CGChristiane Groher

Christiane Groher

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Christiane Groher has a total of 16 co-authors. Here are the top co-authors by number of shared publications:

  • Andreas Mautner

    Institute of Environmental Biotechnology, Department of Agricultural Sciences, BOKU University Vienna, Konrad-Lorenz-Straße 20, 3430 Tulln a.d. Donau, Austria; Polymer & Composite Engineering (PaCE) Group, Institute of Materials Chemistry and Research, University of Vienna, Währinger Straße 42, 1090 Vienna, Austria

    1 shared publication
  • Carla Santana Santos

    Analytical Chemistry- Center for Electrochemical Sciences (CES) Faculty of Chemistry and Biochemistry Ruhr University Bochum Universitätsstraße. 150 44780 Bochum Germany

    1 shared publication
  • Damian Marlon Cupid

    Austrian Institute of Technology GmbH

    1 shared publication
  • Damian Marlon Cupid

    Center for Transport Technologies, AIT Austrian Institute of Technology GmbH, Giefinggasse 4, 1210 Vienna, Austria

    1 shared publication
  • Edgar Ventosa

    International Research Centre in Critical Raw Materials-ICCRAM University of Burgos Plaza Misael Bañuelos s/n E-09001 Burgos Spain

    1 shared publication
  • Erwin Rosenberg

    Vienna University of Technology

    1 shared publication

Latest Publications

  • Open Access

    Investigating the Multifunctional Role of Tris(trimethylsilyl)phosphite as an Electrolyte Additive via Operando Gas Chromatography/Mass Spectrometry and X‐ray Photoelectron Spectroscopy

    by Christiane Groher, Damian Marlon Cupid, Qixiang Jiang, Erwin Rosenberg, Jürgen Kahr

    The multifunctional electrolyte additive tris(trimethylsilyl)phosphite (TMSP) is investigated with a combination of operando gas chromatography/mass spectrometry and X‐ray photoelectron spectroscopy techniques, supported by cycling experiments and electrochemical impedance spectroscopy (EIS) measurements. Indications for hydrofluoric acid (HF) scavenging by TMSP could be found in the gas phase as well as on the electrode surfaces; however, it is observed that the use of TMSP leads to the production of HF, which it eventually scavenges. The investigation of the interphase formation shows that the decomposition products of TMSP are integrated into the interphases of both electrodes. This is accompanied by the formation of trimethylsilane as a decomposition product in the gas phase. TMSP also promotes the two‐electron reduction of ethylene carbonate (EC), which is deduced both from an increased amount of ethene in the gas phase and from Li2CO3 on the electrode surface. The electrochemical investigations show that cells with TMSP have a lower interphase resistance after continued cycling. However, only the cells with 1 wt% of TMSP in the electrolyte outperform the TMSP‐free reference cells. It is concluded that adding more than 1 wt% of TMSP increases the parasitic reactions of the additive to an extent that it partially counteracts its beneficial effect.


  • Open Access

    Unveiling the electronic properties of native solid electrolyte interphase layers on Mg metal electrodes using local electrochemistry

    by Carla Santana Santos, Martina Romio, Yuri Surace, Nicolas Eshraghi, Marco Amores, Andreas Mautner, Christiane Groher, Marcus Jahn, Edgar Ventosa, Wolfgang Schuhmann

    Native solid electrolyte interphases (n-SEI) of magnesium ion batteries were systematically formed using different electrolyte compositions, and the electronic and ionic properties were interrogated using scanning electrochemical microscopy (SECM) complemented by electrochemical impedance spectroscopy and ex situ analysis for chemical composition characterization.


  • Investigation of Gas Evolution by Operando GC/MS from SEI Forming Additives in Lithium-Ion-Batteries

    by Christiane Groher, Damian Marlon Cupid, Erwin Rosenberg, Juergen Kahr

    Due to the chemical reactivity of the electrolyte, electrolyte decomposition often occurs at the electrode-electrolyte interface during cycling, which can lead to a loss in LIB performance. On the anode side, however, the formation of a stable Solid Electrolyte Interphase (SEI) is essential for the safe operation of Lithium-ion batteries (LIBs). The SEI layer, which is permeable for Li+ ions, protects the electroactive materials from direct contact with the electrolyte, thereby inhibiting further electrolyte decomposition. In the formation cycles of fresh cells, electrolyte degradation is primarily attributed to the SEI formation processes at the anode. Several literature reports have confirmed that the newly formed interphase consists of organic and inorganic decomposition products of the electrolyte.1 To increase battery performance, cycle life and safety, it is essential to form a stable SEI.2 A common strategy to stabilize the SEI is to use additives in the electrolyte composition. The additives should exhibit higher reduction potentials than other electrolyte components to enable preferential reduction and incorporation into the SEI. The most common SEI forming additives are fluoroethylene carbonate (FEC) and vinylene carbonate (VC). They both decompose during the formation cycle to form a polymeric layer at the electrode surface. The electrolyte decomposition reactions which lead to SEI formation are usually accompanied by gaseous side products. The evolving gas species form a complex gas mixture which can be separated by gas chromatography (GC) into their individual components and subsequently identified by mass spectrometry (MS). While operando GC/MS gives information on the volatile side products of the electrolyte decomposition reactions, X-ray photoelectron spectroscopy (XPS) can be used to identify the degradation products that form on the surface of the electrode and are incorporated into the SEI. The combination of the two techniques allows a more comprehensive picture of SEI formation processes to be drawn. In this work, operando GC/MS of Lithium-ion full cells with NMC 811 cathodes and graphite anodes was used to compare the gas species evolving during the formation reactions in an electrolyte with the composition of 1M LiPF6 in EC/DEC 1:1 with FEC and VC electrolyte additives in a ratio of 1w%, respectively. In a comparative study we present the decomposition pathways of the electrolytes with and without SEI forming additives by analysing the composition of the gas phase as a function of cell potential. We observe that the complex gas mixture consists of carbonate components originating from transesterification reactions and evaporation of the volatile electrolyte. In addition, inorganic components such as carbon monoxide and carbon dioxide are produced, which mainly stem from the degradation of cyclic carbonates. Furthermore, the gas phase consists of saturated and unsaturated hydrocarbons which can be ascribed to the linear carbonate components as well as ether and carbonyl components. We have also observed that it is possible to distinguish between volatile compounds which form during the charge and discharge processes, respectively. The increased gas evolution at the beginning of the formation cycle confirms that a substantial part of the passivation layer is formed during charge. Finally, operando GC/MS was also used to monitor the evolution of the decomposition products during battery operation at overcharge conditions. Acknowledgement: The author gratefully acknowledges the FFG (Austrian Research Promotion Agency) for funding this research within project No. 879613 References: Verma, P., Maire, P. & Novák, P. A review of the features and analyses of the solid electrolyte interphase in Li-ion batteries. Electrochim. Acta 55, 6332–6341 (2010). Qian, Y. et al. Investigations on the electrochemical decomposition of the electrolyte additive vinylene carbonate in Li metal half cells and lithium ion full cells. J. Power Sources 332, 60–71 (2016).