Tong Jin
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Tong Jin has a total of 32 co-authors. Here are the top co-authors by number of shared publications:
Guangda Niu
School of Optical and Electronic Information and Wuhan National Laboratory for Optoelectronics Huazhong University of Science and Technology Wuhan 430074 China
3 shared publicationsJincong Pang
School of Optical and Electronic Information and Wuhan National Laboratory for Optoelectronics Huazhong University of Science and Technology Wuhan 430074 China
3 shared publications- Guangda Niu
Wuhan National Laboratory for Optoelectronics, Huazhong University of Science and Technology, Wuhan, China
2 shared publications Jiang Tang
School of Optical and Electronic Information and Wuhan National Laboratory for Optoelectronics Huazhong University of Science and Technology Wuhan 430074 China
2 shared publications- Shunsheng Yuan
Wuhan National Laboratory for Optoelectronics and School of Optical and Electronic Information Huazhong University of Science and Technology Wuhan China
2 shared publications Yan Xiong
2 shared publications
Latest Publications
Bulk Charge Recombination Reduction Enabled High Spectral Resolution Perovskite Gamma‐Ray Spectrometer
Solution‐grown metal halide perovskite single crystals have been demonstrated as potential gamma‐ray spectrometer. However, the energy resolution of the solution‐grown formamidinum lead bromide (FAPbBr 3 ) single crystal spectrometer still suffers from strong bulk charge recombination. Here, it is identified that the high bulk charge recombination arises from a gradient Type‐I band distribution throughout the crystal. This band distribution is attributed to the strong coordination of solvents with FA⁺ cations, which become incorporated into the perovskite lattice during crystal growth. It is selected a solvent that more easily decomplexed with FA + , and successfully obtained FAPbBr 3 single crystals without any trapped solvent molecules in the lattices. The FAPbBr 3 single crystals exhibited a tenfold reduction in bulk charge recombination rate, and this enabled the FAPbBr 3 gamma‐ray spectrometer to achieve an energy resolution of 1.47 ± 0.05% for 662 keV 137 Cs gamma rays, which is the best among solution‐grown semiconductor detectors. The unencapsulated FAPbBr 3 gamma‐ray spectrometer exhibited more than three months of operational and storage stability.
Bulk Charge Recombination Reduction Enabled High Spectral Resolution Perovskite Gamma‐Ray Spectrometer
Solution‐grown metal halide perovskite single crystals have been demonstrated as potential gamma‐ray spectrometer. However, the energy resolution of the solution‐grown formamidinum lead bromide (FAPbBr 3 ) single crystal spectrometer still suffers from strong bulk charge recombination. Here, it is identified that the high bulk charge recombination arises from a gradient Type‐I band distribution throughout the crystal. This band distribution is attributed to the strong coordination of solvents with FA⁺ cations, which become incorporated into the perovskite lattice during crystal growth. It is selected a solvent that more easily decomplexed with FA + , and successfully obtained FAPbBr 3 single crystals without any trapped solvent molecules in the lattices. The FAPbBr 3 single crystals exhibited a tenfold reduction in bulk charge recombination rate, and this enabled the FAPbBr 3 gamma‐ray spectrometer to achieve an energy resolution of 1.47 ± 0.05% for 662 keV 137 Cs gamma rays, which is the best among solution‐grown semiconductor detectors. The unencapsulated FAPbBr 3 gamma‐ray spectrometer exhibited more than three months of operational and storage stability.
- 6 November 2023
- Published by Elsevier in Chemical Engineering Journal
- Vol. 477
Ion migration mediated high Seebeck effect in halide perovskites and application in infrared detection
- 6 November 2023
- Published by Elsevier in Chemical Engineering Journal
- Vol. 477
Ion migration mediated high Seebeck effect in halide perovskites and application in infrared detection
- 1 October 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 44 (10) , 1620-1623
Enhancing High-Voltage Stability of CsPbBr₃ Radiation Detectors Through Surface Treatment and Electrode Replacement
- 1 October 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 44 (10) , 1620-1623
Enhancing High-Voltage Stability of CsPbBr₃ Radiation Detectors Through Surface Treatment and Electrode Replacement
- 1 January 2023
- Published by Optica Publishing Group
- Vol. 16, HTh3D.1
Ultrafast perovskite single crystals for positron emission tomography
Two-dimensional perovskite single crystals with high light yield and short decay time were synthesized. The crystals were applied in positron emission tomography, and the coincidence time resolution for the optimized perovskite single crystals reached 119.4 ps.
- 1 January 2023
- Published by Optica Publishing Group
- Vol. 16, HTh3D.1
Ultrafast perovskite single crystals for positron emission tomography
Two-dimensional perovskite single crystals with high light yield and short decay time were synthesized. The crystals were applied in positron emission tomography, and the coincidence time resolution for the optimized perovskite single crystals reached 119.4 ps.
- Open Access
- 11 October 2021
- Published by Higher Education Press in Frontiers of Optoelectronics
- Vol. 14 (4) , 473-481
Oxide perovskite Ba2AgIO6 wafers for X-ray detection
X-ray detection is of great significance in biomedical, nondestructive, and scientific research. Lead halide perovskites have recently emerged as one of the most promising materials for direct X-ray detection. However, the lead toxicity remains a worrisome concern for further commercial application. Great efforts have been made to search for lead-free perovskites with similar optoelectronic properties. Here, we present a lead-free oxide double perovskite material Ba2AgIO6 for X-ray detection. The lead-free, all-inorganic nature, as well as the high density of Ba2AgIO6, promises excellent prospects in X-ray applications. By employing the hydrothermal method, we successfully synthesized highly crystalline Ba2AgIO6 powder with pure phase. Furthermore, we prepared Ba2AgIO6 wafers through isostatic pressure and built X-ray detectors with Au/Ba2AgIO6 wafer/Au photo-conductive structure. The as-prepared X-ray detectors showed a sensitivity of 18.9 µC/(Gyair·cm2) at 5 V/mm, similar to commercial α-Se detectors showcasing their advantages for X-ray detection.
- 11 October 2021
- Published by Higher Education Press in Frontiers of Optoelectronics
- Vol. 14 (4) , 473-481
Open AccessOxide perovskite Ba2AgIO6 wafers for X-ray detection
X-ray detection is of great significance in biomedical, nondestructive, and scientific research. Lead halide perovskites have recently emerged as one of the most promising materials for direct X-ray detection. However, the lead toxicity remains a worrisome concern for further commercial application. Great efforts have been made to search for lead-free perovskites with similar optoelectronic properties. Here, we present a lead-free oxide double perovskite material Ba2AgIO6 for X-ray detection. The lead-free, all-inorganic nature, as well as the high density of Ba2AgIO6, promises excellent prospects in X-ray applications. By employing the hydrothermal method, we successfully synthesized highly crystalline Ba2AgIO6 powder with pure phase. Furthermore, we prepared Ba2AgIO6 wafers through isostatic pressure and built X-ray detectors with Au/Ba2AgIO6 wafer/Au photo-conductive structure. The as-prepared X-ray detectors showed a sensitivity of 18.9 µC/(Gyair·cm2) at 5 V/mm, similar to commercial α-Se detectors showcasing their advantages for X-ray detection.