KHKhuat Thi Hong

Khuat Thi Hong

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Khuat Thi Hong has a total of 30 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • ASSESSMENT OF POTENTIALLY TOXIC ELEMENTS DEPOSITION IN HUNG YEN AND BAC NINH PROVINCES (VIETNAM) USING MOSS BARBULA INDICA BIOMONITORING TECHNIQUE

    by Khiem Hong LE, Nam Dai LE, Inga Zinicovscaia, Nikita Yushin, Son An Nguyen, Thai Thi Xuan Nguyen, My Thi Bao Nguyen, Hieu Trung Nguyen, Trung Van Dinh, Binh Thanh Nguyen, et al.

    Air pollution with potentially harmful elements in two industrial provinces in the Red River Delta, northern Vietnam, was studied using Barbula indica moss. The content of 12 elements including Al, V, Cr, Mn, Fe, Co, Ni, Cu, Zn, Cd, Hg and Pb in the moss samples collected at 36 different locations in the Bac Ninh and Hung Yen was identified by inductively coupled plasma optical emission spectroscopy and direct mercury analyzer. The mean concentrations of Al, V, Cr, Mn, Fe, Co, Ni, Cu, Zn, Cd, Hg, and Pb in the moss samples were 5042, 12.0, 27.0, 222, 4899, 2.6, 11, 90, 537, 0.9, 0.17, and 52 mg/kg, respectively. The contamination factors of the 12 analyzed elements ranged from 2.08 to 11.19, indicating pollution levels from suspected contamination to very severe pollution. Aluminum, chromium, manganese, copper, zinc, and lead exhibited very high levels of contamination. Vanadium, iron, and cobalt were found to be moderately polluted, while cadmium and mercury showed slight contamination. Finally, the air in the surveyed areas showed signs of pollution with nickel. Factor analysis was applied to identify the potential emission sources of these elements into the atmosphere. The results indicated that traffic, industrial activities, coal combustion, and urban dust were the primary contributors to the observed elemental emissions.


  • Open Access

    ANALYTICAL PROCEDURES USING SEM/EDX EQUIPMENT FOR DETERMINING HEAVY METALS CONTENTS IN FLY ASH GENEREATED FROM DOMESTIC SOLID WASTE INCINERATORS: A CASESTUDY OF SOCSON WASTE-TO-POWER PLANT IN HANOI

    by Ngo Tra Mai, Khuat Thi Hong, Nguyen Thi Thuy Hang, Nghiem Thi Ha Lien, Van Huu Tap, Phan Thi Thanh Hang, Trinh Thi Tham, Vu Duc Toan, Nguyen Thi Hoa, Nguyen Hung Son, et al.

    The researching and establishing of as process for analyzing fly ash generated from a domestic solid waste treatment plant by SEM/EDX method were investigated. Three sampling series with twelve (12) fly ash samples collected at SocSon waste-to-power plant were used for: (i) analytical procedure establishment; (ii) standardization; and (iii) test analysis. At each measurement, a cross-check with one random sample using XRF method was carried out to verify the accuracy of the SEM/EDX measurements. As a result, a 6-step measurement procedure has been proposed, including: experimental preparation, sample weighting, liquid/solid phase separation, sample drying, sample measurement and data processing. And for procedure adjustment, liquid/solid phase separation were repeated twice while drying time was doubly increased from 24h to 48h to collect ll heavy metal contaminated residues. The proposed procedure could provide results in about 3-5 seconds without any requirement of sample digestion while most of the heavy metalspresent in fly ash, including low-content ones such as Ag, Cd and Cr were simultaneously displayed. The standardized measurement procedure was applied to test the hazardous properties of fly ash by comparing with QCVN 07:2009/BTNMT – National Technical Regulations on Hazardous waste thresholds. The results identified that fly ash could be primarily considered as hazardous waste with 5/14 heavy metal parameters exceed the limit from 1,7 to 9,5 times and needs to be collected and treated properly. This result is also quite similar to the studies that have been done in China, the US or Vietnam. Thus, SEM/EDX method could be used for analyzing heavy metal components in fly ash samples of solid waste treatment plants.


  • Open Access

    Characteristics of fly ash from the municipal solid waste incineration plant in Can Tho

    by Ngo Tra Mai, Van Huu Tap, Phan Thi Thanh Hang, Trinh Thi Tham, Vu Duc Toan, Nguyen Thi Thuy Hang, Khuat Thi Hong, Nghiem Thi Ha Lien, Vu Duong, Do Quang Hoa, et al.

    In this study, 16 seasonal fly ash samples of municipal solid waste incinerator (MSWI) were collected in from waste-to energy power plant Cantho city to analysis the physical properties and heavy metals content. The results showed that the fly ash samples are very alkaline with porous and spherical shape, and the particle size of 1-100 µm. The analytical results disclosed that in these fly ash samples, the Zn, Pb, Al, Fe and Cr metals were found at high content range from 0.36-19.05 mg/kg while the toxic metals Ni and Hg are also found in fly ash, with the content from 0.141 to 0.51 mg/kg. Thus, fly ash is not hazardous waste and can be used for reuse in industries or land reclamation. The analysis results of SEM/EDX and XRF were quite similar with a difference of below 5%, indicating that both methods can be applied to research heavy metals. The findings in this study can guide the management, treatment and reuse of fly ash from MSWI incineration plants in Vietnam.