François Silva
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
François Silva has a total of 39 co-authors. Here are the top co-authors by number of shared publications:
- Fabien Benedic
LSPM-CNRS, UPR 3407, Université Paris 13, Sorbonne Paris Cité, 99 Avenue J. B. Clément, 93430 Villetaneuse, France
2 shared publications - Jean-Charles Vanel
LPICM, CNRS, Ecole Polytechnique, Institut Polytechnique de Paris, 91128 Palaiseau, France
2 shared publications - Jocelyn Achard
LSPM, CNRS, Universite Sorbonne Paris Nord, 99 Avenue JB Clement, Villetaneuse 93460, France
2 shared publications K. Hassouni
University of Puerto Rico
2 shared publications- Ovidiu Brinza
LSPM CNRS Université Sorbonne Paris Nord UPR 3407 93430 Villetaneuse France
2 shared publications - Pere Roca i Cabarrocas
LPICM, CNRS, Ecole Polytechnique, Institut Polytechnique de Paris, route de Saclay, Palaiseau 91128, France
2 shared publications
Latest Publications
- Open Access
- 14 July 2023
- Published by American Vacuum Society in Journal of Vacuum Science & Technology A
- Vol. 41 (5)
Reactive plasma sputtering deposition of polycrystalline GaN thin films on silicon substrates at room temperature
We report on the successful growth of polycrystalline GaN thin films on Si (100) substrates at room temperature (without intentional heating) using radiofrequency reactive magnetron sputtering. We use Ar and N2 as the main sputtering and N-atom precursor gas sources, respectively, and a gallium cathode as the Ga-atom source. We focus here on studying the effect of working pressure, as it is found to be the parameter that plays the most influential role on the crystalline quality of the thin films in the investigated range (20–95 mTorr). The morphology, microstructure, and composition profile of the GaN thin films are analyzed using a set of ex situ solid-state characterization techniques. This study reveals that for process pressures below 50 mTorr, the resulting films possess an amorphous nature, while for process pressures above that they become polycrystalline. Most of the crystalline films are found to be nanostructured with grain sizes typically ranging from 10 to 30 nm in size. The highest growth rate of ∼ 2.9 Å/s is obtained for the deposition carried out at 50 mTorr. At this pressure, the films exhibit the best crystallinity with a dominant wurtzite hexagonal structure. The elemental distribution of Ga and N throughout the growth profile is uniform with a sharp interface at the substrate, demonstrating one of the interests in working at low temperatures to avoid melt-back etching, a destructive reaction between gallium and silicon, that usually takes place at high temperatures.
- 14 July 2023
- Published by American Vacuum Society in Journal of Vacuum Science & Technology A
- Vol. 41 (5)
Open AccessReactive plasma sputtering deposition of polycrystalline GaN thin films on silicon substrates at room temperature
We report on the successful growth of polycrystalline GaN thin films on Si (100) substrates at room temperature (without intentional heating) using radiofrequency reactive magnetron sputtering. We use Ar and N2 as the main sputtering and N-atom precursor gas sources, respectively, and a gallium cathode as the Ga-atom source. We focus here on studying the effect of working pressure, as it is found to be the parameter that plays the most influential role on the crystalline quality of the thin films in the investigated range (20–95 mTorr). The morphology, microstructure, and composition profile of the GaN thin films are analyzed using a set of ex situ solid-state characterization techniques. This study reveals that for process pressures below 50 mTorr, the resulting films possess an amorphous nature, while for process pressures above that they become polycrystalline. Most of the crystalline films are found to be nanostructured with grain sizes typically ranging from 10 to 30 nm in size. The highest growth rate of ∼ 2.9 Å/s is obtained for the deposition carried out at 50 mTorr. At this pressure, the films exhibit the best crystallinity with a dominant wurtzite hexagonal structure. The elemental distribution of Ga and N throughout the growth profile is uniform with a sharp interface at the substrate, demonstrating one of the interests in working at low temperatures to avoid melt-back etching, a destructive reaction between gallium and silicon, that usually takes place at high temperatures.
- Open Access
- 20 April 2023
- Published by CAIRN.INFO in Question(s) de management
- Vol. n° 42 (1) , 85-86
Les nouveaux enjeux de la relation en démocratie : apprendre le faire relation
- 20 April 2023
- Published by CAIRN.INFO in Question(s) de management
- Vol. n° 42 (1) , 85-86
Open AccessLes nouveaux enjeux de la relation en démocratie : apprendre le faire relation
- 14 June 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 0964-0968
In Situ Modulated PhotoLuminescence For Process Optimization Of Crystalline Silicon Passivation
Modulated Photoluminescence (MPL) is a powerful tool for measuring the minority carrier lifetime of solar cells. An in house in situ MPL equipped Plasma Enhanced Chemical Vapor Deposition reactor enables the monitoring of passivation properties of solar cells during the fabrication steps of devices. In this study, this tool was used to analyze the impact of annealing steps on passivation properties. First, samples passivated by an aluminum oxide layer were annealed and the evolution of the effective lifetime in the wafer was studied. This allowed to optimize the temperature and duration of the heat treatment. A similar study was made on Fired Passivating Contacts with a passivating stack of SiO x /(p) $\mu\mathrm{c}$ -Si:H/SiN x :H. An interesting low-lifetime regime is consistently observed when the samples undergo a high temperature ( $\mathrm{T} > 350^{\circ}\mathrm{C}$ ) annealing step, followed by a lifetime recovery during the subsequent cooling step. Corona charge and TEM images allowed to get a deeper understanding of the passivation mechanisms evidenced during in situ MPL measurements.- 14 June 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 0964-0968
In Situ Modulated PhotoLuminescence For Process Optimization Of Crystalline Silicon Passivation
Modulated Photoluminescence (MPL) is a powerful tool for measuring the minority carrier lifetime of solar cells. An in house in situ MPL equipped Plasma Enhanced Chemical Vapor Deposition reactor enables the monitoring of passivation properties of solar cells during the fabrication steps of devices. In this study, this tool was used to analyze the impact of annealing steps on passivation properties. First, samples passivated by an aluminum oxide layer were annealed and the evolution of the effective lifetime in the wafer was studied. This allowed to optimize the temperature and duration of the heat treatment. A similar study was made on Fired Passivating Contacts with a passivating stack of SiO x /(p) $\mu\mathrm{c}$ -Si:H/SiN x :H. An interesting low-lifetime regime is consistently observed when the samples undergo a high temperature ( $\mathrm{T} > 350^{\circ}\mathrm{C}$ ) annealing step, followed by a lifetime recovery during the subsequent cooling step. Corona charge and TEM images allowed to get a deeper understanding of the passivation mechanisms evidenced during in situ MPL measurements.- Open Access
- 6 August 2012
- Published by Wiley in Physica Status Solidi (a)
- Vol. 209 (9) , 1750-1753
Homoepitaxial boron‐doped diamond with very low compensation
Homoepitaxial boron‐doped diamond layers grown by chemical vapor deposition on (100)‐oriented substrates are studied by Hall effect and resistivity measurements as a function of the temperature. In the range of 140–600 K, the hole concentration is well described by the neutrality equation in the regime of very low compensation, with the characteristic Ei/2 activation energy, where Ei is the ionization energy of boron acceptors. It indicates that the residual donor concentration is extremely low in the layers (13 cm−3).
- 6 August 2012
- Published by Wiley in Physica Status Solidi (a)
- Vol. 209 (9) , 1750-1753
Open AccessHomoepitaxial boron‐doped diamond with very low compensation
Homoepitaxial boron‐doped diamond layers grown by chemical vapor deposition on (100)‐oriented substrates are studied by Hall effect and resistivity measurements as a function of the temperature. In the range of 140–600 K, the hole concentration is well described by the neutrality equation in the regime of very low compensation, with the characteristic Ei/2 activation energy, where Ei is the ionization energy of boron acceptors. It indicates that the residual donor concentration is extremely low in the layers (13 cm−3).
- 1 April 2006
- Published by Elsevier in Diamond and Related Materials
- Vol. 15 (4-8) , 908-912
Structural and chemical characterisation of soot particles formed in Ar/H2/CH4 microwave discharges during nanocrystalline diamond film synthesis
- 1 April 2006
- Published by Elsevier in Diamond and Related Materials
- Vol. 15 (4-8) , 908-912
Structural and chemical characterisation of soot particles formed in Ar/H2/CH4 microwave discharges during nanocrystalline diamond film synthesis
- 1 June 2005
- Published by Elsevier in Thin Solid Films
- Vol. 482 (1-2) , 50-55
Effects of substrate temperature on nanocrystalline diamond growth: an in-situ optical study using pyrometric interferometry
- 1 June 2005
- Published by Elsevier in Thin Solid Films
- Vol. 482 (1-2) , 50-55
Effects of substrate temperature on nanocrystalline diamond growth: an in-situ optical study using pyrometric interferometry