Yang Yang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Yang Yang has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Rick S. Blum
Department of Electrical and Computer Engineering, Lehigh University, Bethlehem, PA 18015, USA
4 shared publications - Daniel R. Fuhrmann
Department of Electrical and Computer Engineering, Michigan Technological University, Houghton, MI, USA
1 shared publication Rick S. Blum
Department of Electrical and Computer Engineering, Lehigh University
1 shared publicationSana Sfar
CTO Office, InterDigital Communications, LLC
1 shared publication- Tjeng Thiang Tjhung
Inst. for Infocomm Res., Singapore
1 shared publication - Yong Huat Chew
Institute for Infocomm Research, Singapore, Singapore
1 shared publication
Latest Publications
- 29 September 2009
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Signal Processing
- Vol. 58 (3) , 1440-1445
MIMO Radar Waveform Design via Alternating Projection
Waveform design is essential to unleash the performance advantages promised by multiple-input multiple-output (MIMO) radar, and this topic has attracted a lot of attention in the recent years. Revisiting an earlier examined MIMO radar waveform design problem that optimizes both minimum mean-square error estimation (MMSE) and mutual information (MI), in this correspondence we formulate a new waveform design problem and provide some further results, which complement the previous study. More specifically, we present an iterative optimization algorithm based on the alternating projection method to determine waveform solutions that can simultaneously satisfy a structure constraint and optimize the design criteria. Numerical examples are provided, which illustrate the effectiveness of the proposed approach. In particular, we find that the waveform solutions obtained through our proposed algorithm can achieve very close and virtually indistinguishable performance from that predicted in the previous study.
- 29 September 2009
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Signal Processing
- Vol. 58 (3) , 1440-1445
MIMO Radar Waveform Design via Alternating Projection
Waveform design is essential to unleash the performance advantages promised by multiple-input multiple-output (MIMO) radar, and this topic has attracted a lot of attention in the recent years. Revisiting an earlier examined MIMO radar waveform design problem that optimizes both minimum mean-square error estimation (MMSE) and mutual information (MI), in this correspondence we formulate a new waveform design problem and provide some further results, which complement the previous study. More specifically, we present an iterative optimization algorithm based on the alternating projection method to determine waveform solutions that can simultaneously satisfy a structure constraint and optimize the design criteria. Numerical examples are provided, which illustrate the effectiveness of the proposed approach. In particular, we find that the waveform solutions obtained through our proposed algorithm can achieve very close and virtually indistinguishable performance from that predicted in the previous study.
- Open Access
- 19 August 2009
- Published by Springer Nature in EURASIP Journal on Wireless Communications and Networking
- Vol. 2009 (1) , 1
Antenna Selection for MIMO Systems with Closely Spaced Antennas
- 19 August 2009
- Published by Springer Nature in EURASIP Journal on Wireless Communications and Networking
- Vol. 2009 (1) , 1
Open AccessAntenna Selection for MIMO Systems with Closely Spaced Antennas
- 1 August 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 2 (23730803) , 468-472
MIMO Radarwaveform Design
Recently the radar community has been discussing "multiple-input multiple-output (MIMO) radar" that utilizes multiple transmitters to transmit independentwaveforms. MIMO radar offers the potential for significant gains, e.g., diversity gain and spatial resolution gain. Since the employed radar waveform plays a key role in determining the accuracy, resolution, and ambiguity in performing tasks such as determining the target range, velocity, shape and so on, it is meaningful to investigate waveform design specially for this newly proposed MIMO radar. This paper summarizes some of our recent results on MIMO radar waveform design, mainly for identification and classification of extended radar targets. Our waveform design considers optimizing two criteria: maximization of the mutual information (MI) and minimization of the minimum mean-square error (MMSE). In this process, we are also interested in identifying the relationship between the waveforms obtained under the two criteria, given different a prior knowledge of the target's second-order statistics.
- 1 August 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 2 (23730803) , 468-472
MIMO Radarwaveform Design
Recently the radar community has been discussing "multiple-input multiple-output (MIMO) radar" that utilizes multiple transmitters to transmit independentwaveforms. MIMO radar offers the potential for significant gains, e.g., diversity gain and spatial resolution gain. Since the employed radar waveform plays a key role in determining the accuracy, resolution, and ambiguity in performing tasks such as determining the target range, velocity, shape and so on, it is meaningful to investigate waveform design specially for this newly proposed MIMO radar. This paper summarizes some of our recent results on MIMO radar waveform design, mainly for identification and classification of extended radar targets. Our waveform design considers optimizing two criteria: maximization of the mutual information (MI) and minimization of the minimum mean-square error (MMSE). In this process, we are also interested in identifying the relationship between the waveforms obtained under the two criteria, given different a prior knowledge of the target's second-order statistics.
- 1 April 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 303-312
Energy-efficient Routing for Signal Detection under the Neyman-Pearson Criterion in Wireless Sensor Networks
Energy-efficient routing for wireless sensor networks (WSNs) has been a topic of great interest for the last few years, but thus far routing for signal detection in WSNs has not attracted much attention. In particular, little research has focused on the Neyman-Pearson criterion which is the most well accepted metric for radar, sonar and related signal detection problems. In this paper, we formulate the problem of energy-efficient routing for signal detection under the Neyman-Pearson criterion, apparently for the first time. We hereby propose two different routing metrics that aim at a tradeoff between the detection performance and the energy consumption. In particular, the first one leads to a combinatorial problem of identifying a path which achieves the largest possible mean detection-probability-to-energy ratio, while the second one reduces to finding a route which minimizes the consumed energy while maintaining a predetermined detection probability. We further provide efficient algorithms for solving these problems based on state-of-the-art research from operations research. We also present simulation results which indicate the distinctive energy-performance balance achieved by each proposed routing metric.
- 1 April 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 303-312
Energy-efficient Routing for Signal Detection under the Neyman-Pearson Criterion in Wireless Sensor Networks
Energy-efficient routing for wireless sensor networks (WSNs) has been a topic of great interest for the last few years, but thus far routing for signal detection in WSNs has not attracted much attention. In particular, little research has focused on the Neyman-Pearson criterion which is the most well accepted metric for radar, sonar and related signal detection problems. In this paper, we formulate the problem of energy-efficient routing for signal detection under the Neyman-Pearson criterion, apparently for the first time. We hereby propose two different routing metrics that aim at a tradeoff between the detection performance and the energy consumption. In particular, the first one leads to a combinatorial problem of identifying a path which achieves the largest possible mean detection-probability-to-energy ratio, while the second one reduces to finding a route which minimizes the consumed energy while maintaining a predetermined detection probability. We further provide efficient algorithms for solving these problems based on state-of-the-art research from operations research. We also present simulation results which indicate the distinctive energy-performance balance achieved by each proposed routing metric.
- 1 March 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 154-159
Minimax Robust Waveform Design for MIMO Radar in the Presence of PSD Uncertainties
In this paper, we consider the problem of mini-max robust waveform design for multiple-input multiple-output (MIMO) radar based on mutual information (MI) and minimum mean square error (MMSE) estimation for target identification and classification. Recognizing that a single, precise characterization of target power spectral density (PSD) is rare in practice, we assume the PSD lies in an uncertainty class of spectra bounded by known upper and lower bounds, which markedly relaxes the required target a priori knowledge. Based on this band model, we develop minimax robust waveforms for MIMO radar under both MMSE and MI criteria. These robust waveforms bound the worst-case performance at an acceptable limit, and also could insure performance will be sufficiently good for any PSD in the uncertainty class. Our findings also indicate that the MI and MMSE criteria lead to a different minimax robust waveform solutions, which is in contrast to the case of the perfectly known target PSD.
- 1 March 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 154-159
Minimax Robust Waveform Design for MIMO Radar in the Presence of PSD Uncertainties
In this paper, we consider the problem of mini-max robust waveform design for multiple-input multiple-output (MIMO) radar based on mutual information (MI) and minimum mean square error (MMSE) estimation for target identification and classification. Recognizing that a single, precise characterization of target power spectral density (PSD) is rare in practice, we assume the PSD lies in an uncertainty class of spectra bounded by known upper and lower bounds, which markedly relaxes the required target a priori knowledge. Based on this band model, we develop minimax robust waveforms for MIMO radar under both MMSE and MI criteria. These robust waveforms bound the worst-case performance at an acceptable limit, and also could insure performance will be sufficiently good for any PSD in the uncertainty class. Our findings also indicate that the MI and MMSE criteria lead to a different minimax robust waveform solutions, which is in contrast to the case of the perfectly known target PSD.
- 1 January 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 7, 3123-3128
Frequency-domain Channel Frequency Response Estimation for Space-Time Coded MIMO Systems
Frequency-domain equalization (FDE) is an effective technique to mitigate the distortion induced by long-spanning inter-symbol interference, but the receiver requires to estimate the channel information. In this paper, we present a training-based frequency-domain channel frequency response (CFR) estimation scheme, which is hardware efficient when integrating with FDE for space-time (ST) coded multiple-input multiple-output (MIMO) transmissions over frequency-selective fading channels. In this proposed scheme, training sequences are ST block encoded at the transmitter. Similar to when performing FDE, the training sequences are processed after the FFT operation to obtain the CFR. A thorough analysis of the CFR estimation mean square error (MSE) is provided based on both the least squares (LS) and minimum MSE (MMSE) criteria, with the transmit power constraint and the optimal choices of training signals being taken into account. Finally, we demonstrate that when the number of transmit antennas is equal to 2, this CFR estimation could be implemented recursively by means of certain adaptive algorithms. Simulation results are presented to demonstrate the effectiveness of our proposed scheme in joint with FDE in multipath fading channels.
- 1 January 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 7, 3123-3128
Frequency-domain Channel Frequency Response Estimation for Space-Time Coded MIMO Systems
Frequency-domain equalization (FDE) is an effective technique to mitigate the distortion induced by long-spanning inter-symbol interference, but the receiver requires to estimate the channel information. In this paper, we present a training-based frequency-domain channel frequency response (CFR) estimation scheme, which is hardware efficient when integrating with FDE for space-time (ST) coded multiple-input multiple-output (MIMO) transmissions over frequency-selective fading channels. In this proposed scheme, training sequences are ST block encoded at the transmitter. Similar to when performing FDE, the training sequences are processed after the FFT operation to obtain the CFR. A thorough analysis of the CFR estimation mean square error (MSE) is provided based on both the least squares (LS) and minimum MSE (MMSE) criteria, with the transmit power constraint and the optimal choices of training signals being taken into account. Finally, we demonstrate that when the number of transmit antennas is equal to 2, this CFR estimation could be implemented recursively by means of certain adaptive algorithms. Simulation results are presented to demonstrate the effectiveness of our proposed scheme in joint with FDE in multipath fading channels.