María Teresa Ramírez-Palma
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
María Teresa Ramírez-Palma has a total of 29 co-authors. Here are the top co-authors by number of shared publications:
- Erick Cuevas-Yañez
Universidad Autónoma del Estado de México
4 shared publications Diego Martínez-Otero
2 shared publications- Alejandro Dorazco-González
Institute of Chemistry, National Autonomous University of Mexico, Mexico City 04510, Mexico
1 shared publication - Alfredo Santana-Díaz
School of Engineering and Sciences, Tecnologico de Monterrey, Toluca 50110, Mexico
1 shared publication Armando Zambrano-Huerta
1 shared publicationDavid Corona
Centro Conjunto de Investigación en Química Sustentable UAEM-UNAM, Carretera Toluca-Atlacomulco Km. 14.5, Toluca, Estado de México, México Universidad Autónoma del Estado de México
1 shared publication
Latest Publications
- 1 December 2020
- Published by Elsevier in Journal of Molecular Structure
- Vol. 1221
Structural and theoretical studies of 1,3-Bis-(1,2,3-triazol-1-yl)-propan-2-ol derivatives.
- 1 December 2020
- Published by Elsevier in Journal of Molecular Structure
- Vol. 1221
Structural and theoretical studies of 1,3-Bis-(1,2,3-triazol-1-yl)-propan-2-ol derivatives.
- 26 August 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nanotechnology
- Vol. 19 (1536125X) , 711-718
Enhancement of a Green Supercapacitor With a Hydrogel/Carbon Nanotubes-Based Electrolyte
The purpose of this work is to suggest the conception of a supercapacitor using environment-friendly materials, in addition to exhibiting good electrochemical performances. In order to lower the environmental footprint of supercapacitors, one current attempt in the literature is to replace efficient but toxic organic electrolytes by harmless, bio-friendly electrolytes such as a mixture of sodium salt with a hydrogel. However, those bio-friendly electrolytes have not been demonstrated yet to be a relevant alternative, as they are still not able of similar performances as toxic organic electrolytes. The work reported in this paper demonstrates, as a different approach, that the capacitance of a bio-friendly, hydrogel-based electrolyte combined with sodium salt can be significantly increased by adding carbon nanotubes (CNTs) to the gel. As a result, the supercapacitor using the CNT-loaded bio-friendly electrolyte has registered not only an enhanced capacitance, but also better energy and power densities compared to both the same but CNT-free electrolyte, and a toxic DMSO-based organic electrolyte.
- 26 August 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nanotechnology
- Vol. 19 (1536125X) , 711-718
Enhancement of a Green Supercapacitor With a Hydrogel/Carbon Nanotubes-Based Electrolyte
The purpose of this work is to suggest the conception of a supercapacitor using environment-friendly materials, in addition to exhibiting good electrochemical performances. In order to lower the environmental footprint of supercapacitors, one current attempt in the literature is to replace efficient but toxic organic electrolytes by harmless, bio-friendly electrolytes such as a mixture of sodium salt with a hydrogel. However, those bio-friendly electrolytes have not been demonstrated yet to be a relevant alternative, as they are still not able of similar performances as toxic organic electrolytes. The work reported in this paper demonstrates, as a different approach, that the capacitance of a bio-friendly, hydrogel-based electrolyte combined with sodium salt can be significantly increased by adding carbon nanotubes (CNTs) to the gel. As a result, the supercapacitor using the CNT-loaded bio-friendly electrolyte has registered not only an enhanced capacitance, but also better energy and power densities compared to both the same but CNT-free electrolyte, and a toxic DMSO-based organic electrolyte.
- 3 February 2020
- Published by World Scientific Pub Co Pte Ltd in Surface Review and Letters
- Vol. 27 (09)
NANOSTRUCTURED EPOXY-BASED ANTICORROSIVE COATINGS
A functionalized epoxy resin (DGEBA) was synthesized from abietic acid, through the esterification and condensation reactions between the carboxyl groups of abietic acid and the basic functional groups of an epoxy resin. This method of synthesis increases the epoxy resin surface adhesion, as well as the chemical and thermal stability, for being used as a protective coating against corrosion of copper plates. Characterization analyses included FTIR and SEM of both raw and functionalized epoxy resin substrates performed. The corrosion performance of these coatings when applied onto Cu and stainless plates was tested in terms of: (i) immersion in a misty saline chamber, under accelerated corrosive conditions; (ii) Taber abrasion and (iii) hardness, adhesion and potentiodynamic polarization. The obtained results indicate the existence of a chemical bond between the epoxy ring and the carboxyl functional groups of abietic acid. This chemical bonding provided an increased adhesion as well as better chemical and thermal stabilities than those of the original resin. The corrosion resistance lining the functionalized epoxy resin films indicated that their anticorrosive efficiency was up to 30% higher than that of the functionalized resin.
- 3 February 2020
- Published by World Scientific Pub Co Pte Ltd in Surface Review and Letters
- Vol. 27 (09)
NANOSTRUCTURED EPOXY-BASED ANTICORROSIVE COATINGS
A functionalized epoxy resin (DGEBA) was synthesized from abietic acid, through the esterification and condensation reactions between the carboxyl groups of abietic acid and the basic functional groups of an epoxy resin. This method of synthesis increases the epoxy resin surface adhesion, as well as the chemical and thermal stability, for being used as a protective coating against corrosion of copper plates. Characterization analyses included FTIR and SEM of both raw and functionalized epoxy resin substrates performed. The corrosion performance of these coatings when applied onto Cu and stainless plates was tested in terms of: (i) immersion in a misty saline chamber, under accelerated corrosive conditions; (ii) Taber abrasion and (iii) hardness, adhesion and potentiodynamic polarization. The obtained results indicate the existence of a chemical bond between the epoxy ring and the carboxyl functional groups of abietic acid. This chemical bonding provided an increased adhesion as well as better chemical and thermal stabilities than those of the original resin. The corrosion resistance lining the functionalized epoxy resin films indicated that their anticorrosive efficiency was up to 30% higher than that of the functionalized resin.
- 11 July 2019
- Published by Springer Nature in Structural Chemistry
- Vol. 31 (1) , 191-201
Synthesis, structural analysis, and photophysical properties of bi-1,2,3-triazoles
- 11 July 2019
- Published by Springer Nature in Structural Chemistry
- Vol. 31 (1) , 191-201
Synthesis, structural analysis, and photophysical properties of bi-1,2,3-triazoles
- 24 October 2017
- Published by Taylor & Francis in Journal of Macromolecular Science, Part A
- Vol. 54 (12) , 908-914
Synthesis of EDTA core dendrimers through a consecutive esterification-CuAAC process
A novel class of thermostable G0 and G1-dendrimers was synthesized from the coupling of both propargyl and azido esters derived from EDTA through copper catalyzed azide-alkyne cycloaddition. The branching and size in these compounds were controlled by a simple azide-alkyne group position change in the CuAAC reaction in conjunction with the use of 1,3-diazido-propan-2-ol as a polyfunctional compound.
- 24 October 2017
- Published by Taylor & Francis in Journal of Macromolecular Science, Part A
- Vol. 54 (12) , 908-914
Synthesis of EDTA core dendrimers through a consecutive esterification-CuAAC process
A novel class of thermostable G0 and G1-dendrimers was synthesized from the coupling of both propargyl and azido esters derived from EDTA through copper catalyzed azide-alkyne cycloaddition. The branching and size in these compounds were controlled by a simple azide-alkyne group position change in the CuAAC reaction in conjunction with the use of 1,3-diazido-propan-2-ol as a polyfunctional compound.
- Open Access
- 1 January 2016
- Published by Wiley in Journal of Chemistry
- Vol. 2016, 1-7
Ligand Synthesis Catalyst and Complex Metal Ion: Multicomponent Synthesis of 1,3-Bis(4-phenyl-[1,2,3]triazol-1-yl)-propan-2-ol Copper(I) Complex and Application in Copper-Catalyzed Alkyne-Azide Cycloaddition
A new bistriazole copper complex was synthesized by direct treatment of an alkyne, an azide, and CuI as copper salt throughin situligand formation under a multicomponent reaction process. This complex was analyzed by XPS, TGA, DSC, and SEM techniques and revealed a triangular-shaped morphology, high thermal stability, and catalytic power in CuAAC reactions, requiring only 2.5% mol catalyst to afford 1,2,3-triazoles in good yields which can be reused at least for 4 cycles.
- 1 January 2016
- Published by Wiley in Journal of Chemistry
- Vol. 2016, 1-7
Open AccessLigand Synthesis Catalyst and Complex Metal Ion: Multicomponent Synthesis of 1,3-Bis(4-phenyl-[1,2,3]triazol-1-yl)-propan-2-ol Copper(I) Complex and Application in Copper-Catalyzed Alkyne-Azide Cycloaddition
A new bistriazole copper complex was synthesized by direct treatment of an alkyne, an azide, and CuI as copper salt throughin situligand formation under a multicomponent reaction process. This complex was analyzed by XPS, TGA, DSC, and SEM techniques and revealed a triangular-shaped morphology, high thermal stability, and catalytic power in CuAAC reactions, requiring only 2.5% mol catalyst to afford 1,2,3-triazoles in good yields which can be reused at least for 4 cycles.