Alex Bersani
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Alex Bersani has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
- Giorgio Davico
Department of Industrial Engineering, Alma Mater Studiorum - University of Bologna, Bologna, Italy
4 shared publications - Marco Viceconti
Department of Industrial Engineering, Alma Mater Studiorum - University of Bologna, Bologna, Italy
3 shared publications - Erkki Somersalo
Department of Mathematics, Applied Mathematics and Statistics, Case Western Reserve University, Cleveland, OH 44106 USA
2 shared publications - Andrea Di Pietro
Department of Civil and Industrial Engineering, University of Pisa, Italy
1 shared publication - Cristina Curreli
Medical Technology Lab, IRCCS Istituto Ortopedico Rizzoli, 40136 Bologna, Italy
1 shared publication D. Calvetti
1 shared publication
Latest Publications
- Open Access
- 1 October 2025
- Published by Elsevier in Journal of Biomechanics
- Vol. 193, 112993
Stochastic modelling of muscle control during shoulder abduction
- 1 October 2025
- Published by Elsevier in Journal of Biomechanics
- Vol. 193, 112993
Open AccessStochastic modelling of muscle control during shoulder abduction
- Open Access
- 22 August 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Neural Systems and Rehabilitation Engineering
- Vol. 32 (15344320) , 3270-3277
Myobolica: A Stochastic Approach to Estimate Physiological Muscle Control Variability
The inherent redundancy of the musculoskeletal systems is traditionally solved by optimizing a cost function. This approach may not be correct to model non-adult or pathological populations likely to adopt a “non-optimal” motor control strategy. Over the years, various methods have been developed to address this limitation, such as the stochastic approach. A well-known implementation of this approach, Metabolica, samples a wide number of plausible solutions instead of searching for a single one, leveraging Bayesian statistics and Markov Chain Monte Carlo algorithm, yet allowing muscles to abruptly change their activation levels. To overcome this and other limitations, we developed a new implementation of the stochastic approach (Myobolica), adding constraints and parameters to ensure the identification of physiological solutions. The aim of this study was to evaluate Myobolica, and quantify the differences in terms of width of the solution band (muscle control variability) compared to Metabolica. To this end, both muscle forces and knee joint force solutions bands estimated by the two approaches were compared to one another, and against (i) the solution identified by static optimization and (ii) experimentally measured knee joint forces. The use of Myobolica led to a marked narrowing of the solution band compared to Metabolica. Furthermore, the Myobolica solutions well correlated with the experimental data (R 2 = 0.92, RMSE = 0.3 BW), but not as much with the optimal solution (R 2 = 0.82, RMSE = 0.63 BW). Additional analyses are required to confirm the findings and further improve this implementation.
- 22 August 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Neural Systems and Rehabilitation Engineering
- Vol. 32 (15344320) , 3270-3277
Open AccessMyobolica: A Stochastic Approach to Estimate Physiological Muscle Control Variability
The inherent redundancy of the musculoskeletal systems is traditionally solved by optimizing a cost function. This approach may not be correct to model non-adult or pathological populations likely to adopt a “non-optimal” motor control strategy. Over the years, various methods have been developed to address this limitation, such as the stochastic approach. A well-known implementation of this approach, Metabolica, samples a wide number of plausible solutions instead of searching for a single one, leveraging Bayesian statistics and Markov Chain Monte Carlo algorithm, yet allowing muscles to abruptly change their activation levels. To overcome this and other limitations, we developed a new implementation of the stochastic approach (Myobolica), adding constraints and parameters to ensure the identification of physiological solutions. The aim of this study was to evaluate Myobolica, and quantify the differences in terms of width of the solution band (muscle control variability) compared to Metabolica. To this end, both muscle forces and knee joint force solutions bands estimated by the two approaches were compared to one another, and against (i) the solution identified by static optimization and (ii) experimentally measured knee joint forces. The use of Myobolica led to a marked narrowing of the solution band compared to Metabolica. Furthermore, the Myobolica solutions well correlated with the experimental data (R 2 = 0.92, RMSE = 0.3 BW), but not as much with the optimal solution (R 2 = 0.82, RMSE = 0.63 BW). Additional analyses are required to confirm the findings and further improve this implementation.
- Open Access
- 14 June 2024
- Published by Elsevier in Chaos, Solitons & Fractals
- Vol. 185
Exploring muscle recruitment by Bayesian methods during motion
- 14 June 2024
- Published by Elsevier in Chaos, Solitons & Fractals
- Vol. 185
Open AccessExploring muscle recruitment by Bayesian methods during motion
- Open Access
- 25 April 2024
- Published by Elsevier in Computers in Biology and Medicine
- Vol. 175, 108524
AST: An OpenSim-based tool for the automatic scaling of generic musculoskeletal models
- 25 April 2024
- Published by Elsevier in Computers in Biology and Medicine
- Vol. 175, 108524
Open AccessAST: An OpenSim-based tool for the automatic scaling of generic musculoskeletal models
- 1 October 2023
- Published by Human Kinetics in Journal of Applied Biomechanics
- Vol. 39 (5) , 294-303
Modeling Human Suboptimal Control: A Review
This review paper provides an overview of the approaches to model neuromuscular control, focusing on methods to identify nonoptimal control strategies typical of populations with neuromuscular disorders or children. Where possible, the authors tightened the description of the methods to the mechanisms behind the underlying biomechanical and physiological rationale. They start by describing the first and most simplified approach, the reductionist approach, which splits the role of the nervous and musculoskeletal systems. Static optimization and dynamic optimization methods and electromyography-based approaches are summarized to highlight their limitations and understand (the need for) their developments over time. Then, the authors look at the more recent stochastic approach, introduced to explore the space of plausible neural solutions, thus implementing the uncontrolled manifold theory, according to which the central nervous system only controls specific motions and tasks to limit energy consumption while allowing for some degree of adaptability to perturbations. Finally, they explore the literature covering the explicit modeling of the coupling between the nervous system (acting as controller) and the musculoskeletal system (the actuator), which may be employed to overcome the split characterizing the reductionist approach.
- 1 October 2023
- Published by Human Kinetics in Journal of Applied Biomechanics
- Vol. 39 (5) , 294-303
Modeling Human Suboptimal Control: A Review
This review paper provides an overview of the approaches to model neuromuscular control, focusing on methods to identify nonoptimal control strategies typical of populations with neuromuscular disorders or children. Where possible, the authors tightened the description of the methods to the mechanisms behind the underlying biomechanical and physiological rationale. They start by describing the first and most simplified approach, the reductionist approach, which splits the role of the nervous and musculoskeletal systems. Static optimization and dynamic optimization methods and electromyography-based approaches are summarized to highlight their limitations and understand (the need for) their developments over time. Then, the authors look at the more recent stochastic approach, introduced to explore the space of plausible neural solutions, thus implementing the uncontrolled manifold theory, according to which the central nervous system only controls specific motions and tasks to limit energy consumption while allowing for some degree of adaptability to perturbations. Finally, they explore the literature covering the explicit modeling of the coupling between the nervous system (acting as controller) and the musculoskeletal system (the actuator), which may be employed to overcome the split characterizing the reductionist approach.