part C: Emerging Technologies
- Vol. 15 (6) , 392-403
Statistical characteristics of transitional queue conditions in signalized arterials
- Open Access
- 1 July 2006
- Published by University of South Florida Libraries in Journal of Public Transportation
- Vol. 9 (3) , 117-136
Simulation of Transit Signal Priority Using the NTCIP Architecture
Transit Signal Priority (TSP) is an important element of Bus Rapid Transit (BRT) that involves coordinated efforts between transit vehicle detection systems, traffic signal control systems, and communication technologies. Successful deployment of TSP requires thorough laboratory evaluation through simulation before field implementation. This paper presents the development and application of a simulation model specifically designed for the design and evaluation of TSP systems. The proposed simulation tool models in detail all the TSP components in accordance with the National Transportation Communications for ITS Protocol (NTCIP) standard for TSP systems. The study is intended to shed light on how the variety of TSP elements can be addressed in microscopic simulation in a structured and systematic fashion. Sample applications of the model on a real-life arterial corridor in California demonstrate its capabilities and features.
- 1 July 2006
- Published by University of South Florida Libraries in Journal of Public Transportation
- Vol. 9 (3) , 117-136
Open AccessSimulation of Transit Signal Priority Using the NTCIP Architecture
Transit Signal Priority (TSP) is an important element of Bus Rapid Transit (BRT) that involves coordinated efforts between transit vehicle detection systems, traffic signal control systems, and communication technologies. Successful deployment of TSP requires thorough laboratory evaluation through simulation before field implementation. This paper presents the development and application of a simulation model specifically designed for the design and evaluation of TSP systems. The proposed simulation tool models in detail all the TSP components in accordance with the National Transportation Communications for ITS Protocol (NTCIP) standard for TSP systems. The study is intended to shed light on how the variety of TSP elements can be addressed in microscopic simulation in a structured and systematic fashion. Sample applications of the model on a real-life arterial corridor in California demonstrate its capabilities and features.