Savvas Hadjipanteli

Silver selenide (Ag₂Se) is a promising thermoelectric material for near-room-temperature applications, yet its scalable fabrication remains challenging due to limitations in conventional synthesis routes and the strong dependence of its properties on processing conditions. In this work, the pack cementation technique is introduced as a novel cost-effective, and industrially viable route for producing β-Ag₂Se powders. The influence of synthesis parameters on phase formation, composition, and microstructure is examined, and their correlation with thermoelectric behavior is studied to establish clear structure–property relationships. The resulting Ag₂Se is comprehensively evaluated for quality and performance. Phase-pure orthorhombic β-Ag₂Se with near-stoichiometric composition and a uniform microstructure was successfully synthesized, with phase purity preserved after consolidation without secondary phases. The material exhibited competitive thermoelectric performance, achieving a maximum ZT = 0.63 at 352 K and stable operation up to ~375 K. These findings demonstrate that pack cementation can deliver high-quality Ag₂Se with competitive efficiency, highlighting its potential for future optimization and large-scale production.

Mechanical alloying (MA) has been proven to be an energy-efficient synthetic route for the development of high-performance thermoelectric (TE) materials. Higher Manganese Silicide (HMS) phases of the general formula Mn(Si_1−xAl_x)_1.75 (0 ≤ x ≤ 0.05) were prepared by MA implementing a short-time ball-milling process. Powder XRD and SEM analysis were carried out to validate the HMS phases, while small amounts of the secondary phase, MnSi, were also identified, especially for the Al-doped products. Electrical transport properties measurements showed that Al substitution causes an effective hole doping. A remarkable increase in electrical conductivity is observed for the Al-doped phases, while the corresponding reduction in the Seebeck coefficient is indicative of the increase in carrier density. Despite the small percentages of MnSi detected in Al-doped phases, an improvement in TE efficiency is achieved in the series Mn(Si_1−xAl_x)_1.75 (0 ≤ x ≤ 0.05). The 2.5% Al-doped phase exhibits a maximum figure-of-merit (ZT) of 0.43 at 773 K. Moreover, in an effort to utilize recycled silicon byproducts from photovoltaic (PV) manufacturing, Al-doped phases are developed by MA using two types of Si kerf. The two kerf-based products exhibit lower TE efficiencies, due to the increased amounts of the metallic MnSi phase.