Jizhong Li
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Jizhong Li has a total of 17 co-authors. Here are the top co-authors by number of shared publications:
- Hua Ding
School of Materials Science and Engineering, Northeastern University, Shenyang 110819, China
2 shared publications Anthony Lochtefeld
Amberwave
1 shared publicationCheryl Major
Amberwave
1 shared publication- Guohua Li
Zhejiang University of Technology
1 shared publication James G. Fiorenza
Amberwave
1 shared publicationJennifer M. Hydrick
Amberwave
1 shared publication
Latest Publications
- Open Access
- 24 August 2023
- Published by Institution of Engineering and Technology (IET) in IET Communications
- Vol. 17 (17) , 1998-2008
Power allocation optimization for hybrid information and energy transfer with massive MIMO downlink
This paper investigates the power allocation in a massive multiple‐input multiple‐output (MIMO) downlink system, where the base station (BS) simultaneously transmits information and energy to information terminals and energy terminals without resorting to any wireless energy harvesting (EH) protocol, respectively. First, with respect to this system, the closed‐form expressions of achievable rate and harvested energy are, respectively, derived for Rayleigh fading channels. Then, from these expressions, three optimization problems are formulated based on quality‐of‐service (QoS) requirements, with the purposes of maximizing achievable sum rate, harvested sum energy and joint QoS requirements, respectively. The optimization problem of maximizing achievable sum rate is transformed into a sequence of geometric programmings (GPs), which can be solved efficiently with standard convex optimization tools. The optimization problem of maximizing harvested sum energy is proved to be solvable as a linear program. The optimization problem of maximizing joint QoS requirements is shown to be a multi‐objective optimization problem (MOOP) and solved by a one‐dimensional search based on GP. Finally, numerical results manifest that the proposed power allocation algorithms can provide good system performances of achievable sum rate and harvested sum energy, and jointly guarantee QoS fairness in terms of achievable rate and harvested energy.
- 24 August 2023
- Published by Institution of Engineering and Technology (IET) in IET Communications
- Vol. 17 (17) , 1998-2008
Open AccessPower allocation optimization for hybrid information and energy transfer with massive MIMO downlink
This paper investigates the power allocation in a massive multiple‐input multiple‐output (MIMO) downlink system, where the base station (BS) simultaneously transmits information and energy to information terminals and energy terminals without resorting to any wireless energy harvesting (EH) protocol, respectively. First, with respect to this system, the closed‐form expressions of achievable rate and harvested energy are, respectively, derived for Rayleigh fading channels. Then, from these expressions, three optimization problems are formulated based on quality‐of‐service (QoS) requirements, with the purposes of maximizing achievable sum rate, harvested sum energy and joint QoS requirements, respectively. The optimization problem of maximizing achievable sum rate is transformed into a sequence of geometric programmings (GPs), which can be solved efficiently with standard convex optimization tools. The optimization problem of maximizing harvested sum energy is proved to be solvable as a linear program. The optimization problem of maximizing joint QoS requirements is shown to be a multi‐objective optimization problem (MOOP) and solved by a one‐dimensional search based on GP. Finally, numerical results manifest that the proposed power allocation algorithms can provide good system performances of achievable sum rate and harvested sum energy, and jointly guarantee QoS fairness in terms of achievable rate and harvested energy.
- 1 September 2019
- Published by Elsevier in Materials Science and Engineering: A
- Vol. 764, 138261
Low-temperature superplastic deformation mechanism in Ti–6Al–4V alloy processed by friction stir processing
- 1 September 2019
- Published by Elsevier in Materials Science and Engineering: A
- Vol. 764, 138261
Low-temperature superplastic deformation mechanism in Ti–6Al–4V alloy processed by friction stir processing
- 1 January 2018
- Published by SAGE Publications in Materials Science and Technology
- Vol. 34 (2) , 153-160
Effects of friction-stir processing with water cooling on the properties of an Al–Zn–Mg–Cu Alloy
An Al–Zn–Mg–Cu (Al-7B04) aluminium alloy in two conditions, i.e. with an artificial aging (7B04-AA) temper and with an annealing (7B04-O) temper, was friction-stir processed using water cooling, and the microstructure and the mechanical properties of the stir zone (SZ) were investigated. Compared with the samples subjected to air cooling, the SZs of water-cooled samples were strengthened, and the degree of strengthening depended on the initial base metal temper. For friction-stir-processed material after an 7B04-O temper, the efficiency of strengthening was relatively high due not only to the refinement of grains and strengthening precipitates but also due to the high solution level in the SZ. In contrast, the slight strengthening of friction-stir-processed 7B04-AA resulted solely from grain refinement.
- 1 January 2018
- Published by SAGE Publications in Materials Science and Technology
- Vol. 34 (2) , 153-160
Effects of friction-stir processing with water cooling on the properties of an Al–Zn–Mg–Cu Alloy
An Al–Zn–Mg–Cu (Al-7B04) aluminium alloy in two conditions, i.e. with an artificial aging (7B04-AA) temper and with an annealing (7B04-O) temper, was friction-stir processed using water cooling, and the microstructure and the mechanical properties of the stir zone (SZ) were investigated. Compared with the samples subjected to air cooling, the SZs of water-cooled samples were strengthened, and the degree of strengthening depended on the initial base metal temper. For friction-stir-processed material after an 7B04-O temper, the efficiency of strengthening was relatively high due not only to the refinement of grains and strengthening precipitates but also due to the high solution level in the SZ. In contrast, the slight strengthening of friction-stir-processed 7B04-AA resulted solely from grain refinement.
- 1 February 2010
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 3, 570-574
Eliminating abnormal positioning bias with translation technology in AGPS method
Abnormal positioning bias were found through the analysis to positioning algorithm in assisted global positioning system (AGPS) with mobile station (MS) clock error. This bias is engendered in the process of calculating the pseudo-range. The translation number of whole chips is determined which is referred to the satellite of maximum angle of elevation relative to the base station (BS). Using this method, the abnormal positioning bias of several hundred kilometers was eliminated.
- 1 February 2010
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 3, 570-574
Eliminating abnormal positioning bias with translation technology in AGPS method
Abnormal positioning bias were found through the analysis to positioning algorithm in assisted global positioning system (AGPS) with mobile station (MS) clock error. This bias is engendered in the process of calculating the pseudo-range. The translation number of whole chips is determined which is referred to the satellite of maximum angle of elevation relative to the base station (BS). Using this method, the abnormal positioning bias of several hundred kilometers was eliminated.
- 6 March 2009
- Published by The Electrochemical Society in ECS Transactions
- Vol. 18 (1) , 887-894
Thin Film InP Epitaxy on Si (001) Using Selective Aspect Ratio Trapping
High quality InP thin films have been demonstrated in SiO2 trenches on silicon via Aspect Ratio Trapping (ART), whereby defects arising from lattice mismatch (~8%) are trapped by laterally confining sidewalls. Double-buffer layers and two-step ART growth processes have been employed to trap vertical threading dislocations originating at InP/Si interface. InP film quality and optical properties have been analyzed using SEM, TEM and room temperature photoluminescence. Full trapping of dislocations has been demonstrated for trenches up to 400 nm in width without the additional formation of defects at the sidewalls above 500 nm initial growth. This approach shows great promise for the integration of III-V materials onto silicon.
- 6 March 2009
- Published by The Electrochemical Society in ECS Transactions
- Vol. 18 (1) , 887-894
Thin Film InP Epitaxy on Si (001) Using Selective Aspect Ratio Trapping
High quality InP thin films have been demonstrated in SiO2 trenches on silicon via Aspect Ratio Trapping (ART), whereby defects arising from lattice mismatch (~8%) are trapped by laterally confining sidewalls. Double-buffer layers and two-step ART growth processes have been employed to trap vertical threading dislocations originating at InP/Si interface. InP film quality and optical properties have been analyzed using SEM, TEM and room temperature photoluminescence. Full trapping of dislocations has been demonstrated for trenches up to 400 nm in width without the additional formation of defects at the sidewalls above 500 nm initial growth. This approach shows great promise for the integration of III-V materials onto silicon.
- 1 May 1990
- Published by Optica Publishing Group in Applied Optics
- Vol. 29 (13) , 1870-1871
Determination of the fast axis with an infrared spectrometer for quartz and mica waveplates
Optics InfoBase is the Optical Society's online library for flagship journals, partnered and copublished journals, and recent proceedings from OSA conferences.
- 1 May 1990
- Published by Optica Publishing Group in Applied Optics
- Vol. 29 (13) , 1870-1871
Determination of the fast axis with an infrared spectrometer for quartz and mica waveplates
Optics InfoBase is the Optical Society's online library for flagship journals, partnered and copublished journals, and recent proceedings from OSA conferences.