Irene Franzetti
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Irene Franzetti has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
Tom Smolinka
2 shared publicationsAi-Lin Chan
Chemical and Material Sciences Center National Renewable Energy Laboratory 15013 Denver West Parkway Golden CO 80401 USA
1 shared publication- André Weber
Institute for Applied Materials—Electrochemical Technologies (IAM-ET), Karlsruhe Institute of Technology (KIT), Karlsruhe, 76131, Germany
1 shared publication Artem Pushkarev
Chemical Energy Storage Fraunhofer Institute for Solar Energy System ISE Heidenhofstrasse 2 D-79110 Freiburg Germany
1 shared publicationCharlotte Menke
1 shared publication- Chenke Dai
Fraunhofer Institute for Solar Energy System ISE, Heidenhofstrasse 2, 79110, Freiburg, Germany
1 shared publication
Latest Publications
- Open Access
- 1 November 2025
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 172 (11) , 114510
Built-In Open Circuit Reference Electrodes in a PEM Water Electrolysis Cell – A Proof of Concept
This study presents a proof of concept for the integration of open circuit reference electrodes (OC-REs) in proton-exchange membrane water electrolysis (PEMWE) cells to understand electrode performance and loss mechanisms, allowing for unequivocal assignment of these losses to anode and cathode. OC-REs, which are non-invasive to cell performance and share the same environment as the working electrodes (WEs), are assessed for stability and reproducibility while their performance is investigated across varying current densities and membrane thicknesses. Results demonstrate the significant impact of hydrogen crossover on the potential of the anode RE, impact that was modeled by calculating a current-density-dependent mixed potential. When comparing half-cell and full-cell polarization, the latter shows significantly higher reproducibility, with proper electrode alignment being crucial to minimize differences in half-cell polarization curves. Conversely, no significant impact from alignment on half-cell electrochemical impedance spectroscopy (EIS) was observed, making this technique the more consistent approach. The half-cell EIS revealed a significant contribution from the cathode to the overall loss, contrary to indications from most studies lacking this half-cell insight. These findings illustrate the potential of OC-REs as effective sensors for assessing electrode contributions, paving the way for future investigations into optimizing PEMWE.
- 1 November 2025
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 172 (11) , 114510
Open AccessBuilt-In Open Circuit Reference Electrodes in a PEM Water Electrolysis Cell – A Proof of Concept
This study presents a proof of concept for the integration of open circuit reference electrodes (OC-REs) in proton-exchange membrane water electrolysis (PEMWE) cells to understand electrode performance and loss mechanisms, allowing for unequivocal assignment of these losses to anode and cathode. OC-REs, which are non-invasive to cell performance and share the same environment as the working electrodes (WEs), are assessed for stability and reproducibility while their performance is investigated across varying current densities and membrane thicknesses. Results demonstrate the significant impact of hydrogen crossover on the potential of the anode RE, impact that was modeled by calculating a current-density-dependent mixed potential. When comparing half-cell and full-cell polarization, the latter shows significantly higher reproducibility, with proper electrode alignment being crucial to minimize differences in half-cell polarization curves. Conversely, no significant impact from alignment on half-cell electrochemical impedance spectroscopy (EIS) was observed, making this technique the more consistent approach. The half-cell EIS revealed a significant contribution from the cathode to the overall loss, contrary to indications from most studies lacking this half-cell insight. These findings illustrate the potential of OC-REs as effective sensors for assessing electrode contributions, paving the way for future investigations into optimizing PEMWE.
- Open Access
- 9 September 2024
- Published by Elsevier in Journal of Power Sources
- Vol. 622
Inductive loops in impedance spectra of PEM water electrolyzers
- 9 September 2024
- Published by Elsevier in Journal of Power Sources
- Vol. 622
Open AccessInductive loops in impedance spectra of PEM water electrolyzers
- Open Access
- 20 June 2023
- Published by Wiley in Energy Technology
- Vol. 11 (12)
Parasitic Effects in Impedance Spectrum of PEM Water Electrolysis Cells: Case Study of High‐Frequency Inductive Effects
Electrochemical impedance spectroscopy (EIS) is a powerful tool to characterize and distinguish electrochemical, electrical, and diffusive processes in an electrolysis cell. The EIS response with small impedance (mΩ) depends on components and materials of the cell, but often also on the electrical setup, cables, and connectors, leading to incorrect conclusions about the performance of the electrolysis cells. These parasitic effects are assessed via a short‐circuit measurement and confirmed to be external from the membrane electrode assembly (MEA). In the setup, the inductive characteristic is described by a modified inductive reactance and must be included in the equivalent circuit model (ECM) which is fitting the cell EIS spectra in operation (in situ). If points of the spectra showing inductive characteristic (belowx‐axis in Nyquist plot) are excluded from the ECM evaluation, an artificially increased ohmic resistance at high frequencies is obtained. In addition, considerations on other components of the ECM can be misleading and significantly incorrect. The only way to avoid that inductive behavior caused by the external setup is incorrectly assigned to the ECM describing properties of the MEA is to include the inductive effects in the ECM analysis of in situ EIS measurements.
- 20 June 2023
- Published by Wiley in Energy Technology
- Vol. 11 (12)
Open AccessParasitic Effects in Impedance Spectrum of PEM Water Electrolysis Cells: Case Study of High‐Frequency Inductive Effects
Electrochemical impedance spectroscopy (EIS) is a powerful tool to characterize and distinguish electrochemical, electrical, and diffusive processes in an electrolysis cell. The EIS response with small impedance (mΩ) depends on components and materials of the cell, but often also on the electrical setup, cables, and connectors, leading to incorrect conclusions about the performance of the electrolysis cells. These parasitic effects are assessed via a short‐circuit measurement and confirmed to be external from the membrane electrode assembly (MEA). In the setup, the inductive characteristic is described by a modified inductive reactance and must be included in the equivalent circuit model (ECM) which is fitting the cell EIS spectra in operation (in situ). If points of the spectra showing inductive characteristic (belowx‐axis in Nyquist plot) are excluded from the ECM evaluation, an artificially increased ohmic resistance at high frequencies is obtained. In addition, considerations on other components of the ECM can be misleading and significantly incorrect. The only way to avoid that inductive behavior caused by the external setup is incorrectly assigned to the ECM describing properties of the MEA is to include the inductive effects in the ECM analysis of in situ EIS measurements.