Wen-Che Tsai
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Wen-Che Tsai has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
Erik S. Jeng
Department of Electronic Engineering, Chung Yuan Christian University, Chung Li 32023, Taiwan
1 shared publicationHui-Ling Kao
Department of Electronic Engineering, Chung Yuan Christian University, Chung Li 32023, Taiwan
1 shared publicationKun-Hsu Liao
Department of Electronic Engineering, Chung Yuan Christian University, Chung Li 32023, Taiwan
1 shared publicationTzu-Ping Lin
Department of Electronic Engineering, Chung Yuan Christian University, Chung Li 32023, Taiwan
1 shared publicationYu-Hao Liu
Department of Electronic Engineering, Chung Yuan Christian University, Chung Li 32023, Taiwan
1 shared publication
Latest Publications
- Open Access
- 27 January 2015
- Published by Optica Publishing Group in Optics Express
- Vol. 23 (3) , 2187-2195
Room temperature fabrication of ZnO/ST-cut quartz SAW UV photodetector with small temperature coefficient
Room-temperature fabricated ZnO/ST-cut quartz is adopted for SAW ultraviolet (UV) photodetector. The ST-cut quartz substrate and ZnO layer are used for SAW excitation and photodetection, respectively. High resolution x-ray diffraction (XRD) and photoluminescence (PL) measurement indicate that high quality ZnO films can be deposited on ST-cut quartz using radio frequency (RF) sputtering. As the SAW devices under UV illumination (6 mW/cm2), a downshift in frequency of about 35 KHz can be observed. The observed small temperature coefficient of frequency (TCF) indicates that SAW devices exhibit good temperature stability. The results present feasibility of using ZnO/ST-cut quartz SAW photodetectors in ultraviolet region.
- 27 January 2015
- Published by Optica Publishing Group in Optics Express
- Vol. 23 (3) , 2187-2195
Open AccessRoom temperature fabrication of ZnO/ST-cut quartz SAW UV photodetector with small temperature coefficient
Room-temperature fabricated ZnO/ST-cut quartz is adopted for SAW ultraviolet (UV) photodetector. The ST-cut quartz substrate and ZnO layer are used for SAW excitation and photodetection, respectively. High resolution x-ray diffraction (XRD) and photoluminescence (PL) measurement indicate that high quality ZnO films can be deposited on ST-cut quartz using radio frequency (RF) sputtering. As the SAW devices under UV illumination (6 mW/cm2), a downshift in frequency of about 35 KHz can be observed. The observed small temperature coefficient of frequency (TCF) indicates that SAW devices exhibit good temperature stability. The results present feasibility of using ZnO/ST-cut quartz SAW photodetectors in ultraviolet region.