Jing Liu

Volatile compounds greatly affect tomato aroma, but systematic analysis of volatiles in tomatoes is limited by detection techniques. Here, HS-SPME Arrow-GC × GC-Q/TOFMS was employed to analyze tomato flavor profiles across different cultivation times. To investigate the effects of light and temperature on aroma profiles, three tomato samples across different cultivation periods, including S1 (harvested on May 30th, with lowest temperature and light conditions), S2 (harvested on August 10th, with the highest temperature and light), and S3 (harvested on June 27th, with moderate temperature and light), were analyzed. Overall, 227 volatiles were identified, belonging to 9 aroma categories. Hexanal, (E)-2-hexenal, nonanal, (E)-2-Octenal, trans-geranylacetone, 6-methyl-5-hepten-2-one, 3,4-Octadiene, 7-methyl-, and citral were found to be the key volatiles contributing most significantly to differentiating the samples across cultivation periods, imparting grassy and floral–fruity notes, respectively. The S1 tomatoes had a distinct grassy aroma, whereas the S3 tomatoes had a floral/fruity fragrance. Most differential metabolites were correlated with fatty acid, amino acid, and isoprenoid pathways. S1 tomatoes were characterized by fatty aldehydes (mainly C6/C9), and S2 tomatoes contained high concentrations of fatty alcohols. S3 tomatoes were positively correlated with isoprenoid-derived volatiles. These variations might be caused by the fluctuations in daily temperature and light intensity. This work establishes a foundational reference for assessing environmental effects on tomato flavor profiles.

The detoxification of crops grown in Cadmium (Cd)-contaminated acid soil has been widely studied, but for contaminated alkaline soil, there is still inadequate research or information. In order to investigate the effects of calcium and sulfur fertilizers, accompanied by different side elements, on the growth and Cd uptake of Spinacia oleracea grown in Cd-contaminated alkaline soil, the plants were subjected to five treatments, including calcium silicate (Ca-Si), calcium biphosphate (Ca-P), magnesium sulfate (S-Mg), ferric sulfate (S-Fe), and zinc sulfate (S-Zn), and a control group. The results showed that the S-Fe achieved the highest shoot fresh mass and dry mass and the highest shoot Cd concentration and accumulation, which were 30%, 68%, 4.6%, and 73% higher than the control group, respectively. The Ca-Si, Ca-P, S-Mg, and S-Zn reduced the root Cd concentration by 18%, 42%, 7%, and 49%, respectively, and reduced the shoot Cd concentration by 25%, 36%, 15%, and 27%, respectively, as compared to the control. S-Fe increases plant N uptake and photosynthesis, which is beneficial to biomass accumulation. Ca-P improves soil and plant P nutrition status, as well as plant K and Ca status, and helps alleviate plant Cd stress. Overall, calcium fertilizers accompanied by phosphorus have the potential to reduce plant Cd contamination risk, while sulfur fertilizers accompanied by iron show potential for enhancing Cd extraction.