Martin Konopka
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Martin Konopka has a total of 25 co-authors. Here are the top co-authors by number of shared publications:
- Wolfgang Schröder
RWTH Aachen University
2 shared publications - Alexander Kromka
Institute of Physics of the Czech Academy of Sciences Prague Czech Republic
1 shared publication Dušan Vaňa
1 shared publication- Huan Fei Wen
North University of China
1 shared publication - Ivan Štich
Institute of Informatics, Slovak Academy of Sciences
1 shared publication - Jozef Dobrovodský
Faculty of Materials Science and Technology in Trnava, Slovak University of Technology in Bratislava, Jána Bottu 2781/25, 917-24 Trnava, Slovakia
1 shared publication
Latest Publications
- 16 June 2025
- Published by Elsevier in Applied Surface Science
- Vol. 709
Role of oxygen in suppression of boron incorporation in diamond films: Surface reactions insight
- 16 June 2025
- Published by Elsevier in Applied Surface Science
- Vol. 709
Role of oxygen in suppression of boron incorporation in diamond films: Surface reactions insight
- Open Access
- 29 September 2023
- Published by American Association for the Advancement of Science (AAAS) in Science Advances
- Vol. 9 (39) , eadi4799
Tip-activated single-atom catalysis: CO oxidation on Au adatom on oxidized rutile TiO 2 surface
Single-atom catalysis of carbon monoxide oxidation on metal-oxide surfaces is crucial for greenhouse recycling, automotive catalysis, and beyond, but reports of the atomic-scale mechanism are still scarce. Here, using scanning probe microscopy, we show that charging single gold atoms on oxidized rutile titanium dioxide surface, both positively and negatively, considerably promotes adsorption of carbon monoxide. No carbon monoxide adsorption is observed on neutral gold atoms. Two different carbon monoxide adsorption geometries on gold atoms are identified. We demonstrate full control over the redox state of adsorbed gold single atoms, carbon monoxide adsorption geometry, and carbon monoxide adsorption/desorption by the atomic force microscopy tip. On charged gold atoms, we activate Eley-Rideal oxidation reaction between carbon monoxide and a neighboring oxygen adatom by the tip. Our results provide unprecedented insights into carbon monoxide adsorption and suggest that the gold dual activity for carbon monoxide oxidation after electron or hole attachment is also the key ingredient in photocatalysis under realistic conditions.
- 29 September 2023
- Published by American Association for the Advancement of Science (AAAS) in Science Advances
- Vol. 9 (39) , eadi4799
Open AccessTip-activated single-atom catalysis: CO oxidation on Au adatom on oxidized rutile TiO 2 surface
Single-atom catalysis of carbon monoxide oxidation on metal-oxide surfaces is crucial for greenhouse recycling, automotive catalysis, and beyond, but reports of the atomic-scale mechanism are still scarce. Here, using scanning probe microscopy, we show that charging single gold atoms on oxidized rutile titanium dioxide surface, both positively and negatively, considerably promotes adsorption of carbon monoxide. No carbon monoxide adsorption is observed on neutral gold atoms. Two different carbon monoxide adsorption geometries on gold atoms are identified. We demonstrate full control over the redox state of adsorbed gold single atoms, carbon monoxide adsorption geometry, and carbon monoxide adsorption/desorption by the atomic force microscopy tip. On charged gold atoms, we activate Eley-Rideal oxidation reaction between carbon monoxide and a neighboring oxygen adatom by the tip. Our results provide unprecedented insights into carbon monoxide adsorption and suggest that the gold dual activity for carbon monoxide oxidation after electron or hole attachment is also the key ingredient in photocatalysis under realistic conditions.
- 1 July 2019
- Published by American Institute of Aeronautics and Astronautics (AIAA) in Journal of Thermophysics and Heat Transfer
- Vol. 33 (3) , 673-685
Extension of a Standard Flow Solver for Simulating Phase Change in Cryogenic Tanks
- 1 July 2019
- Published by American Institute of Aeronautics and Astronautics (AIAA) in Journal of Thermophysics and Heat Transfer
- Vol. 33 (3) , 673-685
Extension of a Standard Flow Solver for Simulating Phase Change in Cryogenic Tanks
- Open Access
- 20 March 2014
- Published by American Physical Society (APS) in Physical Review B
- Vol. 89 (12)
Wave-packet representation of leads for efficient simulations of time-dependent electronic transport
We present theoretical foundations and numerical demonstration of an efficient method for performing time-dependent many-electron simulations for electronic transport. The method employs the concept of stroboscopic wave-packet basis for the description of electrons' dynamics in the semi-infinite leads. The rest of the system can be treated using common propagation schemes for finite electronic systems. We use the implementation of our method to study the time-dependent current response in armchair graphene nanoribbons (AGNRs) with sizes up to 800 atoms described within tight-binding approximation. The character of the time-dependent current is studied for different magnitudes of the bias voltage, variable width and length of AGNRs, different positions of the current measurement, and for full and reduced coupling of the AGNRs to the electrodes. DOI: http://dx.doi.org/10.1103/PhysRevB.89.125424 ©2014 American Physical Society
- 20 March 2014
- Published by American Physical Society (APS) in Physical Review B
- Vol. 89 (12)
Open AccessWave-packet representation of leads for efficient simulations of time-dependent electronic transport
We present theoretical foundations and numerical demonstration of an efficient method for performing time-dependent many-electron simulations for electronic transport. The method employs the concept of stroboscopic wave-packet basis for the description of electrons' dynamics in the semi-infinite leads. The rest of the system can be treated using common propagation schemes for finite electronic systems. We use the implementation of our method to study the time-dependent current response in armchair graphene nanoribbons (AGNRs) with sizes up to 800 atoms described within tight-binding approximation. The character of the time-dependent current is studied for different magnitudes of the bias voltage, variable width and length of AGNRs, different positions of the current measurement, and for full and reduced coupling of the AGNRs to the electrodes. DOI: http://dx.doi.org/10.1103/PhysRevB.89.125424 ©2014 American Physical Society
- 25 March 2013
- Published by Wiley in Journal of Turbomachinery
- Vol. 135 (3) , 031031
Large-Eddy Simulation of Film Cooling in an Adverse Pressure Gradient Flow
In order to analyze the interaction of multiple rows of film cooling holes in flows at adverse pressure gradients, large-eddy simulations (LESs) are performed. The considered three-row cooling configuration consists of inclined cooling holes at an angle of 30 deg with a lateral pitch of p/D=3 and a streamwise spacing of l/D=6. The cooling holes possess a fan-shaped exit geometry with lateral and streamwise expansions. For each cooling row the complete internal flow is computed. Air and CO2 are injected in order to investigate the influence of an increased density ratio on the film cooling physics at adverse pressure gradients. The CO2 injected at the same blowing rate as air shows a higher magnitude of the Reynolds shear stress component and, thus, an enhanced mixing downstream of the cooling holes. The LES results of the air and CO2 configurations are compared to the corresponding particle-image velocimetry (PIV) measurements and show a convincing agreement in terms of the averaged streamwise velocity and streamwise velocity fluctuations. Furthermore, the cooling effectiveness is investigated for a zero and an adverse pressure gradient configuration with a temperature ratio at gas turbine conditions. For the adverse pressure gradient case, reduced temperature levels off the wall are observed. However, the cooling effectiveness shows only minor differences compared to the zero pressure gradient flow. The turbulent Schmidt number at CO2 injection shows large variations. Just downstream of the injection it attains low values, whereas high values are detected in the upper mixing zone of the cooling flow and the freestream at each film cooling row.
- 25 March 2013
- Published by Wiley in Journal of Turbomachinery
- Vol. 135 (3) , 031031
Large-Eddy Simulation of Film Cooling in an Adverse Pressure Gradient Flow
In order to analyze the interaction of multiple rows of film cooling holes in flows at adverse pressure gradients, large-eddy simulations (LESs) are performed. The considered three-row cooling configuration consists of inclined cooling holes at an angle of 30 deg with a lateral pitch of p/D=3 and a streamwise spacing of l/D=6. The cooling holes possess a fan-shaped exit geometry with lateral and streamwise expansions. For each cooling row the complete internal flow is computed. Air and CO2 are injected in order to investigate the influence of an increased density ratio on the film cooling physics at adverse pressure gradients. The CO2 injected at the same blowing rate as air shows a higher magnitude of the Reynolds shear stress component and, thus, an enhanced mixing downstream of the cooling holes. The LES results of the air and CO2 configurations are compared to the corresponding particle-image velocimetry (PIV) measurements and show a convincing agreement in terms of the averaged streamwise velocity and streamwise velocity fluctuations. Furthermore, the cooling effectiveness is investigated for a zero and an adverse pressure gradient configuration with a temperature ratio at gas turbine conditions. For the adverse pressure gradient case, reduced temperature levels off the wall are observed. However, the cooling effectiveness shows only minor differences compared to the zero pressure gradient flow. The turbulent Schmidt number at CO2 injection shows large variations. Just downstream of the injection it attains low values, whereas high values are detected in the upper mixing zone of the cooling flow and the freestream at each film cooling row.
- 7 July 2011
- Published by Wiley in Journal of Turbomachinery
- Vol. 134 (2) , 021025
Particle-Image Velocimetry Measurements of Film Cooling in an Adverse Pressure Gradient Flow
The turbulent flow field of a film cooling flow is investigated using the particle-image velocimetry technique. Cooling jets are injected from a multirow hole configuration into a turbulent boundary layer flow of a flat plate in the presence of a zero and an adverse pressure gradient. The investigations focus on full-coverage film cooling. Therefore, the film cooling configuration consists of three staggered rows of holes with a lateral spacing of p/D=3 and a streamwise row distance of l/D=6. The inclined cooling holes feature a fan-shaped exit geometry with lateral and streamwise expansions. Jets of air and CO2 are injected separately at different blowing ratios into a boundary layer to examine the effects of the density ratio between coolant and mainstream on the mixing behavior and consequently, the cooling efficiency. For the zero pressure gradient case, the measurement results indicate the different nature of the mixing process between the jets and the crossflow after the first, second, and third row. The mainstream velocity distributions evidence the growth of the boundary layer thickness at increasing row number. The interaction between the undisturbed boundary layer and first two rows leads to maximum values of turbulent kinetic energy. The presence of an adverse pressure gradient in the mainstream clearly intensifies the growth of the boundary layer thickness and increases the velocity fluctuations in the upper mixing zone. The measurements considering an increased density ratio show higher turbulence intensities in the shear zone between the jets and the main flow, leading to a more pronounced mixing in this area. The results of the experimental measurements are used to validate numerical findings from a large-eddy simulation. This comparison shows a very good agreement for mean velocity distributions and velocity fluctuations.
- 7 July 2011
- Published by Wiley in Journal of Turbomachinery
- Vol. 134 (2) , 021025
Particle-Image Velocimetry Measurements of Film Cooling in an Adverse Pressure Gradient Flow
The turbulent flow field of a film cooling flow is investigated using the particle-image velocimetry technique. Cooling jets are injected from a multirow hole configuration into a turbulent boundary layer flow of a flat plate in the presence of a zero and an adverse pressure gradient. The investigations focus on full-coverage film cooling. Therefore, the film cooling configuration consists of three staggered rows of holes with a lateral spacing of p/D=3 and a streamwise row distance of l/D=6. The inclined cooling holes feature a fan-shaped exit geometry with lateral and streamwise expansions. Jets of air and CO2 are injected separately at different blowing ratios into a boundary layer to examine the effects of the density ratio between coolant and mainstream on the mixing behavior and consequently, the cooling efficiency. For the zero pressure gradient case, the measurement results indicate the different nature of the mixing process between the jets and the crossflow after the first, second, and third row. The mainstream velocity distributions evidence the growth of the boundary layer thickness at increasing row number. The interaction between the undisturbed boundary layer and first two rows leads to maximum values of turbulent kinetic energy. The presence of an adverse pressure gradient in the mainstream clearly intensifies the growth of the boundary layer thickness and increases the velocity fluctuations in the upper mixing zone. The measurements considering an increased density ratio show higher turbulence intensities in the shear zone between the jets and the main flow, leading to a more pronounced mixing in this area. The results of the experimental measurements are used to validate numerical findings from a large-eddy simulation. This comparison shows a very good agreement for mean velocity distributions and velocity fluctuations.
- 1 November 1999
- Published by American Physical Society (APS) in Physical Review A
- Vol. 60 (5) , 4183-4186
Stimulated emission from an atom in a photonic crystal
I analyze the stimulated emission process in photonic band structures. I consider a dipole transition of a two-level atom which is tuned near an edge of a photonic band gap. I solve numerically the Schrödinger equation for the chosen model without Born and Markovian approximations. It is shown that even one photon in the field can have significant influence on the dynamics of the system providing the atomic transition is tuned near sharp structures of the density of modes.
- 1 November 1999
- Published by American Physical Society (APS) in Physical Review A
- Vol. 60 (5) , 4183-4186
Stimulated emission from an atom in a photonic crystal
I analyze the stimulated emission process in photonic band structures. I consider a dipole transition of a two-level atom which is tuned near an edge of a photonic band gap. I solve numerically the Schrödinger equation for the chosen model without Born and Markovian approximations. It is shown that even one photon in the field can have significant influence on the dynamics of the system providing the atomic transition is tuned near sharp structures of the density of modes.