Daniel Parra-Molina
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Daniel Parra-Molina has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
- Adriana Gómez Gómez
Pontificia Universidad Javeriana
1 shared publication - Aníbal Maury-Ramírez
Architecture Department, Faculty of Design Sciences, University of Antwerp, 2000 Antwerp, Belgium
1 shared publication - Manuel Alejandro Rojas-Manzano
Department of Civil and Industrial Engineering, Pontificia Universidad Javeriana, Calle 18 # 118-250, Santiago de Cali 760031, Colombia
1 shared publication - Mario Fernando Muñoz-Velez
Grupo Materiales Compuestos, Escuela de Ingeniería de Materiales, Universidad del Valle, Calle 13 No. 100-00, Cali 760032, Colombia
1 shared publication
Latest Publications
- Open Access
- 26 September 2023
- Published by MDPI AG in Sustainability
- Vol. 15 (19) , 14224
Mechanical Performance of Mortars with Partial Replacement of Cement by Aluminum Dross: Inactivation and Particle Size
Although the use of primary aluminum dross as cement replacement has shown promising results in mortars and concretes, there is a knowledge gap between the effect of the secondary dross inactivation process and particle sizes on the mechanical properties and consistency. So, by using X-ray diffraction, laser granulometry, and scanning electron microscopy, this article describes first the inactivation process applied to a secondary aluminum dross. Second, this manuscript presents the fresh and hardened properties of mortar mixes containing 5, 10, and 20% inactivated secondary aluminum dross with three different particle sizes (i.e., fine, intermediate, and coarse). Mortar flow test results indicate that compressive and flexural strengths of mixes containing up to 20% fine and intermediate aluminum dross as cement replacement were satisfactory, respectively. These results have the potential to reduce the environmental and health impacts caused by cement production and secondary aluminum dross disposal, respectively. Moreover, the durability aspects of the mortar mixes, as well as the effectivity of the investigated inactivation process, are identified as future research topics.
- 26 September 2023
- Published by MDPI AG in Sustainability
- Vol. 15 (19) , 14224
Open AccessMechanical Performance of Mortars with Partial Replacement of Cement by Aluminum Dross: Inactivation and Particle Size
Although the use of primary aluminum dross as cement replacement has shown promising results in mortars and concretes, there is a knowledge gap between the effect of the secondary dross inactivation process and particle sizes on the mechanical properties and consistency. So, by using X-ray diffraction, laser granulometry, and scanning electron microscopy, this article describes first the inactivation process applied to a secondary aluminum dross. Second, this manuscript presents the fresh and hardened properties of mortar mixes containing 5, 10, and 20% inactivated secondary aluminum dross with three different particle sizes (i.e., fine, intermediate, and coarse). Mortar flow test results indicate that compressive and flexural strengths of mixes containing up to 20% fine and intermediate aluminum dross as cement replacement were satisfactory, respectively. These results have the potential to reduce the environmental and health impacts caused by cement production and secondary aluminum dross disposal, respectively. Moreover, the durability aspects of the mortar mixes, as well as the effectivity of the investigated inactivation process, are identified as future research topics.