Alexander Pavlov
Alexander Pavlov has a total of 64 co-authors. Here are the top co-authors by number of shared publications:
- Rustam Khabibullin
V.G. Mokerov Institute of Ultra High Frequency Semiconductor Electronics of RAS
6 shared publications - Rinat R. Galiev
Mokerov Institute of Ultrahigh Frequency Semiconductor Electronics 1 , Moscow 117105
5 shared publications - Eduard I. Moiseev
National Research University Higher School of Economics, St. Petersburg, Russia
4 shared publications - Ivan Sergeevich Makhov
HSE University, Saint Petersburg, Russia
4 shared publications - Konstantin A. Ivanov
National Research University Higher School of Economics, Saint Petersburg, Russia
3 shared publications - Natalia V. Kryzhanovskaya
National Research University Higher School of Economics, Saint Petersburg, Russia
3 shared publications
Latest Publications
- Open Access
- 3 October 2026
- Published by Elsevier in SSRN Electronic Journal
High-Q limaçon-shaped microcavity lasers with InGaAs/GaAs quantum dots
We report high-efficiency and compact semiconductor microcavity lasers with limaçon-shaped geometry operating in continuous-wave mode. The lasers, with radii (r0) ranging from 10 to 25 μm, were formed using a p-i-n heterostructure with an active region based on high-density InGaAs/GaAs quantum dot array, emit at a wavelength near 1080 nm at room temperature. Using smooth cavity deformation with a deformation factor up to ε = 0.46, we achieved directional emission output in the plane of the cavity. Single-mode lasing with an output power of up to 2 mW, limited by the laser self-heating effect, is demonstrated for a laser with a radius of r0 = 10 μm. For larger lasers (r0 = 25 μm), operating in multimode regime, an output power reaches 10 mW. The resonator maintains a high Q of 2×10^(6), enabling a laser linewidth of 150 MHz. The obtained results demonstrate the potential of such microlasers as highly stable and energy-efficient radiation sources suitable for integration into modern photonic circuits.
- 3 October 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessHigh-Q limaçon-shaped microcavity lasers with InGaAs/GaAs quantum dots
We report high-efficiency and compact semiconductor microcavity lasers with limaçon-shaped geometry operating in continuous-wave mode. The lasers, with radii (r0) ranging from 10 to 25 μm, were formed using a p-i-n heterostructure with an active region based on high-density InGaAs/GaAs quantum dot array, emit at a wavelength near 1080 nm at room temperature. Using smooth cavity deformation with a deformation factor up to ε = 0.46, we achieved directional emission output in the plane of the cavity. Single-mode lasing with an output power of up to 2 mW, limited by the laser self-heating effect, is demonstrated for a laser with a radius of r0 = 10 μm. For larger lasers (r0 = 25 μm), operating in multimode regime, an output power reaches 10 mW. The resonator maintains a high Q of 2×10^(6), enabling a laser linewidth of 150 MHz. The obtained results demonstrate the potential of such microlasers as highly stable and energy-efficient radiation sources suitable for integration into modern photonic circuits.
- 18 December 2024
- Published by Elsevier in Optics & Laser Technology
- Vol. 183
Far-field patterns and lasing threshold of limaçon − and quadrupole-shaped microlasers with InGaAs quantum well-dots
- 18 December 2024
- Published by Elsevier in Optics & Laser Technology
- Vol. 183
Far-field patterns and lasing threshold of limaçon − and quadrupole-shaped microlasers with InGaAs quantum well-dots
- Open Access
- 20 November 2024
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 136 (19)
Continuous-wave two-photon terahertz quantum cascade laser
We report on the implementation of a terahertz two-photon quantum cascade laser operating in a continuous wave mode. Lasers that can emit two photons as a result of the relaxation of a single electron between two states of the same parity have been discussed since the early days of the laser era, but implementation has been hampered by the lack of a suitable gain medium. The semiconductor structure of a quantum cascade laser seems to be an ideal medium for realizing such two-photon emission. Our work demonstrates dual-band laser radiation in the range of 3.1–3.9 THz (104–130 cm−1) at temperatures up to 90 K.
- 20 November 2024
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 136 (19)
Open AccessContinuous-wave two-photon terahertz quantum cascade laser
We report on the implementation of a terahertz two-photon quantum cascade laser operating in a continuous wave mode. Lasers that can emit two photons as a result of the relaxation of a single electron between two states of the same parity have been discussed since the early days of the laser era, but implementation has been hampered by the lack of a suitable gain medium. The semiconductor structure of a quantum cascade laser seems to be an ideal medium for realizing such two-photon emission. Our work demonstrates dual-band laser radiation in the range of 3.1–3.9 THz (104–130 cm−1) at temperatures up to 90 K.
- 2 November 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-4
Output Characteristics of III-V Quantum Dot Injection Microdisk Lasers
Semiconductor microdisk lasers developed using III-V epitaxial materials are widely studied during the last decade due to the bright prospectives coming from high quality circular cavity. The threshold and spectral characteristics of microlasers have been studied in sufficient detail, but the issue of the output power of such lasers has not been addressed, just as the features of the light-current characteristics have been poorly studied. The complexity of this issue is associated with the high Q factor of the disk resonator, and therefore the low level of radiative loss. In addition, the peculiarities of the farfield radiation pattern of a disk laser make the usual methods to measure light-current dependences incomplete, in which part of the information about the microlaser radiation is lost due to the fact that the laser radiation has a complex nature in the lateral and vertical directions. In this work, we provide a comprehensive overview on the main parameters influencing output power and efficiency progress of III-V quantum dot injection microdisk lasers. We discuss fundamental concepts related to the output power limitations in the quantum dot disk lasers. We demonstrate improving of the far-field diagram of disk lasers with small deviation of the cavity shape from circular. Limaçon-shaped microlasers were used to increase output power and wall-plug efficiency. We also summarize methods to control the output power and to improve thermal characteristics of a small disk lasers.
- 2 November 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-4
Output Characteristics of III-V Quantum Dot Injection Microdisk Lasers
Semiconductor microdisk lasers developed using III-V epitaxial materials are widely studied during the last decade due to the bright prospectives coming from high quality circular cavity. The threshold and spectral characteristics of microlasers have been studied in sufficient detail, but the issue of the output power of such lasers has not been addressed, just as the features of the light-current characteristics have been poorly studied. The complexity of this issue is associated with the high Q factor of the disk resonator, and therefore the low level of radiative loss. In addition, the peculiarities of the farfield radiation pattern of a disk laser make the usual methods to measure light-current dependences incomplete, in which part of the information about the microlaser radiation is lost due to the fact that the laser radiation has a complex nature in the lateral and vertical directions. In this work, we provide a comprehensive overview on the main parameters influencing output power and efficiency progress of III-V quantum dot injection microdisk lasers. We discuss fundamental concepts related to the output power limitations in the quantum dot disk lasers. We demonstrate improving of the far-field diagram of disk lasers with small deviation of the cavity shape from circular. Limaçon-shaped microlasers were used to increase output power and wall-plug efficiency. We also summarize methods to control the output power and to improve thermal characteristics of a small disk lasers.
- Open Access
- 1 December 2023
- Published by Pleiades Publishing Ltd in Technical Physics Letters
- Vol. 49 (S3) , S159-S162
3.8 THz Quantum Cascade Laser Grown by Metalorganic Vapor Phase Epitaxy
We have demonstrated a quantum cascade laser (QCL) with a generation frequency of about 3.8 THz, grown by metal-organic vapor phase epitaxy. The multilayer heterostructure for QCLs consists of 185 repetitions of an active module containing four GaAs/Al0.15Ga0.85As quantum wells. The threshold current and threshold voltage of the fabricated QCL were 2.25 kA/cm2 and 19.7 V, respectively. The QCL oscillations were carried out in the multimode regime, and the detection of terahertz radiation continued with an increase in the laser temperature up to 60 K.
- 1 December 2023
- Published by Pleiades Publishing Ltd in Technical Physics Letters
- Vol. 49 (S3) , S159-S162
Open Access3.8 THz Quantum Cascade Laser Grown by Metalorganic Vapor Phase Epitaxy
We have demonstrated a quantum cascade laser (QCL) with a generation frequency of about 3.8 THz, grown by metal-organic vapor phase epitaxy. The multilayer heterostructure for QCLs consists of 185 repetitions of an active module containing four GaAs/Al0.15Ga0.85As quantum wells. The threshold current and threshold voltage of the fabricated QCL were 2.25 kA/cm2 and 19.7 V, respectively. The QCL oscillations were carried out in the multimode regime, and the detection of terahertz radiation continued with an increase in the laser temperature up to 60 K.
- 11 September 2023
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 134 (10)
III–V microdisk lasers coupled to planar waveguides
We report on InGaAs/GaAs quantum dot injection microdisk lasers laterally connected with a bus waveguide fabricated by planar technology from the same epi-structure. Various coupling schemes of microlaser with waveguide are studied including a microlaser attached to a waveguide (zero gap), a 100 nm gap for evanescence light outcoupling, and with a waveguide surrounding the resonator. The modes outcoupling and microlaser's loss (Q-factor) are analyzed by simulation of the lasers. A strong decrease in the number of the microdisk resonance lines associated with an increase in loss in the resonator due to the coupling with waveguide is observed in modeling and experimentally. We study the spectral and lasing parameters of the microdisk lasers, as well as characteristics of the outcoupled emission, and demonstrate efficient light outcoupling for 30 and 40 μm diameter continuous wave operating microdisk laser up to 96 °C.
- 11 September 2023
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 134 (10)
III–V microdisk lasers coupled to planar waveguides
We report on InGaAs/GaAs quantum dot injection microdisk lasers laterally connected with a bus waveguide fabricated by planar technology from the same epi-structure. Various coupling schemes of microlaser with waveguide are studied including a microlaser attached to a waveguide (zero gap), a 100 nm gap for evanescence light outcoupling, and with a waveguide surrounding the resonator. The modes outcoupling and microlaser's loss (Q-factor) are analyzed by simulation of the lasers. A strong decrease in the number of the microdisk resonance lines associated with an increase in loss in the resonator due to the coupling with waveguide is observed in modeling and experimentally. We study the spectral and lasing parameters of the microdisk lasers, as well as characteristics of the outcoupled emission, and demonstrate efficient light outcoupling for 30 and 40 μm diameter continuous wave operating microdisk laser up to 96 °C.
- 21 April 2017
- Published by Pleiades Publishing Ltd in Semiconductors
- Vol. 51 (4) , 438-443
Alloyed Si/Al-based ohmic contacts to AlGaN/GaN nitride heterostructures
For the first time in Russia, the Si/Al/Ti/Au alloyed contact composition is investigated for the formation of ohmic contacts to AlGaN/GaN heterostructures using thermal annealing. The obtained results are compared with those for conventional Ti/Al/Ni/Au ohmic contacts. Use of the composition under investigation makes it possible to decrease the annealing temperature to 675–700°C, which results in improvement in the morphology of alloyed ohmic contacts in comparison with conventional contacts. The value of the contact resistance using the Si/Al-based composition to the AlGaN/GaN heterostructure is obtained in relation to the temperature and annealing duration. It is shown that no qualitative change in the resistance occurs at an annealing duration of several minutes in the temperature range of 700–750°C. In the temperature range of 675–700°C, there is an asymptotic decrease in the contact resistance with increasing annealing duration. The smallest value of the contact resistance amounts to 0.41 Ω mm.
- 21 April 2017
- Published by Pleiades Publishing Ltd in Semiconductors
- Vol. 51 (4) , 438-443
Alloyed Si/Al-based ohmic contacts to AlGaN/GaN nitride heterostructures
For the first time in Russia, the Si/Al/Ti/Au alloyed contact composition is investigated for the formation of ohmic contacts to AlGaN/GaN heterostructures using thermal annealing. The obtained results are compared with those for conventional Ti/Al/Ni/Au ohmic contacts. Use of the composition under investigation makes it possible to decrease the annealing temperature to 675–700°C, which results in improvement in the morphology of alloyed ohmic contacts in comparison with conventional contacts. The value of the contact resistance using the Si/Al-based composition to the AlGaN/GaN heterostructure is obtained in relation to the temperature and annealing duration. It is shown that no qualitative change in the resistance occurs at an annealing duration of several minutes in the temperature range of 700–750°C. In the temperature range of 675–700°C, there is an asymptotic decrease in the contact resistance with increasing annealing duration. The smallest value of the contact resistance amounts to 0.41 Ω mm.