Sho Nagai
Sho Nagai has a total of 20 co-authors. Here are the top co-authors by number of shared publications:
Yasuo Hayashi
AGC Inc.
7 shared publications- Hiroharu Yui
Department of Chemistry, Faculty of Science, Tokyo University of Science, Tokyo, Japan
4 shared publications Keishi Tsukiyama
3 shared publications- Keisuke Nakao2 shared publications
- Shu‐Hei Urashima
Nuclear Science and Engineering Center, Japan Atomic Energy Agency (JAEA), Tokai, Ibaraki 319-1195, JAPAN
2 shared publications Atsushi Saito
Innovative Technology Laboratories
1 shared publication
Latest Publications
- Open Access
- 13 October 2026
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 130 (42) , 14649-14659
Water Adsorption on SiO2 Surfaces Functionalized with −OH, −NH2, and −F Groups by Plasma Treatments
Understanding water adsorption on SiO2 surfaces is crucial for controlling the electrostatic resistivity of glass surfaces and suppressing their electrostatic discharge. In the present study, we investigated the water adsorption behavior of SiO2 surfaces processed using H2O, NH3, and CF4 plasmas. SiO2 surfaces treated with NH3 plasma exhibited the highest water adsorption, followed by the H2O and CF4 plasma-treated surfaces. Since no correlation was observed between the functional group density and the amount of adsorbed water after various plasma treatments, the observed variation in water adsorption can be mainly attributed to the types of functional groups. X-ray photoelectron spectroscopy revealed that the NH3 and CF4 plasma treatments partially replaced surface Si–OH groups with Si–NH2 and Si–F groups, respectively. Density functional theory calculations demonstrated that the partial replacement of Si–OH groups by Si–NH2 groups enhanced the bond polarity of the coexisting Si–OH groups. Water adsorption energy analysis revealed that water molecules were most stable when interacting with both Si–NH2 and Si–OH groups, whereas they were least stable when interacting with both Si–F and Si–OH groups. Finally, we demonstrated that the resistivity of SiO2 glass can be controlled through functional group modification.
- 13 October 2026
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 130 (42) , 14649-14659
Open AccessWater Adsorption on SiO2 Surfaces Functionalized with −OH, −NH2, and −F Groups by Plasma Treatments
Understanding water adsorption on SiO2 surfaces is crucial for controlling the electrostatic resistivity of glass surfaces and suppressing their electrostatic discharge. In the present study, we investigated the water adsorption behavior of SiO2 surfaces processed using H2O, NH3, and CF4 plasmas. SiO2 surfaces treated with NH3 plasma exhibited the highest water adsorption, followed by the H2O and CF4 plasma-treated surfaces. Since no correlation was observed between the functional group density and the amount of adsorbed water after various plasma treatments, the observed variation in water adsorption can be mainly attributed to the types of functional groups. X-ray photoelectron spectroscopy revealed that the NH3 and CF4 plasma treatments partially replaced surface Si–OH groups with Si–NH2 and Si–F groups, respectively. Density functional theory calculations demonstrated that the partial replacement of Si–OH groups by Si–NH2 groups enhanced the bond polarity of the coexisting Si–OH groups. Water adsorption energy analysis revealed that water molecules were most stable when interacting with both Si–NH2 and Si–OH groups, whereas they were least stable when interacting with both Si–F and Si–OH groups. Finally, we demonstrated that the resistivity of SiO2 glass can be controlled through functional group modification.
- Open Access
- 1 October 2026
- Published by Elsevier in SSRN Electronic Journal
Glass-composition dependence of adhesion between electrolessly deposited Cu films and glass substrates: Synergistic roles of Al and alkaline-earth species
Glass substrates are promising for advanced semiconductor packaging, but reliable copper (Cu) adhesion remains challenging for through-glass-via metallization. We investigated the effect of glass composition on adhesion produced by electroless Cu plating using a sensitization–activation process that forms a SnO₂-containing interlayer. Peel testing of bulk glasses and composition-controlled sputtered model-glass films showed that alkali-free aluminosilicate glass had higher adhesion than fused silica and borosilicate glass. Neither Al₂O₃ nor alkaline-earth metal oxides alone produced strong adhesion, whereas their coexistence produced a synergistic effect. Adhesion did not correlate solely with non-bridging oxygen concentration or with the amounts of adsorbed Sn and Pd. Scanning transmission electron microscopy with energy-dispersive X-ray spectroscopy (STEM–EDX) showed no detectable long-range migration of glass constituents into the interlayer. X-ray photoelectron spectroscopy (XPS) revealed annealing-induced changes in the local environment of alkaline-earth species, but similar Mg changes occurred in low-adhesion SiO₂–MgO model glasses. Thus, alkaline-earth modification alone is insufficient. Local structural environments involving both Al and alkaline-earth species are key to forming a high-adhesion interface, providing compositional guidance for glass design in advanced packaging.
- 1 October 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessGlass-composition dependence of adhesion between electrolessly deposited Cu films and glass substrates: Synergistic roles of Al and alkaline-earth species
Glass substrates are promising for advanced semiconductor packaging, but reliable copper (Cu) adhesion remains challenging for through-glass-via metallization. We investigated the effect of glass composition on adhesion produced by electroless Cu plating using a sensitization–activation process that forms a SnO₂-containing interlayer. Peel testing of bulk glasses and composition-controlled sputtered model-glass films showed that alkali-free aluminosilicate glass had higher adhesion than fused silica and borosilicate glass. Neither Al₂O₃ nor alkaline-earth metal oxides alone produced strong adhesion, whereas their coexistence produced a synergistic effect. Adhesion did not correlate solely with non-bridging oxygen concentration or with the amounts of adsorbed Sn and Pd. Scanning transmission electron microscopy with energy-dispersive X-ray spectroscopy (STEM–EDX) showed no detectable long-range migration of glass constituents into the interlayer. X-ray photoelectron spectroscopy (XPS) revealed annealing-induced changes in the local environment of alkaline-earth species, but similar Mg changes occurred in low-adhesion SiO₂–MgO model glasses. Thus, alkaline-earth modification alone is insufficient. Local structural environments involving both Al and alkaline-earth species are key to forming a high-adhesion interface, providing compositional guidance for glass design in advanced packaging.
- Open Access
- 14 November 2025
- Published by Elsevier in Applied Surface Science
- Vol. 720
Composition-dependent low-temperature bonding reactivity in multicomponent silicate glasses
- 14 November 2025
- Published by Elsevier in Applied Surface Science
- Vol. 720
Open AccessComposition-dependent low-temperature bonding reactivity in multicomponent silicate glasses
- Open Access
- 16 August 2025
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 17 (34) , 48932-48940
Damage-Free Vertical Microfabrication of α-Quartz via HF Gas-Phase Catalyst Etching
Vertical microfabrication of α-quartz is typically performed via reactive-ion etching; however, ion irradiation from a plasma source etches the hard mask and disrupts the crystal structure of the etched surface. Thus, the microstructures fabricated via the conventional process have limitations in terms of the taper angle, depth, and crystallinity, which limits technological innovation in quartz devices. In this study, we introduce a plasma-free gas-phase catalyst etching for α-quartz using HF gas and a patterned photoresist as a catalyst. This method realizes vertical etching without depth limitations, regardless of the crystal orientations because the etching reaction in the catalyst contact area on the quartz is dominant over the crystal anisotropy. Therefore, high-aspect-ratio deep microstructures were fabricated on the α-quartz without forming damage layers, e.g., amorphization or chemical-state changes. Our findings may lead to inventions in material and device design using microfabricated α-quartz.
- 16 August 2025
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 17 (34) , 48932-48940
Open AccessDamage-Free Vertical Microfabrication of α-Quartz via HF Gas-Phase Catalyst Etching
Vertical microfabrication of α-quartz is typically performed via reactive-ion etching; however, ion irradiation from a plasma source etches the hard mask and disrupts the crystal structure of the etched surface. Thus, the microstructures fabricated via the conventional process have limitations in terms of the taper angle, depth, and crystallinity, which limits technological innovation in quartz devices. In this study, we introduce a plasma-free gas-phase catalyst etching for α-quartz using HF gas and a patterned photoresist as a catalyst. This method realizes vertical etching without depth limitations, regardless of the crystal orientations because the etching reaction in the catalyst contact area on the quartz is dominant over the crystal anisotropy. Therefore, high-aspect-ratio deep microstructures were fabricated on the α-quartz without forming damage layers, e.g., amorphization or chemical-state changes. Our findings may lead to inventions in material and device design using microfabricated α-quartz.
- Open Access
- 7 December 2024
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 128 (50) , 21399-21407
Direct Bonding of Amino-Modified Silica and Metal Oxides: Condensation Reactivity Explained by Acidity/Basicity of Metal-Hydroxyl Groups
- 7 December 2024
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 128 (50) , 21399-21407
Open AccessDirect Bonding of Amino-Modified Silica and Metal Oxides: Condensation Reactivity Explained by Acidity/Basicity of Metal-Hydroxyl Groups
- 18 January 2024
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 107 (5) , 2877-2887
Low‐temperature bonding of glasses: The role of plasma‐engrafted surface amino groups
Low‐temperature (<∼200°C) bonding of glasses is a key technology for utilizing them for microfluidics, optical applications, and microelectromechanical systems. In the present study, bonding strength of SiO 2 glasses was examined for those after several surface treatment methods. As a result, it was found that two‐step (H 2 O→ NH 3 ) plasma treatment remarkably strengthened the bonding strength (>1 J/m 2 ) at the annealing temperature of 150°C. The improvement was achieved even when only one side of the bonded surfaces was plasma‐treated. X‐ray photoelectron spectroscopy revealed that the two‐step plasma treatment generated Si–NH 2 groups on the topmost surface. Upon the annealing (2 was desorbed from the bonded interface, indicating that the Si–NH 2 effectively reacted with Si–OH on the other side to form Si–O–Si covalent bonds. This study contributes to understanding of the role of surface functional groups for bonding reaction. Furthermore, the method proposed here would be promising as a production technology because it enables glass bonding at lower temperatures with a simple plasma system.
- 18 January 2024
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 107 (5) , 2877-2887
Low‐temperature bonding of glasses: The role of plasma‐engrafted surface amino groups
Low‐temperature (<∼200°C) bonding of glasses is a key technology for utilizing them for microfluidics, optical applications, and microelectromechanical systems. In the present study, bonding strength of SiO 2 glasses was examined for those after several surface treatment methods. As a result, it was found that two‐step (H 2 O→ NH 3 ) plasma treatment remarkably strengthened the bonding strength (>1 J/m 2 ) at the annealing temperature of 150°C. The improvement was achieved even when only one side of the bonded surfaces was plasma‐treated. X‐ray photoelectron spectroscopy revealed that the two‐step plasma treatment generated Si–NH 2 groups on the topmost surface. Upon the annealing (2 was desorbed from the bonded interface, indicating that the Si–NH 2 effectively reacted with Si–OH on the other side to form Si–O–Si covalent bonds. This study contributes to understanding of the role of surface functional groups for bonding reaction. Furthermore, the method proposed here would be promising as a production technology because it enables glass bonding at lower temperatures with a simple plasma system.
- Open Access
- 11 September 2023
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 127 (38) , 19055-19063
Structural Anomality of the Adsorbed Water on Al-Doped Silica Revealed by Heterodyne-Detected Vibrational Sum-Frequency Generation Spectroscopy
- 11 September 2023
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 127 (38) , 19055-19063
Open AccessStructural Anomality of the Adsorbed Water on Al-Doped Silica Revealed by Heterodyne-Detected Vibrational Sum-Frequency Generation Spectroscopy