Josef B. Slowik
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Josef B. Slowik has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Alexander Knebel
Otto Schott Institute of Materials Research, Friedrich Schiller University Jena, Jena, Germany
1 shared publication - Ayisha Komal
Friedrich Schiller University Jena
1 shared publication - Dušan Galusek
FunGlass Alexander Dubček University of Trenčín Trenčín Slovakia
1 shared publication - Ingolf Voigt
Fraunhofer Institute for Ceramic Technologies and Systems IKTS Hermsdorf, Michael-Faraday-Straße 1, 07629 Hermsdorf, Germany
1 shared publication - Jose Joaquin Velazquez
FunGlass Alexander Dubček University of Trenčín Trenčín Slovakia
1 shared publication - Lothar Wondraczek
Otto Schott Institute of Materials Research University of Jena Jena Germany
1 shared publication
Latest Publications
- Open Access
- 4 September 2023
- Published by American Chemical Society (ACS) in ChemRxiv
Gas Separating Metal-Organic Framework Membrane Films on Large Area 3D-Printed Tubular Ceramic Scaffolds
Polycrystalline metal-organic framework (MOF) membrane films prepared on ceramic supports can separate gases with high energy efficiency. They generally exhibit very high permeance and selectivity but suffer from cost issues through the required ceramic supports. Increasing the area and reducing the ceramic component to a minimum could be a strategy to enabling neat membrane of MOFs. In a rapid prototyping approach using 3D-printed porous scaffolds with a double helical channel geometry, we dramatically increase the active membrane area-to-volume ratio. Following stereolithographic printing and de-binding of a ceramic slurry, an adapted sintering protocol was employed to sinter commercially available alumina slurries into porous scaffolds. The 3D-printed scaffolds were optimized at a porosity of 40%, with satisfying mechanical stability. Furthermore, synthetic procedures yielding omnidirectional, homogeneous coatings on the outside and inside of the tubular scaffolds were developed. Membrane films of ZIF-8 and HKUST-1 covering a huge 50 cm² membrane area were produced in this way by applying a counter-diffusion methodology. Gas separation performance was evaluated for H2, CO2, N2 and CH4, in single-gas measurements and on their binary gas mixtures.
- 4 September 2023
- Published by American Chemical Society (ACS) in ChemRxiv
Open AccessGas Separating Metal-Organic Framework Membrane Films on Large Area 3D-Printed Tubular Ceramic Scaffolds
Polycrystalline metal-organic framework (MOF) membrane films prepared on ceramic supports can separate gases with high energy efficiency. They generally exhibit very high permeance and selectivity but suffer from cost issues through the required ceramic supports. Increasing the area and reducing the ceramic component to a minimum could be a strategy to enabling neat membrane of MOFs. In a rapid prototyping approach using 3D-printed porous scaffolds with a double helical channel geometry, we dramatically increase the active membrane area-to-volume ratio. Following stereolithographic printing and de-binding of a ceramic slurry, an adapted sintering protocol was employed to sinter commercially available alumina slurries into porous scaffolds. The 3D-printed scaffolds were optimized at a porosity of 40%, with satisfying mechanical stability. Furthermore, synthetic procedures yielding omnidirectional, homogeneous coatings on the outside and inside of the tubular scaffolds were developed. Membrane films of ZIF-8 and HKUST-1 covering a huge 50 cm² membrane area were produced in this way by applying a counter-diffusion methodology. Gas separation performance was evaluated for H2, CO2, N2 and CH4, in single-gas measurements and on their binary gas mixtures.