David Alldred
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
David Alldred has a total of 2 co-authors. Here are the top co-authors by number of shared publications:
- Brian Cousins
Edward S. Rogers Sr. Department of Electrical and Computer Engineering, University of Toronto, Toronto, ON, M5S 3G4, Canada
1 shared publication - Sorin P. Voinigescu
Edward S. Rogers Sr. Department of Electrical and Computer Engineering, University of Toronto, Toronto, ON, M5S 3G4, Canada
1 shared publication
Latest Publications
- 1 November 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 15508781,p. 51-54
A 1.2V, 60-GHz radio receiver with on-chip transformers and inductors in 90-nm CMOS
This paper describes an integrated 60-GHz receiver in 90-nm CMOS including an LNA and downconversion mixer as well as LO and IF buffers. Transformer baluns are used for S/D conversion of the RF and LO signals to allow for conventional double-balanced mixing. The single-ended downconversion gain of a 60 GHz signal to a 5 GHz IF is 16 dB with an input compression point of-21 dBm while consuming 60 mW of power. The DSB noise figure is below 7 dB over the entire IF bandwidth which is greater than 1 GHz. The use of spiral inductors and transformers as matching elements resulted in a die area of only 600 mum times 475 mum including pads
- 1 November 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 15508781,p. 51-54
A 1.2V, 60-GHz radio receiver with on-chip transformers and inductors in 90-nm CMOS
This paper describes an integrated 60-GHz receiver in 90-nm CMOS including an LNA and downconversion mixer as well as LO and IF buffers. Transformer baluns are used for S/D conversion of the RF and LO signals to allow for conventional double-balanced mixing. The single-ended downconversion gain of a 60 GHz signal to a 5 GHz IF is 16 dB with an input compression point of-21 dBm while consuming 60 mW of power. The DSB noise figure is below 7 dB over the entire IF bandwidth which is greater than 1 GHz. The use of spiral inductors and transformers as matching elements resulted in a die area of only 600 mum times 475 mum including pads