Ouahiba Bechiri
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Ouahiba Bechiri has a total of 19 co-authors. Here are the top co-authors by number of shared publications:
Mostefa Abbessi
The Laboratory of the Environmental Engineering, Department of Process Engineering, Faculty of Engineering, University of Annaba, Annaba, Algeria
5 shared publicationsNaima Habache
Department of the Process Engineering Faculty of Science and Technology University Mohamed‐Cherif Messaadia Souk Ahras Algeria
3 shared publicationsAbir Tabaï
University of Annaba
2 shared publicationsA Benzidoune
1 shared publicationA Medkour
1 shared publicationAmina Medkour
Faculty of Engineering Sciences, Laboratory of LGE, Department of Process Engineering, UBMA, Annaba, Algeria
1 shared publication
Latest Publications
- 22 October 2026
- Published by Springer Nature in International Journal of Environmental Science and Technology
- Vol. 23 (11) , 705
Electro-Fenton treatment of dye wastewater: process optimization and modeling
- 22 October 2026
- Published by Springer Nature in International Journal of Environmental Science and Technology
- Vol. 23 (11) , 705
Electro-Fenton treatment of dye wastewater: process optimization and modeling
- 7 March 2026
- Published by Wiley in International Journal of Chemical Kinetics
- Vol. 58 (7) , 323-333
Removal of Nitric Acid From Liquid Effluent by the Solvent Extraction Method: Effect of Different Operating Parameters, Kinetic and Thermodynamic Study
This investigation focuses on the liquid‐liquid extraction of nitric acid utilizing various organic solvents, specifically dichloroethane, dichloromethane, and trichloroethylene. The study comprehensively evaluated the impact of several operational parameters, such as solvent concentration, contact time, nitric acid concentration, settling time, the ratio of the organic to aqueous phase (V O /V a ), stirring speed, and temperature on the extraction efficiency. Additionally, thermodynamic and kinetic studies were conducted to gain a deeper insight into the processes involved. The thermodynamic results indicate static system stability, characterized by low, negative ΔS values, suggesting that the organic phase system has achieved equilibrium. Kinetic findings reveal that the extraction rate is predominantly controlled by diffusion through the liquid film. (ΔS° ranging from approximately −12 to −45 J.mol 1− .K 1− depending on the solvent)
- 7 March 2026
- Published by Wiley in International Journal of Chemical Kinetics
- Vol. 58 (7) , 323-333
Removal of Nitric Acid From Liquid Effluent by the Solvent Extraction Method: Effect of Different Operating Parameters, Kinetic and Thermodynamic Study
This investigation focuses on the liquid‐liquid extraction of nitric acid utilizing various organic solvents, specifically dichloroethane, dichloromethane, and trichloroethylene. The study comprehensively evaluated the impact of several operational parameters, such as solvent concentration, contact time, nitric acid concentration, settling time, the ratio of the organic to aqueous phase (V O /V a ), stirring speed, and temperature on the extraction efficiency. Additionally, thermodynamic and kinetic studies were conducted to gain a deeper insight into the processes involved. The thermodynamic results indicate static system stability, characterized by low, negative ΔS values, suggesting that the organic phase system has achieved equilibrium. Kinetic findings reveal that the extraction rate is predominantly controlled by diffusion through the liquid film. (ΔS° ranging from approximately −12 to −45 J.mol 1− .K 1− depending on the solvent)
- 31 August 2023
- Published by Wiley in International Journal of Chemical Kinetics
- Vol. 56 (1) , 30-42
Thermally activated persulfate oxidation of Basic Fuchsin dye: Effect of different operating parameters, kinetic, and thermodynamic study
The present paper aims to investigate the efficiency of thermal activation persulfate in eliminating the organic dye “Basic Fuchsin” (BF). In addition, the study attempts to elucidate the effect of different operating parameters, such as persulfate dosage (0.44–4.4 mM), the initial solution pH of (3–10), and temperature (25–50°C), on the process. The effects of various anions and water matrices on BF discoloration were investigated. Thus, the findings revealed that 94.15% of BF can be eliminated using persulfate at a concentration of 4.4 mM and a temperature equal to 50°C. It occurs under the following operating conditions: oxidation time of 60 min, initial pH equal to 6, the pollutant concentration of 10 ppm, and stirring speed equal to 300 rpm. Furthermore, the kinetic study indicated that the degradation of the BF dye using PS followed a first‐order pattern with rate constants varying within a range of 15.3 × 10−3–43.2 × 10−3 min−1. Based on the Arrhenius equation, the activation energy of the studied process was determined to be 29 kJ mol−1, suggesting that a moderate activation energy is required for BF discoloration. The results of the thermodynamic study confirm that the oxidation process is non‐spontaneous and endothermic. Coexisting inorganic anions delayed BF discoloration to varying degrees, and the inhibitory action followed the following order: carbonate > chloride > sulfate > nitrate. Organic pollutants oxidation by the thermal activation of the persulfate is a simple and effective method for the depollution of waste textile water.
- 31 August 2023
- Published by Wiley in International Journal of Chemical Kinetics
- Vol. 56 (1) , 30-42
Thermally activated persulfate oxidation of Basic Fuchsin dye: Effect of different operating parameters, kinetic, and thermodynamic study
The present paper aims to investigate the efficiency of thermal activation persulfate in eliminating the organic dye “Basic Fuchsin” (BF). In addition, the study attempts to elucidate the effect of different operating parameters, such as persulfate dosage (0.44–4.4 mM), the initial solution pH of (3–10), and temperature (25–50°C), on the process. The effects of various anions and water matrices on BF discoloration were investigated. Thus, the findings revealed that 94.15% of BF can be eliminated using persulfate at a concentration of 4.4 mM and a temperature equal to 50°C. It occurs under the following operating conditions: oxidation time of 60 min, initial pH equal to 6, the pollutant concentration of 10 ppm, and stirring speed equal to 300 rpm. Furthermore, the kinetic study indicated that the degradation of the BF dye using PS followed a first‐order pattern with rate constants varying within a range of 15.3 × 10−3–43.2 × 10−3 min−1. Based on the Arrhenius equation, the activation energy of the studied process was determined to be 29 kJ mol−1, suggesting that a moderate activation energy is required for BF discoloration. The results of the thermodynamic study confirm that the oxidation process is non‐spontaneous and endothermic. Coexisting inorganic anions delayed BF discoloration to varying degrees, and the inhibitory action followed the following order: carbonate > chloride > sulfate > nitrate. Organic pollutants oxidation by the thermal activation of the persulfate is a simple and effective method for the depollution of waste textile water.
- 3 January 2021
- Published by Springer Nature in Arabian Journal for Science and Engineering
- Vol. 46 (7) , 6519-6530
Activation of persulfate by transition substituted Wells-Dawson-type heteropoltungstomolybdates to degrade a toxic dye in aqueous solution
- 3 January 2021
- Published by Springer Nature in Arabian Journal for Science and Engineering
- Vol. 46 (7) , 6519-6530
Activation of persulfate by transition substituted Wells-Dawson-type heteropoltungstomolybdates to degrade a toxic dye in aqueous solution
- 18 February 2020
- Published by Springer Nature in Arabian Journal for Science and Engineering
- Vol. 45 (6) , 4669-4681
Cobalt-Substituted Heteropolyanion: Synthesis, Characterization, and Application to Oxidation of an Organic Dye in an Aqueous Medium
- 18 February 2020
- Published by Springer Nature in Arabian Journal for Science and Engineering
- Vol. 45 (6) , 4669-4681
Cobalt-Substituted Heteropolyanion: Synthesis, Characterization, and Application to Oxidation of an Organic Dye in an Aqueous Medium
- 27 January 2020
- Published by Springer Nature in SN Applied Sciences
- Vol. 2 (2) , 1-11
The vanadium-substituted heteropolytungstate catalyzed oxidation of the organic dye by H2O2 in an aqueous solution
- 27 January 2020
- Published by Springer Nature in SN Applied Sciences
- Vol. 2 (2) , 1-11
The vanadium-substituted heteropolytungstate catalyzed oxidation of the organic dye by H2O2 in an aqueous solution
- Open Access
- 21 March 2017
- Published by Springer Nature in Euro-Mediterranean Journal for Environmental Integration
- Vol. 2 (1) , 8
Study of the degradation of a toxic dye by the catalytic system (H1.5Fe1.5P2W12Mo6O61, 22H2O)/H2O2
- 21 March 2017
- Published by Springer Nature in Euro-Mediterranean Journal for Environmental Integration
- Vol. 2 (1) , 8
Open AccessStudy of the degradation of a toxic dye by the catalytic system (H1.5Fe1.5P2W12Mo6O61, 22H2O)/H2O2
- Open Access
- 21 November 2016
- Published by Springer Nature in International Journal of Industrial Chemistry
- Vol. 8 (1) , 83-89
Degradation of organic dye using a new homogeneous Fenton-like system based on hydrogen peroxide and a recyclable Dawson-type heteropolyanion
- 21 November 2016
- Published by Springer Nature in International Journal of Industrial Chemistry
- Vol. 8 (1) , 83-89
Open AccessDegradation of organic dye using a new homogeneous Fenton-like system based on hydrogen peroxide and a recyclable Dawson-type heteropolyanion