Wido H. Schreiner
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Wido H. Schreiner has a total of 40 co-authors. Here are the top co-authors by number of shared publications:
- Dante Homero Mosca
Universidade Federal do Paraná 1 Departamento de Física CP 19044, CEP 81531-990, Curitiba, PR, Brazil
3 shared publications - Miguel Abbate
Departamento de Física, Universidade Federal do Paraná, Caixa Postal 19044, 81531-990 Curitiba, PR, Brazil
2 shared publications - Ney Mattoso
Physics Department, Federal University of Paraná (UFPR), Centro Politécnico, Curitiba 81531-980, Paraná, Brazil
2 shared publications Adriana F. Lubambo
Departamento de Física, Universidade Federal do Paraná, Jd das Américas-Centro Politécnico, Curitiba, Caixa Postal, PR, Brazil
1 shared publication- Alex B. Cezar
Instituto Federal do Paraná 1 , 82920-030 Curitiba, Paraná, Brazil
1 shared publication - Alfredo R. Vaz
Universidade Estadual de Campinas, Brasil
1 shared publication
Latest Publications
- 22 September 2023
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 134 (12)
Size-induced metal–insulator transition temperature decrease of VO2 nanoparticles obtained by laser irradiation in water
Vanadium dioxide (VO2) is a highly attractive and multifunctional material for technological applications due to its metal–insulator transition, which is accompanied by several orders of magnitude changes in electrical resistivity and optical transmissivity. In this work, we report on the metal–insulator transition of VO2 nanoparticles which are produced by a simple, efficient, and low-cost two-step preparation method based on infrared laser irradiation of V2O5 powder dispersed in water and subsequent stoichiometric stabilization by vacuum annealing at 773 K. VO2 nanoparticles have an average size of 36 nm with facet-like contours and undergo a structural phase transition from a monoclinic to a tetragonal phase, accompanied by a metal–insulator transition occurring around 323 K, which is about 17 K lower than bulk VO2. No evidence of the formation of intermediary metastable phases is observed. Our findings reveal that the size of VO2 nanoparticles is a key parameter to moving the transition closer to room temperature, which is important for many applications.
- 22 September 2023
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 134 (12)
Size-induced metal–insulator transition temperature decrease of VO2 nanoparticles obtained by laser irradiation in water
Vanadium dioxide (VO2) is a highly attractive and multifunctional material for technological applications due to its metal–insulator transition, which is accompanied by several orders of magnitude changes in electrical resistivity and optical transmissivity. In this work, we report on the metal–insulator transition of VO2 nanoparticles which are produced by a simple, efficient, and low-cost two-step preparation method based on infrared laser irradiation of V2O5 powder dispersed in water and subsequent stoichiometric stabilization by vacuum annealing at 773 K. VO2 nanoparticles have an average size of 36 nm with facet-like contours and undergo a structural phase transition from a monoclinic to a tetragonal phase, accompanied by a metal–insulator transition occurring around 323 K, which is about 17 K lower than bulk VO2. No evidence of the formation of intermediary metastable phases is observed. Our findings reveal that the size of VO2 nanoparticles is a key parameter to moving the transition closer to room temperature, which is important for many applications.
- Open Access
- 1 January 2013
- Published by Sociedade Brasileira de Cirurgia Cardiovascular in Brazilian Journal of Cardiovascular Surgery
- Vol. 28 (3) , 331-337
Effects of reprocessing on chemical and morphological properties of guide wires used in angioplasty
To investigate the influence of the reprocessing technique of enzymatic bath with ultrasonic cleaning and ethylene oxide sterilization on the chemical properties and morphological structure of polymeric coatings of guide wire for regular guiding catheter. These techniques simulated the routine of guide wire reprocessing in many hemodynamic services in Brazil and other countries. Samples from three different manufacturers were verified by scanning electron microscopy and X-ray photoelectron spectroscopy. A single or double sterilization of the catheters with ethylene oxide was not associated with morphological or chemical changes. However, scanning electron microscopy images showed that the washing method was associated with rough morphological changes, including superficial holes and bubbles, in addition to chemical changes of external atomic layers of polymeric coating surfaces, as detected by the X-ray photoelectron spectroscopy method, which is compatible with extended chemical changes on catheter surfaces. The reprocessing of the catheters with ethylene oxide was not associated with morphological or chemical changes, and it seemed appropriate to maintain guide wire coating integrity. However, the method combining chemical cleaning with mechanical vibration resulted in rough anatomical and chemical surface deterioration, suggesting that this reprocessing method should be discouraged.
- 1 January 2013
- Published by Sociedade Brasileira de Cirurgia Cardiovascular in Brazilian Journal of Cardiovascular Surgery
- Vol. 28 (3) , 331-337
Open AccessEffects of reprocessing on chemical and morphological properties of guide wires used in angioplasty
To investigate the influence of the reprocessing technique of enzymatic bath with ultrasonic cleaning and ethylene oxide sterilization on the chemical properties and morphological structure of polymeric coatings of guide wire for regular guiding catheter. These techniques simulated the routine of guide wire reprocessing in many hemodynamic services in Brazil and other countries. Samples from three different manufacturers were verified by scanning electron microscopy and X-ray photoelectron spectroscopy. A single or double sterilization of the catheters with ethylene oxide was not associated with morphological or chemical changes. However, scanning electron microscopy images showed that the washing method was associated with rough morphological changes, including superficial holes and bubbles, in addition to chemical changes of external atomic layers of polymeric coating surfaces, as detected by the X-ray photoelectron spectroscopy method, which is compatible with extended chemical changes on catheter surfaces. The reprocessing of the catheters with ethylene oxide was not associated with morphological or chemical changes, and it seemed appropriate to maintain guide wire coating integrity. However, the method combining chemical cleaning with mechanical vibration resulted in rough anatomical and chemical surface deterioration, suggesting that this reprocessing method should be discouraged.
- 1 May 2009
- Published by Elsevier in Colloids and Surfaces B: Biointerfaces
- Vol. 70 (2) , 174-180
Dewetting pattern and stability of thin xyloglucan films adsorbed on silicon and mica
- 1 May 2009
- Published by Elsevier in Colloids and Surfaces B: Biointerfaces
- Vol. 70 (2) , 174-180
Dewetting pattern and stability of thin xyloglucan films adsorbed on silicon and mica
- 1 May 2007
- Published by Elsevier in Journal of Electron Spectroscopy and Related Phenomena
- Vol. 156-158, 476-481
X-ray photoelectron spectroscopy study on sintered Pb1−xLaxTiO3 ferroelectric ceramics
- 1 May 2007
- Published by Elsevier in Journal of Electron Spectroscopy and Related Phenomena
- Vol. 156-158, 476-481
X-ray photoelectron spectroscopy study on sintered Pb1−xLaxTiO3 ferroelectric ceramics
- 1 May 2002
- Published by Elsevier in Thin Solid Films
- Vol. 411 (2) , 256-261
Ion irradiation effects on hardness and elastic modulus in AZ 1350J™ photoresist film
- 1 May 2002
- Published by Elsevier in Thin Solid Films
- Vol. 411 (2) , 256-261
Ion irradiation effects on hardness and elastic modulus in AZ 1350J™ photoresist film
- 31 May 2001
- Published by IOP Publishing in Journal of Physics: Condensed Matter
- Vol. 13 (24) , 5723-5729
Evidence of chemical bonding in the electronic structure of a metastable Fe80Cu20alloy
- 31 May 2001
- Published by IOP Publishing in Journal of Physics: Condensed Matter
- Vol. 13 (24) , 5723-5729
Evidence of chemical bonding in the electronic structure of a metastable Fe80Cu20alloy
- 1 October 1997
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 144 (10) , 3624-3628
Structure, Composition, and Morphology of Electrodeposited Co0.9Fe0.1 ( Cu ) Alloys
- 1 October 1997
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 144 (10) , 3624-3628
Structure, Composition, and Morphology of Electrodeposited Co0.9Fe0.1 ( Cu ) Alloys
- 1 April 1996
- Published by Elsevier in Journal of Magnetism and Magnetic Materials
- Vol. 156 (1-3) , 391-393
Influence of Fe and Cu seed layers on the magnetoresistance in Fe/Cu superlattices grown on Si(111) and CaF2(111) /Si(111)
- 1 April 1996
- Published by Elsevier in Journal of Magnetism and Magnetic Materials
- Vol. 156 (1-3) , 391-393
Influence of Fe and Cu seed layers on the magnetoresistance in Fe/Cu superlattices grown on Si(111) and CaF2(111) /Si(111)