Alexandre Bois-Brochu
Research Interests
Alexandre Bois-Brochu has a total of 3 co-authors. Here are the top co-authors by number of shared publications:
- Julie Lévesque
Québec Metallurgy, Center Trois-Rivières, Québec, Canada
1 shared publication - Maxime Croteau
Québec Metallurgy Center, Trois-Rivières, QC G9A 5E1, Canada
1 shared publication - Théo Ouellet
Québec Metallurgy Center, Trois-Rivières, QC G9A 5E1, Canada
1 shared publication
Latest Publications
- Open Access
- 13 September 2023
- Published by MDPI AG in Engineering Proceedings
- Vol. 43 (1) , 16
Wire Arc Additive Manufacturing of Aluminium Alloys
Additive manufacturing is used to produce parts with complex near-net shape geometries. It can also be used to repair parts that have worn out in service using specific processes such as Wire Arc Additive Manufacturing (WAAM) and Directed Energy Deposition (DED). Wire additive manufacturing processes allow for relatively high deposition rates compared to powder technologies but necessitate a stable welding process and a controlled heat input. As the perfect transfer mode for low welding energy and low spatter, Cold Metal Transfer (CMT) is the process of choice for WAAM. In this project, parts made from aluminium 4943 and 6061 were additively manufactured using CMT technology. The deposition rate, porosity level, and mechanical properties are discussed herein. For the 6061 alloy, after heat treatment, it is possible to attain properties that are close to those obtained for T6 for wrought products or even higher when samples are hot-isostatically pressed.
- 13 September 2023
- Published by MDPI AG in Engineering Proceedings
- Vol. 43 (1) , 16
Open AccessWire Arc Additive Manufacturing of Aluminium Alloys
Additive manufacturing is used to produce parts with complex near-net shape geometries. It can also be used to repair parts that have worn out in service using specific processes such as Wire Arc Additive Manufacturing (WAAM) and Directed Energy Deposition (DED). Wire additive manufacturing processes allow for relatively high deposition rates compared to powder technologies but necessitate a stable welding process and a controlled heat input. As the perfect transfer mode for low welding energy and low spatter, Cold Metal Transfer (CMT) is the process of choice for WAAM. In this project, parts made from aluminium 4943 and 6061 were additively manufactured using CMT technology. The deposition rate, porosity level, and mechanical properties are discussed herein. For the 6061 alloy, after heat treatment, it is possible to attain properties that are close to those obtained for T6 for wrought products or even higher when samples are hot-isostatically pressed.