Yoshihiro Shimizu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Yoshihiro Shimizu has a total of 40 co-authors. Here are the top co-authors by number of shared publications:
Manshi Ohyanagi
5 shared publications- Tessui Nakagawa
Faculty of Science, University of the Ryukyus
3 shared publications Ryosuke Sato
2 shared publicationsA. Miyagi
Okinawa Prefectural Naha Kokusai Senior High School 2 , 1-29-1, Ameku, Naha, Okinawa 900-0005, Japan
1 shared publicationAisei Miyagi
1 shared publication- Akio Koizumi
Department of Health and Environmental Sciences, Graduate School of Medicine, Kyoto University, Kyoto, Japan
1 shared publication
Latest Publications
- 4 September 2026
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 1080
Enhanced hydrogen sorption kinetics of Mg/MgH2 by a (Mg,Co,Ni,Cu,Zn)O high-entropy oxide catalyst
- 4 September 2026
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 1080
Enhanced hydrogen sorption kinetics of Mg/MgH2 by a (Mg,Co,Ni,Cu,Zn)O high-entropy oxide catalyst
- 26 April 2026
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 1065
Effect of Li2TiO3 crystal phase on the hydrogenation and dehydrogenation kinetics of Mg/MgH2
- 26 April 2026
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 1065
Effect of Li2TiO3 crystal phase on the hydrogenation and dehydrogenation kinetics of Mg/MgH2
- 24 March 2026
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 1062
Thermodynamic identification of hydrogen freezing in LaNi5H6 using communal entropy
- 24 March 2026
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 1062
Thermodynamic identification of hydrogen freezing in LaNi5H6 using communal entropy
- 4 July 2025
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 154
Hydrothermal decomposition of ammonia borane: H2–NH3 release, power generation, and recycle
- 4 July 2025
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 154
Hydrothermal decomposition of ammonia borane: H2–NH3 release, power generation, and recycle
- 3 August 2024
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 82, 733-739
Delayed ammonia release of ammonia borane hydrolysis by citric acid
- 3 August 2024
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 82, 733-739
Delayed ammonia release of ammonia borane hydrolysis by citric acid
- 1 September 2023
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 94 (9)
Development of continuous measurement system for hydrogen and impurity gases using detector tube
A relatively accurate, inexpensive, simple, and continuous quantification system for hydrogen and impurity gas(es) using a detector tube was developed in this study. Additionally, different detector tubes can be applied to measure different types of gases in a wide range from ppm order to % level. We optimized this system and evaluated its accuracy as well as the behavior of released H2 and impurity (NH3) gases from a hydrolysis of ammonia borane using a Pt/Al2O3 catalyst. The accuracy of hydrogen quantitation achieved by this system was comparable to that of commercial mass flow meters, and the accuracy of ammonia quantitation was 10% or 5% relative standard deviation, which depends on the detector tube. The concentration of released NH3 was evaluated by image analysis with a time-lapse video of the detector tube and succeeded in analyzing from ppm to % order. The H2 and NH3 release behaviors agreed with pH, and the percentage of reaction was estimated by NMR measurement of the reacted solution. These results confirmed the accuracy of this system.
- 1 September 2023
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 94 (9)
Development of continuous measurement system for hydrogen and impurity gases using detector tube
A relatively accurate, inexpensive, simple, and continuous quantification system for hydrogen and impurity gas(es) using a detector tube was developed in this study. Additionally, different detector tubes can be applied to measure different types of gases in a wide range from ppm order to % level. We optimized this system and evaluated its accuracy as well as the behavior of released H2 and impurity (NH3) gases from a hydrolysis of ammonia borane using a Pt/Al2O3 catalyst. The accuracy of hydrogen quantitation achieved by this system was comparable to that of commercial mass flow meters, and the accuracy of ammonia quantitation was 10% or 5% relative standard deviation, which depends on the detector tube. The concentration of released NH3 was evaluated by image analysis with a time-lapse video of the detector tube and succeeded in analyzing from ppm to % order. The H2 and NH3 release behaviors agreed with pH, and the percentage of reaction was estimated by NMR measurement of the reacted solution. These results confirmed the accuracy of this system.
- 22 October 2020
- Published by Inter-Research Science Center in Aquatic Microbial Ecology
- Vol. 85, 131-139
Contribution of large bacteria to bacterial biomass in a deep freshwater lake (Lake Biwa, Japan)
- 22 October 2020
- Published by Inter-Research Science Center in Aquatic Microbial Ecology
- Vol. 85, 131-139
Contribution of large bacteria to bacterial biomass in a deep freshwater lake (Lake Biwa, Japan)
- Open Access
- 1 April 2020
- Published by Japan Institute of Metals in MATERIALS TRANSACTIONS
- Vol. 61 (4) , 787-794
Temperature- and Catalyst-Dependent Transformation from Reaction Rate-Limited to Diffusion Rate-Limited Hydrogenation of Mg with Nb2O5 Catalyst
The hydrogen consumption behavior during the hydrogenation of magnesium (Mg) with niobium oxide (Nb2O5) catalyst was analyzed via the volumetric Sieverts method, and categorized into two types of consumption kinetic processes: increasing consumption rate with temperature at lower temperatures and almost constant consumption rate at higher temperatures. The consumption rates were measured as the hydrogen absorption rates of Mg, and were analyzed based on a first-order reaction for two types of absorption processes, reaction rate-limited and diffusion rate-limited. The apparent activation energies in the hydrogen absorption rate increased with temperature at low temperatures, and were 49.5–53 kJ/mol for Mg with 5, 10, and 20 mass% Nb2O5 catalyst, which were lower than the activation energy for pure Mg. The apparent activation energies in the absorption rate were almost constant at higher temperatures, ranging from 0–9.6 kJ/mol. The transformation of the absorption reaction process from a reaction rate-limited to diffusion rate-limited process with an extremely lower apparent activation energy is similar to that observed during the combustion of charcoal.
- 1 April 2020
- Published by Japan Institute of Metals in MATERIALS TRANSACTIONS
- Vol. 61 (4) , 787-794
Open AccessTemperature- and Catalyst-Dependent Transformation from Reaction Rate-Limited to Diffusion Rate-Limited Hydrogenation of Mg with Nb2O5 Catalyst
The hydrogen consumption behavior during the hydrogenation of magnesium (Mg) with niobium oxide (Nb2O5) catalyst was analyzed via the volumetric Sieverts method, and categorized into two types of consumption kinetic processes: increasing consumption rate with temperature at lower temperatures and almost constant consumption rate at higher temperatures. The consumption rates were measured as the hydrogen absorption rates of Mg, and were analyzed based on a first-order reaction for two types of absorption processes, reaction rate-limited and diffusion rate-limited. The apparent activation energies in the hydrogen absorption rate increased with temperature at low temperatures, and were 49.5–53 kJ/mol for Mg with 5, 10, and 20 mass% Nb2O5 catalyst, which were lower than the activation energy for pure Mg. The apparent activation energies in the absorption rate were almost constant at higher temperatures, ranging from 0–9.6 kJ/mol. The transformation of the absorption reaction process from a reaction rate-limited to diffusion rate-limited process with an extremely lower apparent activation energy is similar to that observed during the combustion of charcoal.
- Open Access
- 25 June 2019
- Published by Japan Institute of Light Metals in Journal of Japan Institute of Light Metals
- Vol. 69 (6) , 312-314
Influence of cold rolling on strength and resistance to hydrogen embrittlement in Al–8%Zn–2%Mg–2%Cu–0.15%Zr alloy
- 25 June 2019
- Published by Japan Institute of Light Metals in Journal of Japan Institute of Light Metals
- Vol. 69 (6) , 312-314
Open AccessInfluence of cold rolling on strength and resistance to hydrogen embrittlement in Al–8%Zn–2%Mg–2%Cu–0.15%Zr alloy