Nidhi Singh
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Nidhi Singh has a total of 21 co-authors. Here are the top co-authors by number of shared publications:
- Dilip Yadav
Gautam Buddha University
6 shared publications - Dipti Singh
Gautam Buddha University
4 shared publications - Lillie Dewan
National Institute of Technology Kurukshetra
3 shared publications - Babita Singh
Electrical Engineering Department, Gautam Buddha University, Greater Noida, India
2 shared publications - Nimay Chandra Giri
Department of Electronics and Communication Engineering, Centurion University of Technology and Management, Jatni, India
2 shared publications - Pranay Bhadauria
Gautam Buddha University
2 shared publications
Latest Publications
- 2 November 2026
- Published by Institute of Central Computation and Knowledge Inc. in ICCK Transactions on Sensing, Communication, and Control
- Vol. 3 (4) , 210-236
Genetic Algorithm Based PFOID-SMC with a Sliding Mode Observer for a Quadcopter under Sensing and Communication Constraints
This paper presents a genetic algorithm (GA)-tuned sliding mode controller for a quadcopter (QuCo) in which the sliding surface is built from a proportional-fractional-order-integral-derivative (PFOID) error function (PFOID-SMC). The aim is to achieve accurate trajectory tracking in the presence of aerodynamic drag, wind, sensor noise and parametric uncertainty. Sensing and communication are kept inside the closed loop. The controller receives only measured or estimated states from a gyroscope (200~Hz), an attitude and heading reference system (100~Hz), an RTK-GNSS receiver (10~Hz) and a barometer (50~Hz), each with its own bias and noise, while the reference and the GNSS position are sent over a link with delay, packet loss and quantization. A sliding mode observer reconstructs attitude, angular rates, velocities, wind and disturbance accelerations and motor faults, and its disturbance estimates enter the equivalent control. Finite-time reaching and exponential convergence of the sliding variables are proved channel by channel with Lyapunov functions, and the stability of the complete cascade is checked numerically. The controller is compared with GA-tuned PID, conventional SMC, FOPID, super-twisting SMC and the earlier PFOID-SMC law in 15 scenarios, each with five noise realizations. In nominal conditions, it is not the most accurate (3-D position RMSE 0.119~m, against 0.071~m for FOPID). It gives the lowest error, however, under the strongest wind (0.134~m), under a 30% increase in mass and inertia (0.179~m, against at least 0.82~m for all baselines) and after a 40% loss of effectiveness of one motor (0.147~m). Without the observer, the same controller diverges.
- 2 November 2026
- Published by Institute of Central Computation and Knowledge Inc. in ICCK Transactions on Sensing, Communication, and Control
- Vol. 3 (4) , 210-236
Genetic Algorithm Based PFOID-SMC with a Sliding Mode Observer for a Quadcopter under Sensing and Communication Constraints
This paper presents a genetic algorithm (GA)-tuned sliding mode controller for a quadcopter (QuCo) in which the sliding surface is built from a proportional-fractional-order-integral-derivative (PFOID) error function (PFOID-SMC). The aim is to achieve accurate trajectory tracking in the presence of aerodynamic drag, wind, sensor noise and parametric uncertainty. Sensing and communication are kept inside the closed loop. The controller receives only measured or estimated states from a gyroscope (200~Hz), an attitude and heading reference system (100~Hz), an RTK-GNSS receiver (10~Hz) and a barometer (50~Hz), each with its own bias and noise, while the reference and the GNSS position are sent over a link with delay, packet loss and quantization. A sliding mode observer reconstructs attitude, angular rates, velocities, wind and disturbance accelerations and motor faults, and its disturbance estimates enter the equivalent control. Finite-time reaching and exponential convergence of the sliding variables are proved channel by channel with Lyapunov functions, and the stability of the complete cascade is checked numerically. The controller is compared with GA-tuned PID, conventional SMC, FOPID, super-twisting SMC and the earlier PFOID-SMC law in 15 scenarios, each with five noise realizations. In nominal conditions, it is not the most accurate (3-D position RMSE 0.119~m, against 0.071~m for FOPID). It gives the lowest error, however, under the strongest wind (0.134~m), under a 30% increase in mass and inertia (0.179~m, against at least 0.82~m for all baselines) and after a 40% loss of effectiveness of one motor (0.147~m). Without the observer, the same controller diverges.
- 27 October 2026
- Published by Springer Nature in International Journal of Dynamics and Control
- Vol. 14 (11) , 420
Tracking control of quadcopter using optimized fractional-order backstepping sliding mode controller
- 27 October 2026
- Published by Springer Nature in International Journal of Dynamics and Control
- Vol. 14 (11) , 420
Tracking control of quadcopter using optimized fractional-order backstepping sliding mode controller
- Open Access
- 1 December 2024
- Published by Dewspublication
- Vol. 20 (S15) , 1594-1611
Controller Design Using Grey Wolf Optimization Technique for Reduced Order System
The primary goal of this study is to design a controller for the reduced order sys-tem obtained using Grey Wolf Optimization technique through direct approach. The objective of model order reduction is to maintain the characteristics of the original higher-order system into reduced order model. The method of model order reduction involves the conversion of the critical attributes of the full-scale model into a reduced-order system. The performance of the proposed model or-der reduction method using Grey Wolf optimization is effectively evaluated, and two standard numerical examples are used to demonstrate the unique features of this approach. Using power series expansion, the controller is designed for origi-nal high order system and reduced order model obtained using GWO technique. The response of closed loop high order system response and closed loop reduced order model response are compared with reference model to prove its efficiency. Comparisons are also made between the models generated by this innovative approach and those derived from present and frequently employed model reduc-tion techniques. The recommended approach's efficacy is assessed using perfor-mance error metrics and transient response parameters.
- 1 December 2024
- Published by Dewspublication
- Vol. 20 (S15) , 1594-1611
Open AccessController Design Using Grey Wolf Optimization Technique for Reduced Order System
The primary goal of this study is to design a controller for the reduced order sys-tem obtained using Grey Wolf Optimization technique through direct approach. The objective of model order reduction is to maintain the characteristics of the original higher-order system into reduced order model. The method of model order reduction involves the conversion of the critical attributes of the full-scale model into a reduced-order system. The performance of the proposed model or-der reduction method using Grey Wolf optimization is effectively evaluated, and two standard numerical examples are used to demonstrate the unique features of this approach. Using power series expansion, the controller is designed for origi-nal high order system and reduced order model obtained using GWO technique. The response of closed loop high order system response and closed loop reduced order model response are compared with reference model to prove its efficiency. Comparisons are also made between the models generated by this innovative approach and those derived from present and frequently employed model reduc-tion techniques. The recommended approach's efficacy is assessed using perfor-mance error metrics and transient response parameters.
- 1 July 2024
- Published by Springer Nature
- p. 543-555
Model Order Reduction of Linear Continuous and Discrete Systems Using Grey Wolf Optimization
- 1 July 2024
- Published by Springer Nature
- p. 543-555
Model Order Reduction of Linear Continuous and Discrete Systems Using Grey Wolf Optimization
- 1 July 2024
- Published by Springer Nature
- p. 237-249
GA Based Order Abatement Technique for Linear Dynamic Systems
- 1 July 2024
- Published by Springer Nature
- p. 237-249
GA Based Order Abatement Technique for Linear Dynamic Systems
- 1 July 2024
- Published by Springer Nature
- p. 191-210
Performance Analysis of Ann-Based Multi-Input Hybrid Power Conversion System
- 1 July 2024
- Published by Springer Nature
- p. 191-210
Performance Analysis of Ann-Based Multi-Input Hybrid Power Conversion System
- Open Access
- 12 April 2024
- Published by Hindawi Limited in International Journal of Intelligent Systems
- Vol. 2024, 1-29
Comparison of Bioinspired Techniques for Tracking Maximum Power under Variable Environmental Conditions
This paper presents a comparative analysis of bioinspired algorithms employed on a PV system subject to standard conditions, under step-change of irradiance conditions, and a partial shading condition for tracking the global maximum power point (GMPP). Four performance analysis and comparison techniques are artificial bee colony, particle swarm optimization, genetic algorithm, and a new metaheuristic technique called jellyfish optimization, respectively. These existing algorithms are well-known for tracking the GMPP with high efficiency. This paper compares these algorithms based on extracting GMPP in terms of maximum power from a PV module running at a uniform (STC), nonuniform solar irradiation (under step-change of irradiance), and partial shading conditions (PSCs). For analysis and comparison, two modules are taken: 1Soltech-1STH-215P and SolarWorld Industries GmbH Sunmodule plus SW 245 poly module, which are considered to form a panel by connecting four series modules. Comparison is based on maximum power tracking, total execution time, and minimum number of iterations to achieve the GMPP with high tracking efficiency and minimum error. Minitab software finds the regression equation (objective function) for STC, step-changing irradiation, and PSC. The reliability of the data (P-V curves) was measured in terms of p value, R, , and VIF. The value comes out to be near 1, which shows the accuracy of the data. The simulation results prove that the new evolutionary jellyfish optimization technique gives better results in terms of higher tracking efficiency with very less time to obtain GMPP in all environmental conditions, with a higher efficiency of 98 to 99.9% with less time of 0.0386 to 0.1219 sec in comparison to ABC, GA, and PSO. The RMSE value for the proposed method JFO (0.59) is much lower than that of ABC, GA, and PSO.- 12 April 2024
- Published by Hindawi Limited in International Journal of Intelligent Systems
- Vol. 2024, 1-29
Open AccessComparison of Bioinspired Techniques for Tracking Maximum Power under Variable Environmental Conditions
This paper presents a comparative analysis of bioinspired algorithms employed on a PV system subject to standard conditions, under step-change of irradiance conditions, and a partial shading condition for tracking the global maximum power point (GMPP). Four performance analysis and comparison techniques are artificial bee colony, particle swarm optimization, genetic algorithm, and a new metaheuristic technique called jellyfish optimization, respectively. These existing algorithms are well-known for tracking the GMPP with high efficiency. This paper compares these algorithms based on extracting GMPP in terms of maximum power from a PV module running at a uniform (STC), nonuniform solar irradiation (under step-change of irradiance), and partial shading conditions (PSCs). For analysis and comparison, two modules are taken: 1Soltech-1STH-215P and SolarWorld Industries GmbH Sunmodule plus SW 245 poly module, which are considered to form a panel by connecting four series modules. Comparison is based on maximum power tracking, total execution time, and minimum number of iterations to achieve the GMPP with high tracking efficiency and minimum error. Minitab software finds the regression equation (objective function) for STC, step-changing irradiation, and PSC. The reliability of the data (P-V curves) was measured in terms of p value, R, , and VIF. The value comes out to be near 1, which shows the accuracy of the data. The simulation results prove that the new evolutionary jellyfish optimization technique gives better results in terms of higher tracking efficiency with very less time to obtain GMPP in all environmental conditions, with a higher efficiency of 98 to 99.9% with less time of 0.0386 to 0.1219 sec in comparison to ABC, GA, and PSO. The RMSE value for the proposed method JFO (0.59) is much lower than that of ABC, GA, and PSO. - 24 January 2024
- Published by Springer Nature
- p. 141-158
Performance Analysis of Various Converters in PV Systems Using PSO-Based MPPT
- 24 January 2024
- Published by Springer Nature
- p. 141-158
Performance Analysis of Various Converters in PV Systems Using PSO-Based MPPT