ADAgni Dhakal

Agni Dhakal

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Agni Dhakal has a total of 11 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Influence of Land Use and Slope Orientation on Soil Respiration Variations in Relation to Climate Factors in Temperate Zone of Nepal

    by Deepa Dhital, Agni Dhakal

    A comprehensive understanding of soil carbon emissions across different land‐use types, topographies, and slope aspects is still lacking. There is a need to better understand how these emissions via soil respiration (Rs) vary with influencing factors. This is vital for precise carbon estimation and management and plays a crucial role in carbon cycling. Thus, we examined how land‐use types and slope aspects affect soil respiration (Rs) and its response on multiple influencing factors. A closed chamber method with an infrared gas analyzer was employed in this study to measure Rs, recorded soil temperature (Ts), air temperature (Ta), soil water content (Swc), electrical conductivity (Ec), and photosynthetic photon flux density (PPFD) in a grassland (GL), forest on the north‐facing slope (FNF), and forest on the south‐facing slope (FSF) in the Annapurna Conservation Area (ACA) of the temperate zone in Nepal. The results of this study showed that grassland possessed higher Rs at 276.89 mg CO 2 m −2 ·h −1 with Ts and Ta than the FNF at 167.62 mg CO 2 m −2 ·h −1 and FSF at 113.96 mg CO 2 m −2 ·h −1 . Lower Ts and Ta in FNF were recorded compared to FSF. The Swc, Ec, and PPFD were aligned with the variations in Rs in all land‐use types and forests except the temperature and PPFD in the forests of different aspects. Significant statistical variations ( p < 0.05) among land‐use types and slopes were exhibited by Rs, Ts, Ta, Swc, Ec, and PPFD. The results suggested variations in Rs and its influencing factors are impacted by both land‐use types and slope aspects. Accurately estimating carbon budget requires accounting for Swc, Ec, and PPFD, and land‐use types and aspects along with the temperature effect on Rs in high temperate zones.

  • Open Access

    Analysis and Detection of Heavy Metals Content in Some Selected Packaged Fruit Juices of Kathmandu City by Flame Atomic Absorption Spectroscopy

    by Neeta Paudel, Agni Dhakal, Situ Shrestha Pradhanang

    The determination of level of heavy metals in packaged fruit juices is crucial, as extended exposure to even small quantities of these toxic element can cause severe health issues and chronic poisoning. Hence, it is essential to gather comprehensive data on the presence of heavy metals in packaged fruit juice samples. The objective of this research work is to determine heavy metals (Fe, Cu, Zn and Pb) in four different types of packaged fruit juice samples viz Apple, Mango, Orange and Lychee of four different popular brands bought from retail market of Kathmandu city by flame atomic absorption spectroscopy and compare with acceptable limit set by WHO/FAO. Wet acid digestion method was used for digestion process of packaged fruit juice samples. The concentration of Iron were ranged from 0.572-0.762mg/L in Orange juices; 0.362-0.624mg/L in Mango juices; 0.277-3.649mg/L in Apple juices; 0.279-1.770mg/L in Lychee juices respectively. Copper concentration were ranged from not detected (ND)-0.574mg/L in Orange juices; ND for all selected samples in Mango juices; ND- 0.023mg/L in Apple juices; ND-0.041mg/L in Lyclee juices. Similarly Zinc concentration were ranged from 0.0511-0.2026mg/L in Orange juices; ND-0.0700mg/L in Mango juices; ND for all selected samples in Apple juices; ND-0.0287mg/L in Lychee juices. The concentration of hazardous element Lead was found below detection limit in all selected packaged fruit juice samples. The heavy metals concentration in selected brand of packaged fruit juice samples was in following order: Fe>Zn>Cu> Pb. Int. J. Appl. Sci. Biotechnol. Vol 12(3): 158-165.


  • Open Access

    Characterization of Thermostable Cellulase from Bacillus licheniformis PANG L Isolated from the Himalayan Soil

    by Manita Shyaula, Sunil Regmi, Deegendra Khadka, Ram Chandra Poudel, Agni Dhakal, Devesh Koirala, Jaishree Sijapati, Anjana Singh, Jyoti Maharjan

    This study aimed to isolate, purify, and characterize a potential thermophilic cellulase-producing bacterium from the Himalayan soil. Eleven thermophilic bacteria were isolated, and the strain PANG L was found to be the most potent cellulolytic producer. Morphological, physiological, biochemical, and molecular characterization identified PANG L as Bacillus licheniformis. This is the first study on the isolation of thermostable cellulase-producing Bacillus licheniformis from the Himalayan soil. This bacterium was processed for the production of cellulase enzyme. The optimum conditions for cellulase production were achieved at 45C after 48h of incubation at pH 6.5 in media-containing carboxymethyl cellulose (CMC) and yeast extract as carbon and nitrogen sources, respectively, in a thermo-shaker at 100rpm. The enzyme was partially purified by 80 ammonium sulphate precipitation followed by dialysis, resulting in a 1.52-fold purification. The optimal activity of partially purified cellulase was observed at a temperature of 60C and pH 5. The cellulase enzyme was stable within the pH ranges of 35 and retained 67 of activity even at 55C. Cellulase activity was found to be enhanced in the presence of metal ions such as Cd2+, Pb2+, and Ba2+. The enzyme showed the highest activity when CMC was used as a substrate, followed by cellobiose. The Km and Vmax values of the enzyme were 1.8mg/ml and 10.92μg/ml/min, respectively. The cellulase enzyme obtained from Bacillus licheniformis PANG L had suitable catalytic properties for use in industrial applications.