Elodie Amiguet
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Elodie Amiguet has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
Bertrand Van De Moortèle
Laboratoire de Géologie de Lyon Université de Lyon, CNRS, ENS de Lyon, Université Claude Bernard Lyon 1, Lyon France
1 shared publication- Bruno Reynard
Laboratoire de Géologie de Lyon, Univ Lyon, ENS de Lyon, Univ Lyon1, CNRS, France
1 shared publication - Nadège Hilairet
Univ. Lille CNRS INRAE Centrale Lille UMR 8207 ‐ UMET ‐ Unité Matériaux et Transformations Lille France
1 shared publication - Patrick Cordier
UMR 8207 - UMET - Unité Matériaux Et Transformations, Univ. Lille, CNRS, INRAE, Centrale Lille, Lille, France
1 shared publication
Latest Publications
- Open Access
- 29 April 2014
- Published by American Geophysical Union (AGU) in Journal of Geophysical Research: Solid Earth
- Vol. 119 (6) , 4640-4655
Deformation mechanisms and rheology of serpentines in experiments and in nature
Microstructures in serpentine samples recovered from deformation experiments performed at high pressure (1–8 GPa), high temperature (150–500°C), and laboratory strain rates (4 10−4–10−6 s−1) were studied using transmission electron microscopy on thin sections prepared by focused ion beam. Lizardite crystals deform by easy glide along the basal planes associated with microkink. This mechanism is associated with a plastic strength of ~100 MPa that defines the upper bound of lizardite strength in natural conditions. Antigorite crystals deform essentially by conjugated slip along (101) and planes observed in sections close to (010). This conjugate system results in an apparent global slip system akin to [100](001). In all samples, delamination and comminution produce fine‐grained interconnected regions at grain boundaries because intracrystalline deformation mechanisms are insufficient to satisfy the von Mises criterion. The deformation laws of lizardite (plastic flow) and antigorite (strain rate dependent) differ because of their differing intracrystalline deformation mechanisms. Subgrain boundary geometry in natural samples and [100](001) crystal preferred orientations indicate the activation of slip systems similar to those observed in experimentally deformed samples, suggesting that the strain rate‐dependent rheology of antigorite derived from experiments applies to subduction zone conditions. Delamination of antigorite crystals of a few tens to hundreds of nanometers is not observed in natural samples from subduction zones, suggesting plastic deformation of serpentinites at natural low strain rates and stresses is likely accompanied by recrystallization through dissolution‐precipitation processes that act as a low‐temperature equivalent of dynamic recrystallization through diffusion at high temperature.
- 29 April 2014
- Published by American Geophysical Union (AGU) in Journal of Geophysical Research: Solid Earth
- Vol. 119 (6) , 4640-4655
Open AccessDeformation mechanisms and rheology of serpentines in experiments and in nature
Microstructures in serpentine samples recovered from deformation experiments performed at high pressure (1–8 GPa), high temperature (150–500°C), and laboratory strain rates (4 10−4–10−6 s−1) were studied using transmission electron microscopy on thin sections prepared by focused ion beam. Lizardite crystals deform by easy glide along the basal planes associated with microkink. This mechanism is associated with a plastic strength of ~100 MPa that defines the upper bound of lizardite strength in natural conditions. Antigorite crystals deform essentially by conjugated slip along (101) and planes observed in sections close to (010). This conjugate system results in an apparent global slip system akin to [100](001). In all samples, delamination and comminution produce fine‐grained interconnected regions at grain boundaries because intracrystalline deformation mechanisms are insufficient to satisfy the von Mises criterion. The deformation laws of lizardite (plastic flow) and antigorite (strain rate dependent) differ because of their differing intracrystalline deformation mechanisms. Subgrain boundary geometry in natural samples and [100](001) crystal preferred orientations indicate the activation of slip systems similar to those observed in experimentally deformed samples, suggesting that the strain rate‐dependent rheology of antigorite derived from experiments applies to subduction zone conditions. Delamination of antigorite crystals of a few tens to hundreds of nanometers is not observed in natural samples from subduction zones, suggesting plastic deformation of serpentinites at natural low strain rates and stresses is likely accompanied by recrystallization through dissolution‐precipitation processes that act as a low‐temperature equivalent of dynamic recrystallization through diffusion at high temperature.