Shuo Dong
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Shuo Dong has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
- Guohong Chen
College of Ecological Environment and Urban Construction, Fujian University of Technology, Fuzhou 350118, China
2 shared publications - Junjiang Bai
College of Ecological Environment and Urban Construction, Fujian University of Technology, Fuzhou 350118, China
2 shared publications - Rengui Weng
College of Ecological Environment and Urban Construction, Fujian University of Technology, Fuzhou 350118, China
2 shared publications - Feng Tian
College of Ecological Environment and Urban Construction, Fujian University of Technology, Fuzhou 350118, China
1 shared publication - Jie Qin
College of Ecological Environment and Urban Construction, Fujian University of Technology, Fuzhou 350118, China
1 shared publication - Shaojie Li
College of Ecological Environment and Urban Construction, Fujian University of Technology, Fuzhou 350118, China
1 shared publication
Latest Publications
- Open Access
The Performance of Cellulose Composite Membranes and Their Application in Drinking Water Treatment
Water scarcity and water pollution have become increasingly severe, and therefore, the purification of water resources has recently garnered increasing attention. Given its position as a major water resource, the efficient purification of drinking water is of crucial importance. In this study, we adopted a phase transition method to prepare ZrO2/BCM (bamboo cellulose membranes), after which we developed IP-ZrO2/BC-NFM (bamboo cellulose nanofiltration membranes) through interfacial polymerization using piperazine (PIP) and tricarbonyl chloride (TMC). Subsequently, we integrated these two membranes to create a combined “ultrafiltration + nanofiltration” membrane process for the treatment of drinking water. The membrane combination process was conducted at 25 °C, with ultrafiltration at 0.1 MPa and nanofiltration at 0.5 MPa. This membrane combination, featuring “ultrafiltration + nanofiltration,” had a significant impact on reducing turbidity, consistently maintaining the post-filtration turbidity of drinking water at or below 0.1 NTU. Furthermore, the removal rates for CODMN and ammonia nitrogen reached 75% and 88.6%, respectively, aligning with the standards for high-quality drinking water. In a continuous 3 h experiment, the nanofiltration unit exhibited consistent retention rates for Na2SO4 and bovine serum protein (BSA), with variations of less than 5%, indicating exceptional separation performance. After 9 h of operation, the water flux of the nanofiltration unit began to stabilize, with a decrease rate of approximately 25%, demonstrating that the “ultrafiltration + nanofiltration” membrane combination can maintain consistent performance during extended use. In conclusion, the “ultrafiltration + nanofiltration” membrane combination exhibited remarkable performance in the treatment of drinking water, offering a viable solution to address issues related to water scarcity and water pollution.
Open AccessThe Performance of Cellulose Composite Membranes and Their Application in Drinking Water Treatment
Water scarcity and water pollution have become increasingly severe, and therefore, the purification of water resources has recently garnered increasing attention. Given its position as a major water resource, the efficient purification of drinking water is of crucial importance. In this study, we adopted a phase transition method to prepare ZrO2/BCM (bamboo cellulose membranes), after which we developed IP-ZrO2/BC-NFM (bamboo cellulose nanofiltration membranes) through interfacial polymerization using piperazine (PIP) and tricarbonyl chloride (TMC). Subsequently, we integrated these two membranes to create a combined “ultrafiltration + nanofiltration” membrane process for the treatment of drinking water. The membrane combination process was conducted at 25 °C, with ultrafiltration at 0.1 MPa and nanofiltration at 0.5 MPa. This membrane combination, featuring “ultrafiltration + nanofiltration,” had a significant impact on reducing turbidity, consistently maintaining the post-filtration turbidity of drinking water at or below 0.1 NTU. Furthermore, the removal rates for CODMN and ammonia nitrogen reached 75% and 88.6%, respectively, aligning with the standards for high-quality drinking water. In a continuous 3 h experiment, the nanofiltration unit exhibited consistent retention rates for Na2SO4 and bovine serum protein (BSA), with variations of less than 5%, indicating exceptional separation performance. After 9 h of operation, the water flux of the nanofiltration unit began to stabilize, with a decrease rate of approximately 25%, demonstrating that the “ultrafiltration + nanofiltration” membrane combination can maintain consistent performance during extended use. In conclusion, the “ultrafiltration + nanofiltration” membrane combination exhibited remarkable performance in the treatment of drinking water, offering a viable solution to address issues related to water scarcity and water pollution.
- Open Access
- 3 March 2023
- Published by MDPI AG in International Journal of Environmental Research and Public Health
- Vol. 20 (5) , 4525
Study on the Radioactivity Levels of Metal Tailings in the Lhasa Area of Tibet
The main purpose of this study was to determine the natural radioactivity level of raw radionuclides in the metal tailings of a mine in Lhasa, Tibet, and to conduct sampling and detection in 17 typical metal tailing mines in Lhasa, Tibet. The specific activity concentrations of 226Ra, 232Th, and 40K in the samples were calculated. The total αβχγ radiation, radon concentration, and outdoor absorbed dose rate in the air 1.0 m above the ground were measured. The γ radiation levels affecting miners and their surrounding residents were assessed. The results show that the radiation dose ranges from 0.08 μSv/h to 0.26 μSv/h, and the radon concentration ranges from 10.8 Bq/m3 to 29.6 Bq/m3, which does not exceed the national radiation-related standards, and the environmental hazard risk is low. The specific activity concentration of 226Ra ranged from 8.91 Bq/kg to 94.61 Bq/kg, the specific activity concentration of 232Th ranged from 2.90 Bq/kg to 89.62 Bq/kg, and the specific activity concentration of 40K was less than MDA to 762.89 Bq/kg. The average absorbed dose rate (DO) of the 17 mining areas was 39.82 nGy/h, the average annual effective dose rate (EO) was 0.057 mSv/y. The average external risk index of the 17 mining areas was 0.24, the average internal risk index was 0.34, and the average γ index was 0.31, all of which were less than the maximum permissible limit. This means that the metal tailings from all 17 mining areas were within the limit for γ radiation and, therefore, can be used in bulk as major building materials without posing a significant radiation threat to the residents of the study area.
- 3 March 2023
- Published by MDPI AG in International Journal of Environmental Research and Public Health
- Vol. 20 (5) , 4525
Open AccessStudy on the Radioactivity Levels of Metal Tailings in the Lhasa Area of Tibet
The main purpose of this study was to determine the natural radioactivity level of raw radionuclides in the metal tailings of a mine in Lhasa, Tibet, and to conduct sampling and detection in 17 typical metal tailing mines in Lhasa, Tibet. The specific activity concentrations of 226Ra, 232Th, and 40K in the samples were calculated. The total αβχγ radiation, radon concentration, and outdoor absorbed dose rate in the air 1.0 m above the ground were measured. The γ radiation levels affecting miners and their surrounding residents were assessed. The results show that the radiation dose ranges from 0.08 μSv/h to 0.26 μSv/h, and the radon concentration ranges from 10.8 Bq/m3 to 29.6 Bq/m3, which does not exceed the national radiation-related standards, and the environmental hazard risk is low. The specific activity concentration of 226Ra ranged from 8.91 Bq/kg to 94.61 Bq/kg, the specific activity concentration of 232Th ranged from 2.90 Bq/kg to 89.62 Bq/kg, and the specific activity concentration of 40K was less than MDA to 762.89 Bq/kg. The average absorbed dose rate (DO) of the 17 mining areas was 39.82 nGy/h, the average annual effective dose rate (EO) was 0.057 mSv/y. The average external risk index of the 17 mining areas was 0.24, the average internal risk index was 0.34, and the average γ index was 0.31, all of which were less than the maximum permissible limit. This means that the metal tailings from all 17 mining areas were within the limit for γ radiation and, therefore, can be used in bulk as major building materials without posing a significant radiation threat to the residents of the study area.