Sergiy Lyubchyk
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Sergiy Lyubchyk has a total of 41 co-authors. Here are the top co-authors by number of shared publications:
- Aleksander S. Doroshkevich
Joint Institute for Nuclear Research
2 shared publications - Alisa A. Tatarinova
Joint Institute for Nuclear Research, Dubna, 141980, Russia
2 shared publications - Dan Chicea
Research Center for Complex Physical Systems, Faculty of Sciences, Lucian Blaga University of Sibiu, 550012 Sibiu, Romania
2 shared publications - Matlab Nabi Mirzayev
Joint Institute for Nuclear Research, Joliot-Curie 6, Dubna, Moscow region, 141980, Russia
2 shared publications - Svitlana B. Lyubchyk
Research Centre in Industrial Engineering Management and Sustainability, Lusófona University, 1749-024 Lisbon, Portugal
2 shared publications - A.A. Moldanazar1 shared publication
Latest Publications
- Open Access
- 4 July 2026
- Published by IWA Publishing in Journal of Water and Climate Change
- Vol. 17 (7) , 1924-1942
Multiscale evaluation of gridded precipitation and temperature in the High Atlas (Morocco)
This study presents a multiscale evaluation of five gridded climate products, ERA5-Land, TerraClimate, CHIRPS, CHIRTS, and PERSIANN CCS-CDR, over the semiarid topographically complex High Atlas Mountains of Morocco. Using observations from nine ground stations, performance was assessed at daily, monthly, and annual scales through correlation coefficient, RMSE, bias, and MAE metrics. Results reveal substantial spatial and temporal variability in accuracy. ERA5-Land consistently achieved the highest agreement with observations (CC = 0.92–0.99 for temperature), attributed to its multisource data assimilation framework. TerraClimate also performed well, particularly for temperature and monthly precipitation, benefiting from hybrid downscaling and elevation correction. In contrast, satellite-based products exhibited pronounced systematic biases, including precipitation overestimation (+110% for CHIRPS), underestimation (−34% for PERSIANN CCS-CDR), and significant temperature biases for CHIRTS, especially at high-altitude stations. Spatial analysis confirmed a consistent decline in performance with increasing elevation, underscoring the limitations of both reanalysis and satellite-based estimation in mountainous terrain. These findings stress the importance of bias correction and careful dataset selection for hydrological, agricultural, and climate change applications. More broadly, this work offers a transferable evaluation framework for data-scarce, topographically complex regions, providing actionable guidance for researchers, water managers, and policymakers supporting climate adaptation strategies.
- 4 July 2026
- Published by IWA Publishing in Journal of Water and Climate Change
- Vol. 17 (7) , 1924-1942
Open AccessMultiscale evaluation of gridded precipitation and temperature in the High Atlas (Morocco)
This study presents a multiscale evaluation of five gridded climate products, ERA5-Land, TerraClimate, CHIRPS, CHIRTS, and PERSIANN CCS-CDR, over the semiarid topographically complex High Atlas Mountains of Morocco. Using observations from nine ground stations, performance was assessed at daily, monthly, and annual scales through correlation coefficient, RMSE, bias, and MAE metrics. Results reveal substantial spatial and temporal variability in accuracy. ERA5-Land consistently achieved the highest agreement with observations (CC = 0.92–0.99 for temperature), attributed to its multisource data assimilation framework. TerraClimate also performed well, particularly for temperature and monthly precipitation, benefiting from hybrid downscaling and elevation correction. In contrast, satellite-based products exhibited pronounced systematic biases, including precipitation overestimation (+110% for CHIRPS), underestimation (−34% for PERSIANN CCS-CDR), and significant temperature biases for CHIRTS, especially at high-altitude stations. Spatial analysis confirmed a consistent decline in performance with increasing elevation, underscoring the limitations of both reanalysis and satellite-based estimation in mountainous terrain. These findings stress the importance of bias correction and careful dataset selection for hydrological, agricultural, and climate change applications. More broadly, this work offers a transferable evaluation framework for data-scarce, topographically complex regions, providing actionable guidance for researchers, water managers, and policymakers supporting climate adaptation strategies.
- Open Access
- 28 October 2025
- Published by Technobius in Technobius
- Vol. 5 (4) , 0090
Vibro-pressed concrete for wall blocks based on lightweight expanded clay aggregate obtained with the addition of oil sludge
This study develops lightweight expanded clay aggregate (LECA) from local low-expanding loams using an oil-sludge-based fuel-containing additive and evaluates its use in vibro-pressed lightweight aggregate concrete (LWAC) wall blocks. LECA was produced by granulation and firing, then characterized by bulk density, water absorption, and compressive strength. LWAC blocks were manufactured via a semi-dry vibro-pressing route and tested for density, compressive strength, thermal conductivity, and freeze-thaw resistance. The LECA incorporating oil sludge showed a strength increase from 1.38 MPa to 2.8-3.1 MPa with a moderate density rise (316 to 350-400 kg/m3) while maintaining ~25.8% water absorption. Blocks achieved 800-950 kg/m3 density and 10-12 MPa compressive strength, with 0.75-0.8 W/(m·K) thermal conductivity and 50-75 freeze-thaw cycles. XRD pattern fitting indicated silicate- and spinel-type crystalline phases, though some matches require verification. Overall, the raw material and processing route enable structural wall units with improved thermal performance. The future work should prioritize moisture-related durability under higher saturation.
- 28 October 2025
- Published by Technobius in Technobius
- Vol. 5 (4) , 0090
Open AccessVibro-pressed concrete for wall blocks based on lightweight expanded clay aggregate obtained with the addition of oil sludge
This study develops lightweight expanded clay aggregate (LECA) from local low-expanding loams using an oil-sludge-based fuel-containing additive and evaluates its use in vibro-pressed lightweight aggregate concrete (LWAC) wall blocks. LECA was produced by granulation and firing, then characterized by bulk density, water absorption, and compressive strength. LWAC blocks were manufactured via a semi-dry vibro-pressing route and tested for density, compressive strength, thermal conductivity, and freeze-thaw resistance. The LECA incorporating oil sludge showed a strength increase from 1.38 MPa to 2.8-3.1 MPa with a moderate density rise (316 to 350-400 kg/m3) while maintaining ~25.8% water absorption. Blocks achieved 800-950 kg/m3 density and 10-12 MPa compressive strength, with 0.75-0.8 W/(m·K) thermal conductivity and 50-75 freeze-thaw cycles. XRD pattern fitting indicated silicate- and spinel-type crystalline phases, though some matches require verification. Overall, the raw material and processing route enable structural wall units with improved thermal performance. The future work should prioritize moisture-related durability under higher saturation.
- Open Access
- 11 October 2023
- Published by MDPI AG in Preprints.org
Influence of Neutron Irradiation on the Generation of Charge Carriers in Heated Silicon-Germanium Film Structures for Thermal Energy Converters
The effect of neutron irradiation of Si-Ge/Si film structures obtained by gas-phase epitaxy on the processes of charge carrier generation and the magnitude of the dark short-circuit current and open-circuit voltage caused by it is studied, it is shown that their magnitude practically does not change with time. The results obtained indicate that all types of structural defects, both associated with dopant impurities and radiation exposure, contribute to the generation of charge carriers in heated silicon structures with the participation of deep energy levels, which indicates the applicability of neutron processing of silicon materials to create thermal energy converters, operating at high temperatures.
- 11 October 2023
- Published by MDPI AG in Preprints.org
Open AccessInfluence of Neutron Irradiation on the Generation of Charge Carriers in Heated Silicon-Germanium Film Structures for Thermal Energy Converters
The effect of neutron irradiation of Si-Ge/Si film structures obtained by gas-phase epitaxy on the processes of charge carrier generation and the magnitude of the dark short-circuit current and open-circuit voltage caused by it is studied, it is shown that their magnitude practically does not change with time. The results obtained indicate that all types of structural defects, both associated with dopant impurities and radiation exposure, contribute to the generation of charge carriers in heated silicon structures with the participation of deep energy levels, which indicates the applicability of neutron processing of silicon materials to create thermal energy converters, operating at high temperatures.
- Open Access
- 1 January 2023
- Published by Korkyt Ata Kyzylorda University in Chemistry and Chemical Technology
- Vol. 3, 7-17
STUDY OF FLAVONOIDS IN CAMEL THORN AND THEIR ACTIVITY IN ANGIOTENSIN-CONVERTING ENZYME REDUCTION
- 1 January 2023
- Published by Korkyt Ata Kyzylorda University in Chemistry and Chemical Technology
- Vol. 3, 7-17
Open AccessSTUDY OF FLAVONOIDS IN CAMEL THORN AND THEIR ACTIVITY IN ANGIOTENSIN-CONVERTING ENZYME REDUCTION
- Open Access
- 11 October 2022
- Published by MDPI AG in Preprints.org
The Influence of the Dispersing Agent Nature on the Interaction of DNA Nucleotides with the Surface of YSZ Nanoparticles and the Homogeneity of Lyophilites Based on Them
A variational analysis of dispersion medium (electrolytes and surfactants) was carried out for the best nucleotide interactions with the presence of nanoparticles and the ability to formation of homogeneous coatings upon drying / lyophilization. Using UV-spectroscopy and transmission electron microscopy, the processes of immobilization of nucleotides on the surface of nanoparti-cles of the composition ZrO2-3mol% Y2O3 (YSZ) in the presence of various dispersing agents were investigated. Promising dispersing agents were established, the optimal composition of suspen-sions based on DNA nucleotides and YSZ nanoparticles, which is potentially suitable for adaptive technologies of bionanoelectronics, was selected. The aim of the work is to obtain and study functional media for molecular electronics based on heterojunctions biological molecule – wide-gap dielectric.
- 11 October 2022
- Published by MDPI AG in Preprints.org
Open AccessThe Influence of the Dispersing Agent Nature on the Interaction of DNA Nucleotides with the Surface of YSZ Nanoparticles and the Homogeneity of Lyophilites Based on Them
A variational analysis of dispersion medium (electrolytes and surfactants) was carried out for the best nucleotide interactions with the presence of nanoparticles and the ability to formation of homogeneous coatings upon drying / lyophilization. Using UV-spectroscopy and transmission electron microscopy, the processes of immobilization of nucleotides on the surface of nanoparti-cles of the composition ZrO2-3mol% Y2O3 (YSZ) in the presence of various dispersing agents were investigated. Promising dispersing agents were established, the optimal composition of suspen-sions based on DNA nucleotides and YSZ nanoparticles, which is potentially suitable for adaptive technologies of bionanoelectronics, was selected. The aim of the work is to obtain and study functional media for molecular electronics based on heterojunctions biological molecule – wide-gap dielectric.