Shweta Jagtap
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Shweta Jagtap has a total of 57 co-authors. Here are the top co-authors by number of shared publications:
Upasana Choudhari
Department of Electronic and Instrumentation Science
8 shared publicationsShraddha Hambir
7 shared publicationsSayali Atkare
Department of Physics, Savitribai Phule Pune University, Ganeshkhind, Pune 411007, India
4 shared publications- Chandra Sekhar Rout
Jain University
3 shared publications Mrudul Modak
Department of Electronic and Instrumentation Science, Savitribai Phule Pune University, Pune, India
3 shared publicationsSunil Mahajan
Department of Electronic and Instrumentation Science, Savitribai Phule Pune University, Pune, India
3 shared publications
Latest Publications
- Open Access
- 23 May 2026
- Published by Elsevier in SSRN Electronic Journal
Experiment-Informed SQS–DFT Analysis of SnO2/SnS2 Heterostructures for Low-Temperature NO2 Sensing
Detection of nitrogen dioxide (NO2) at low operating temperature is essential for both environmental and industrial applications. In this study, SnO2/SnS2 heterostructures were synthesized via a hydrothermal method at 200 ◦C for durations of 8, 10, 12, and 14 h to examine gas sensing applications. Structural and compositional analyses verified the formation of well-crystallized interfaces between the SnO2 and SnS2 phases. The optimized sensor showed the highest response (Rg/Ra) of 49.3 to 5 ppm NO2 at 70 ◦C, with reasonably good response/recovery times of 23.2 s / 424.6 s and excellent temporal stability. To rationalize this work, density functional theory (DFT) calculations were performed using experiment-informed Special Quasirandom Structure models that reproduce the measured Sn–S–O stoichiometry. The simulations identified the oxygen site as the most favorable NO2 adsorption site (Eads = –0.25 eV) with a charge transfer of 0.0039 e− (from Bader analysis). Density-of-states results revealed S- and O-derived states emerging near the Fermi level upon adsorption, indicating band-gap narrowing and enhanced conductivity. The combined experimental and theoretical insights show that heterojunction-driven charge distribution and moderate chemisorption underpin the superior NO2 sensing of the SnO2/SnS2 heterostructure.
- 23 May 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessExperiment-Informed SQS–DFT Analysis of SnO2/SnS2 Heterostructures for Low-Temperature NO2 Sensing
Detection of nitrogen dioxide (NO2) at low operating temperature is essential for both environmental and industrial applications. In this study, SnO2/SnS2 heterostructures were synthesized via a hydrothermal method at 200 ◦C for durations of 8, 10, 12, and 14 h to examine gas sensing applications. Structural and compositional analyses verified the formation of well-crystallized interfaces between the SnO2 and SnS2 phases. The optimized sensor showed the highest response (Rg/Ra) of 49.3 to 5 ppm NO2 at 70 ◦C, with reasonably good response/recovery times of 23.2 s / 424.6 s and excellent temporal stability. To rationalize this work, density functional theory (DFT) calculations were performed using experiment-informed Special Quasirandom Structure models that reproduce the measured Sn–S–O stoichiometry. The simulations identified the oxygen site as the most favorable NO2 adsorption site (Eads = –0.25 eV) with a charge transfer of 0.0039 e− (from Bader analysis). Density-of-states results revealed S- and O-derived states emerging near the Fermi level upon adsorption, indicating band-gap narrowing and enhanced conductivity. The combined experimental and theoretical insights show that heterojunction-driven charge distribution and moderate chemisorption underpin the superior NO2 sensing of the SnO2/SnS2 heterostructure.
- 9 February 2026
- Published by American Chemical Society (ACS) in ACS Applied Nano Materials
- Vol. 9 (7) , 3231-3245
Heterointerface-Engineered NiCo 2 O 4 /Ti 3 C 2 T X Nanohybrids for Electrochemical Detection of Hydrogen Peroxide
- 9 February 2026
- Published by American Chemical Society (ACS) in ACS Applied Nano Materials
- Vol. 9 (7) , 3231-3245
Heterointerface-Engineered NiCo 2 O 4 /Ti 3 C 2 T X Nanohybrids for Electrochemical Detection of Hydrogen Peroxide
- Open Access
- 20 October 2025
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 15 (47) , 39795-39806
Synergistic g-C 3 N 4 @SnO 2 nano heterostructures and their application for enhanced humidity sensing
We report g-C 3 N 4 @SnO 2 nanocomposites as efficient wide range and swift humidity-sensing materials. SnO 2 nanoparticles synthesized via a facile solvothermal route were coupled in situ with g-C 3 N 4 sheets through an economic solid-state process.
- 20 October 2025
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 15 (47) , 39795-39806
Open AccessSynergistic g-C 3 N 4 @SnO 2 nano heterostructures and their application for enhanced humidity sensing
We report g-C 3 N 4 @SnO 2 nanocomposites as efficient wide range and swift humidity-sensing materials. SnO 2 nanoparticles synthesized via a facile solvothermal route were coupled in situ with g-C 3 N 4 sheets through an economic solid-state process.
- Open Access
- 5 September 2025
- Published by Royal Society of Chemistry (RSC) in Sensors & Diagnostics
- Vol. 4 (11) , 939-965
Lab on chip for medical and clinical applications
This review provides an in-depth analysis of the fundamentals, technological integration, and expanding applications of lab-on-a-chip (LOC) devices within the realm of clinical and biomedical sciences.
- 5 September 2025
- Published by Royal Society of Chemistry (RSC) in Sensors & Diagnostics
- Vol. 4 (11) , 939-965
Open AccessLab on chip for medical and clinical applications
This review provides an in-depth analysis of the fundamentals, technological integration, and expanding applications of lab-on-a-chip (LOC) devices within the realm of clinical and biomedical sciences.
- 1 September 2025
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 36 (25) , 1-14
Studies on structural and electrical properties of NTC thermistors
- 1 September 2025
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 36 (25) , 1-14
Studies on structural and electrical properties of NTC thermistors
- 17 May 2025
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 1031
Room-temperature NO₂ sensors based on UV-assisted Pt functionalized MoS₂-MoTe₂ heterostructures
- 17 May 2025
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 1031
Room-temperature NO₂ sensors based on UV-assisted Pt functionalized MoS₂-MoTe₂ heterostructures
- Open Access
- 22 April 2025
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 15 (17) , 12987-12996
Enzyme-immobilized graphene oxide-based electrochemical biosensor for glutathione detection
Glutathione acts as a natural antioxidant in the human body and the reduction of its content is a sign of oxidative stress. In this study, a sensitive electrochemical sensor was developed using laccase enzyme immobilized onto graphene oxide (GO) for detection of glutathione. The surface of the indium tin oxide (ITO) was modified with GO via a drop casting method. Subsequently, laccase was immobilized onto the modified ITO decorated with GO. The modified electrode was characterized using field-emission scanning electron microscopy (FESEM), X-ray photoelectron spectroscopy (XPS), Fourier transform infrared spectroscopy (FTIR), cyclic voltammetry (CV) and electrochemical impedance spectroscopy (EIS). The FTIR spectra of laccase/GO confirmed the successful immobilization of laccase onto GO sheets. FESEM analysis revealed the transformation from a layered, wrinkled structure to a compact, smooth surface with spherical laccase, confirming successful enzyme integration. Raman analysis confirmed successful laccase immobilization onto GO, as evidenced by structural changes in the D and G bands, highlighting the modification of the material. The cyclic voltammetry measurements revealed that laccase/GO/ITO exhibited better electrocatalytic activity toward oxidation of GSH in acetate buffer solution than the bare ITO electrode. This newly developed electrode exhibited a good response to glutathione with a wide linear range from 1 μM to 100 μM, a limit of detection of 0.89 μM and high sensitivity (6.51 μA μM−1). Furthermore, it exhibited excellent selectivity, repeatability, and long-term stability. The modified electrode was successfully used for the detection of GSH in a real sample, offering satisfactory results.
- 22 April 2025
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 15 (17) , 12987-12996
Open AccessEnzyme-immobilized graphene oxide-based electrochemical biosensor for glutathione detection
Glutathione acts as a natural antioxidant in the human body and the reduction of its content is a sign of oxidative stress. In this study, a sensitive electrochemical sensor was developed using laccase enzyme immobilized onto graphene oxide (GO) for detection of glutathione. The surface of the indium tin oxide (ITO) was modified with GO via a drop casting method. Subsequently, laccase was immobilized onto the modified ITO decorated with GO. The modified electrode was characterized using field-emission scanning electron microscopy (FESEM), X-ray photoelectron spectroscopy (XPS), Fourier transform infrared spectroscopy (FTIR), cyclic voltammetry (CV) and electrochemical impedance spectroscopy (EIS). The FTIR spectra of laccase/GO confirmed the successful immobilization of laccase onto GO sheets. FESEM analysis revealed the transformation from a layered, wrinkled structure to a compact, smooth surface with spherical laccase, confirming successful enzyme integration. Raman analysis confirmed successful laccase immobilization onto GO, as evidenced by structural changes in the D and G bands, highlighting the modification of the material. The cyclic voltammetry measurements revealed that laccase/GO/ITO exhibited better electrocatalytic activity toward oxidation of GSH in acetate buffer solution than the bare ITO electrode. This newly developed electrode exhibited a good response to glutathione with a wide linear range from 1 μM to 100 μM, a limit of detection of 0.89 μM and high sensitivity (6.51 μA μM−1). Furthermore, it exhibited excellent selectivity, repeatability, and long-term stability. The modified electrode was successfully used for the detection of GSH in a real sample, offering satisfactory results.
- 17 February 2025
- Published by Royal Society of Chemistry (RSC) in Chemical Society Reviews
- Vol. 54 (8) , 3736-3774
Exploring the potential of metal–organic framework based composites as key players in bisphenol detection
This review presents an insightful overview of the detection of bisphenol and its analogues using metal–organic framework composites via different detection techniques.
- 17 February 2025
- Published by Royal Society of Chemistry (RSC) in Chemical Society Reviews
- Vol. 54 (8) , 3736-3774
Exploring the potential of metal–organic framework based composites as key players in bisphenol detection
This review presents an insightful overview of the detection of bisphenol and its analogues using metal–organic framework composites via different detection techniques.
- Open Access
- 26 July 2024
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 14 (33) , 24130-24140
2H-SnS2 assembled with petaloid 1T@2H-MoS2 nanosheet heterostructures for room temperature NO2 gas sensing
In this study, we explored the gas-sensing capabilities of MoS2 petaloid nanosheets in the metallic 1T phase with the commonly investigated semiconducting 2H phase.
- 26 July 2024
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 14 (33) , 24130-24140
Open Access2H-SnS2 assembled with petaloid 1T@2H-MoS2 nanosheet heterostructures for room temperature NO2 gas sensing
In this study, we explored the gas-sensing capabilities of MoS2 petaloid nanosheets in the metallic 1T phase with the commonly investigated semiconducting 2H phase.