Bin Shan

Accurate and reliable positioning for urban vehicles remains challenging under urban canyon conditions, where Global Navigation Satellite System (GNSS) observations are frequently degraded by multipath, blockage, intermittent outages, and unstable recovery after signal reacquisition. An Inertial Navigation System (INS) can provide continuous short-term motion estimation, but its solution gradually drifts over time. Therefore, robust INS/GNSS integration is essential for urban vehicle positioning. However, in position-only fusion, contaminated GNSS positions can directly distort the integrated positioning solution. Conventional fixed-covariance filters and covariance-only adaptive filters are often insufficient to handle urban GNSS errors that are simultaneously time-varying, bias-like, and phase-dependent. To address this issue, this paper proposes a dual-adaptive robust cubature Kalman filter (Dual-ACKF) for urban vehicle INS/GNSS integration under degraded GNSS conditions. Unlike conventional adaptive CKF/UKF methods that mainly regulate the measurement-noise covariance, the proposed Dual-ACKF jointly introduces an explicit GNSS positioning bias state, a slave innovation-energy-based measurement-noise estimator, and scenario-aware robust update strategies for canyon, outage, and recovery conditions. The proposed method is validated using a challenging real-world UrbanNav sequence with Real-Time Kinematic (RTK)-derived reference trajectories and quality-defined GNSS degradation segments. Compared with Dual-AUKF, CKF, and UKF, the proposed Dual-ACKF reduces the P95 horizontal error in the outage segment from 521.23 m, 582.72 m, and 591.60 m to 228.21 m, corresponding to reductions of 56.22%, 60.84%, and 61.43%, respectively. It also reduces the maximum outage error from 638.02 m, 707.37 m, and 718.78 m to 246.45 m, demonstrating stronger long-tail error suppression during degraded and recovery-related periods. These results indicate that explicitly coupling GNSS bias absorption, online measurement-confidence regulation, and phase-dependent robust updates improves the reliability of position-only INS/GNSS integration in challenging urban environments.

To improve the reliability of strapdown inertial navigation system (SINS)/Doppler radar/odometer integrated navigation system, the federated Kalman filter with two-stage fault detection structure is designed, and a fault-tolerant SINS/Doppler radar/odometer integrated navigation method is proposed. Firstly, the pre-fault detection module sets before the local filter, and the residual chi-square test in the carrier coordinate system is selected to detect the abrupt faults of Doppler radar and odometer. Then, the secondary-fault detection module emplaces between the local filter and the main filter, and the sequential probability ratio test (SPRT) is selected to further detect the ramp faults that are difficult to detect by the residual chi-square test. To address the limitation of the SPRT in accurately determining the end time of faults, an improved SPRT is proposed. The improved SPRT reduces the influence of historical fault on the fault statistics by introducing forgetting factors to improve its sensitivity to the fault end. The simulation experiment indicates that the proposed method can quickly detect and isolate abrupt and ramp faults, and promptly restore normal operation of the integrated navigation system after the fault ends, effectively improving the fault tolerance and reliability of the integrated navigation system.

A micro-inertial measurement unit (MIMU) is usually used to sense the angular rate and acceleration of the flight carrier. In this study, multiple MEMS gyroscopes were used to form a spatial non-orthogonal array to construct a redundant MIMU system, and an optimal Kalman filter (KF) algorithm was established by a steady-state KF gain to combine array signals to improve the MIMU’s accuracy. The noise correlation was used to optimize the geometric layout of the non-orthogonal array and reveal the mechanisms of influence of correlation and geometric layout on MIMU’s performance improvement. Additionally, two different conical configuration structures of a non-orthogonal array for 4,5,6,8-gyro were designed and analyzed. Finally, a redundant 4-MIMU system was designed to verify the proposed structure and KF algorithm. The results demonstrate that the input signal rate can be accurately estimated and that the gyro’s error can also be effectively reduced through fusion of non-orthogonal array. The results for the 4-MIMU system illustrate that the gyro’s ARW and RRW noise can be decreased by factors of about 3.5 and 2.5, respectively. In particular, the estimated errors (1σ) on the axes of X_b, Y_b and Z_b were 4.9, 4.6 and 2.9 times lower than that of the single gyroscope.