HHHuan He

Huan He

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Huan He has a total of 42 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Hardware-efficient phase noise compensation for km-scale and mm-level resolution OFDR

    by Shuyan Chen, Huan He, Zhiyong Zhao, Luming Zhao, Ming Tang, Chao Lu

    We demonstrate a hardware-efficient, linewidth-tolerant OFDR system that eliminates the need for an independent auxiliary receiver and a high hardware sampling rate. Using a multiplexed delay configuration, a single integrated coherent receiver simultaneously captures the laser phase noise reference and sensing signal. By introducing an upsampling process in the phase noise compensation algorithm, the unnecessary sampling rate overhead in the experiment is avoided. Finally, using a 200 kHz linewidth laser, the system achieves a 1.5 mm spatial resolution over a 1.9 km fiber, proving its high practicality for low-cost and high-performance distributed fiber sensing.

  • Vector magnetic field sensing using a tapered seven-core fiber modal interferometer

    by Qingyu Wei, Yucheng Yao, Xuchen Hua, Huan He, Ming Tang

    We propose and demonstrate a compact all-fiber vector magnetic field sensor based on a tapered seven-core fiber reflective modal interferometer. The sensor exploits the intrinsic spatial arrangement of the outer cores to detect directional microbending induced by an external magnetic field. A microsphere functionalized with a magneto-mechanically responsive Fe 3 O 4 composite at the fiber tip translates the magnetic field vector into distinct directional spectral shifts. The fabricated device achieves a maximum sensitivity of 17.14 pm/mT with high linearity ( R 2 >0.95) across a measurement range of 30 to 60 mT. This robust architecture and comprehensive vector sensing capability provide a highly promising solution for spatial magnetic mapping and advanced navigation systems.

  • Integrated Sensing and Communication in Self-Homodyne MCF Transmission Systems With Linear Frequency Modulation

    by Bowen Yin, Shuyan Chen, Huan He, Yuqi Li, Mingming Zhang, Yang Shi, Zhiyong Zhao, Ming Tang

    Self-homodyne coherent detection (SHCD) has emerged as a promising solution for high-capacity, cost-effective data center interconnects (DCI), leveraging a co-propagating local oscillator (LO) to simplify receiver-side digital signal processing (DSP). Nevertheless, as these architectures toward hyperscale deployments, integrating distributed optical fiber sensing (DOFS) in DCI becomes increasingly critical, offering essential real-time link health monitoring, particularly optical multipath interference, transmission loss, and vibration disturbances. However, conventional integrated implementations rely on time-domain pulsed localization and phase unwrapping techniques, which inherently suffer from limited spatial resolution and strain detection range. Here we propose a novel architecture that integrates the SHCD transmission system with optical frequency domain reflectometry (OFDR) using shared spectral resources. Both signal and LO paths in the SHCD system undergo periodic linear frequency modulation (LFM), where the induced phase noise is compensated at the receiver via relative-time-delay (RTD) matching between signal and LO. The remote-delivered LO light inherently serves as the sensing probe to ensure the implementation of OFDR. The experiment demonstrates that we successfully achieve 25-GBaud DP-16QAM transmission and 2-cm spatial resolution sensing over a $\sim$10-km multi-core fiber, enabling a vibration sensitivity of 0.0492 $\mu \varepsilon$ /V, with 250 Hz theoretical maximum detection frequency. Remarkably, the integrated transmission system has negligible performance degradation ($\leq$ 0.6 dB) compared to conventional separated systems. We believe the proposed integrated system offers a practical solution to enable sensing capability in DCI.


  • Open Access

    Frequency-comb enabled spectrum-correlation reflectometry for distributed fiber-optic sensing

    by Zhonghong Lin, Zhiyong Zhao, Huan He, Can Chen, Ming Tang, Marcelo A. Soto

    Distributed fiber-optic sensing has become an indispensable tool for large-scale structural and environmental monitoring, where spectral interrogation of backscattering light enables high-precision quantitative measurement of external perturbations. Conventional spectral analysis methods, typically based on frequency-domain serial interrogation or time-to-frequency mapping, face inherent trade-offs between measurement speed, dynamic strain measurement range, and system complexity. Here, we present a distributed frequency comb enabled spectrum-correlation reflectometry as a universal spectral analysis framework that leverages optical frequency comb for parallel multi-frequency interrogation, which is experimentally demonstrated in a phase-sensitive optical time-domain reflectometry (φ-OTDR) system. This method eliminates the need for large frequency scans, achieving more than tenfold improvement in measurement speed over the state-of-the-art spectral analysis methods. Compared to existing phase-demodulated φ-OTDR systems, this method enables vibration amplitude monitoring with a dynamic strain measurement range expanded by more than an order of magnitude, while intrinsically circumventing phase unwrapping issues and interference fading. This work establishes a new paradigm for distributed spectral analysis, providing a flexible and robust platform for a wide range of sensing technologies, including Rayleigh and Brillouin-based schemes, which may have significant impact for geophysics, seismology, civil engineering, and other fields.


  • Open Access

    Ultrawideband dynamic microwave frequency–amplitude measurement

    by Huan He, Jingchuan Wang, Zhiyong Zhao, Dongmei Huang, Alan Pak Tao Lau, Chao Lu, Ming Tang

    Microwave measurement is crucial in various fields, such as communication, radar, and cognitive radio, now poised for a revolution with the advent of photonic-assisted techniques that promise unprecedented performance. However, existing methods often disrupt the amplitude integrity of unknown signals and rely on time-consuming frequency sweeping to achieve multifrequency detection, which markedly restricts their instantaneous bandwidth, response speed, and accuracy. Here, we present a groundbreaking approach leveraging digital optical frequency comb–enabled stimulated Brillouin scattering to achieve instantaneous microwave frequency and amplitude detection, attaining a record-breaking 50.8-gigahertz bandwidth, a 1.1-megahertz accuracy, and a 500-nanosecond temporal resolution, which is three orders of magnitude improvement over that obtained with frequency sweeping schemes. In addition to conventional frequency detection, the proposed technique enables simultaneous multifrequency microwave amplitude measurement and achieves a substantial performance enhancement in the figure of merit of more than 10-fold, which paves the way for dynamic microwave signal detection and analysis.


  • Frequency-Scanning ϕ-OTDR With Symmetrical Triangular Linear Frequency Modulation Probe Light

    by Can Chen, Zhiyong Zhao, Can Zhao, Zhonghong Lin, Huan He, Ming Tang

    A novel frequency-scanning phase-sensitive optical time domain reflectometry (ϕ-OTDR) based on symmetrical triangular linear frequency modulation (LFM) is proposed and demonstrated. By applying pre-distorted triangular driving voltage to the laser, two sets of linear frequency sweeping probe light are generated during the rising and falling edge of the triangular wave, thereby two groups of Rayleigh backscattered (RBS) spectra are obtained, respectively. Cross-correlation calculation is then performed to get the frequency shifts that are generated by the external disturbances, thus enabling quantitative dynamic strain measurement. A high detection sensitivity of 64.2 $p\varepsilon /\sqrt {\text{Hz}} $ is obtained with a fiber of 276 m. Unlike the traditional LFM scheme utilizing the sawtooth driving voltage, no sharp frequency change would be generated in the proposed scheme, as a result all the acquired data can be used for processing, which facilitates the detection of higher frequency vibrations. For proof of concept, a 1.2 kHz vibration is successfully retrieved by the proposed system, which turns out to be undetectable using the conventional systems due to the constraints of Nyquist sampling theory. What's more, the demodulated results of the acquired RBS spectra respectively from the rising edges and falling edges could be used to mitigate the demodulation error induced by the spurious correlation peak in cross-correlation calculation, yielding a more accurate frequency shift determination. The proposed method paves the way to achieve high-sensitivity dynamic monitoring in engineering applications.


  • High-Accuracy Sweep-Free BOTDA Enabled by Simultaneous Full-Field Brillouin Spectra Measurement

    by Huan He, Zhiyong Zhao, Weilun Wei, Can Zhao, Dongmei Huang, Ming Tang

    We propose and demonstrate a novel dynamic Brillouin optical time domain analysis (BOTDA) by utilizing frequency-agility double-sideband digital optical frequency comb (DOFC) probes. For the first time, simultaneous interrogation of the complex Brillouin gain, loss and corresponding phase spectra is realized without frequency sweeping process. An acoustic-optical modulator is employed to aid in the simultaneous acquisition of full-field Brillouin spectra without sideband selective optical filters, yielding a fixed frequency offset over the spectral range via direct detection. Through the joint analysis of additional spectra, the measurement accuracy can be significantly improved compared to the traditional single-sideband-based schemes. In addition, frequency-agility DOFC probes are used to improve the spatial resolution while maintaining an acceptable frequency resolution. Eventually, the proposed BOTDA achieves a 4-m spatial resolution and less than 1.53-MHz frequency uncertainty over 10-km fiber with 400-MHz dynamic measurement range for the full-field Brillouin spectra. For proof of concept, dynamic vibration measurement is demonstrated with 40 Hz sampling rate. The proposed scheme with full-field Brillouin spectra measurement provides high accuracy enhancement, showcasing a promising application for distributed dynamic sensing.


  • Single-End-Access BOCDA Enabled by Multi-Core Fiber for Dynamic Strain Measurements

    by Huan He, Shuyan Chen, Zhiyong Zhao, Dongmei Huang, Ming Tang

    We propose and demonstrate a single-end-access dynamic Brillouin optical correlation-domain analysis sensor based on the multi-core fiber (MCF) and lock-in-amplifier-free detection scheme. The pump and the probe are individually injected into two cores at the same end of a 7-core MCF, where the cores are directly connected at the other end through fan-in/fan-out couplers to achieve single-ended access. Using another pair of cores as a reference path, the Brillouin gain information along two sensing cores is extracted through power subtraction processing, which eliminates the additional reference fiber links and further suppresses the parasitic intensity modulation noise. A measurement accuracy of 1.41 MHz is achieved at a 200-kHz sampling rate. Sensing information from two sensing cores are simultaneously acquired, allowing longitudinal and radial strain measurements. For proof of concept, measurements of up to 1-kHz longitudinal vibration and a 13.1-Hz radial bending-induced vibration are successfully demonstrated with 10-cm spatial resolution, showing great potential for fast high-resolution dynamic strain measurement.


  • Sweep-free Brillouin Optical Correlation Domain Analysis utilizing Digital Optical Frequency Comb

    by Huan He, Shuyan Chen, Can Zhao, Zhiyong Zhao, Songnian Fu, Ming Tang

    We propose and demonstrate a probe sweep-free Brillouin optical correlation domain analysis sensor based on digital optical frequency comb, where acquisitions of Brillouin gain spectrum reach 20 kSa/s at arbitrary position with 10-cm spatial resolution.

  • Accelerating Transmitter Dispersion Eye Closure Quaternary Assessment by Deep Transfer Learning Technique

    by Zengchun Luo, Huan He, Yi Xu, Meng Xiang, Yi Cai, Yuwen Qin, Songnian Fu

    Transmitter dispersion eye closure quaternary (TDECQ) is one of the most important parameters that can systematically evaluate the signal quality of four-level pulse amplitude modulation format (PAM-4) transmitters. We experimentally demonstrate the acceleration of TDECQ assessment by deep transfer learning (DTL) technique. With the help of amplitude histograms (AHs) generated by the received PAM-4 signal, we are able to characterize the TDECQ value directly by the deep neural network (DNN). To further reduce both the computation time and the experimental data used for the training, simulation data can be used to provide the suitable source domain for the DTL implementation. The experimental results of 25 Gbaud PAM-4 signals indicate that, the mean absolute error of TDECQ assessment is below 0.18 dB over a TDECQ range from 1.9 to 3.6 dB. Meanwhile, 33.3% amount of the used experimental data and 40% epochs can be simultaneously reduced during the training process, due to the use of DTL.