JJJinsheng Jia

Jinsheng Jia

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Jinsheng Jia has a total of 9 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Analysis and Solution of Stripe Defect of Glass Tubes Produced by All-Electric Melting Furnace

    by Zhenbo Cao, Meilun Zhang, Jinsheng Jia

    Stripe is a kind of glass defect with complicated causes, which is difficult to avoid completely in production. Based on the serious influence of stripe defects on production efficiency in all-electric fused glass kiln, routine analyses were conducted to reveal its causes. According to the results, the kiln was adjusted but the problem remained unresolved. Finally, cracks at the bottom edge of the material basin were observed during the inspection of the structural elements. After the basin was replaced, the streaks disappeared, so it was determined that the defect at the bottom of the basin was the root cause of streaks. This paper can provide solutions for all-electric glass kiln and analysis of stripe defects in related industries, improve the solution efficiency and ensure the smooth operation of production.

  • Open Access

    The Microstructure Evolution Process and Flexural Behaviours of SiC Matrix Ceramic Infiltrated by Aluminium Base Alloy

    by Wei Wang, Jinsheng Jia, Yong Sun, Zhuang Kong, Tianyi Na, Liangliang Yang, Ruina Ma, Qiang Li

    In this paper, an infiltration approach was proposed to generate a Ti3Si(Al)C2 transition layer in SiC matrix composites to effectually strengthen SiC ceramics. The infiltration temperature played a significant role in the evolution of the microstructure, phase composition, and flexural behaviours. Molten aluminium base alloy fully penetrated SiC ceramic after infiltration at different experimental temperatures (800–1000 °C). The phases in the reaction layer on the surface of SiC ceramic samples varied with the infiltration temperature. When infiltrated at 800 °C, only SiC and Al phases can be found in SiC composites, whereas at 900 °C, a reaction layer containing Ti3Si(Al)C2 and SiC was produced. The Ti3Si(Al)C2 phase grew in situ on SiC. At 1000 °C, the Ti3Si(Al)C2 phase was unstable and decomposed into TiC and Ti5Si3. The cermet phase Ti3Si(Al)C2 was synthesized at a relatively low temperature. Consequently, the flexural modulus and three-point bending strength of samples infiltrated at 900 °C was enhanced by 1.4 and 2.4 times for the original SiC ceramic, respectively.