Wan Kim
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Wan Kim has a total of 40 co-authors. Here are the top co-authors by number of shared publications:
Byoungjoong Kang
System LSI Business, Samsung Electronics, Hwaseong-si, Gyeonggi-do, South Korea
3 shared publicationsChanho Kim
System LSI Business, Samsung Electronics, Hwaseong-si, Gyeonggi-do, South Korea
2 shared publications- Geunhaeng Lee
Department of Information and Telecommunication Engineering, Incheon National University, Incheon, Republic of Korea
2 shared publications Honggul Han
System LSI Business, Samsung Electronics, Hwaseong-si, Gyeonggi-do, South Korea
2 shared publications- Hyun-Gi Seok
Samsung Electronics
2 shared publications Jae-Keun Lee
System LSI Business, Samsung Electronics, Hwaseong-si, Gyeonggi-do, South Korea
2 shared publications
Latest Publications
- 19 February 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 60 (4) , 1150-1161
High-Sensitivity, Low-Power IR-UWB Radar Transceiver With Self-Interference Resistance for Child Presence Detection and Precision Positioning
This article presents a radar-enabled impulse radio ultrawideband (IR-UWB) system by adopting a self-interference-resistant RF transceiver. It demonstrates that child presence detection (CPD) using IR-UWB radar is feasible through the implementation of a radar system that includes physical (PHY), media access control (MAC), and application (APP) processors. The RF transceiver shows high receiver (RX) sensitivity and high transmitter (TX) peak power with low power. In addition, a radar-dedicated TX is used to improve the TX signal isolation to the RX. To achieve the high RX chain gain and low noise figure (NF) of RX, an RX front end (RX-FE) low-noise amplifier (LNA) and voltage-to-current (V2I) with a 50% duty cycle local oscillator (LO) is implemented. Furthermore, a notch pulse shaping filter (PSF) technique is proposed to meet spectrum emission mask (SEM) specifications with low power consumption. An LNA with wide gain ranges is also proposed to improve the sensitivity and support various applications related to radar and positioning applications. The UWB transceiver achieves -96.5-dBm sensitivity at BPRF 6.81 Mb/s and 14-dBm TX peak power and supports radar operation with UWB channels 5 and 9.
- 19 February 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 60 (4) , 1150-1161
High-Sensitivity, Low-Power IR-UWB Radar Transceiver With Self-Interference Resistance for Child Presence Detection and Precision Positioning
This article presents a radar-enabled impulse radio ultrawideband (IR-UWB) system by adopting a self-interference-resistant RF transceiver. It demonstrates that child presence detection (CPD) using IR-UWB radar is feasible through the implementation of a radar system that includes physical (PHY), media access control (MAC), and application (APP) processors. The RF transceiver shows high receiver (RX) sensitivity and high transmitter (TX) peak power with low power. In addition, a radar-dedicated TX is used to improve the TX signal isolation to the RX. To achieve the high RX chain gain and low noise figure (NF) of RX, an RX front end (RX-FE) low-noise amplifier (LNA) and voltage-to-current (V2I) with a 50% duty cycle local oscillator (LO) is implemented. Furthermore, a notch pulse shaping filter (PSF) technique is proposed to meet spectrum emission mask (SEM) specifications with low power consumption. An LNA with wide gain ranges is also proposed to improve the sensitivity and support various applications related to radar and positioning applications. The UWB transceiver achieves -96.5-dBm sensitivity at BPRF 6.81 Mb/s and 14-dBm TX peak power and supports radar operation with UWB channels 5 and 9.
- 3 October 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 58 (12) , 3408-3420
A Fully Integrated IEEE 802.15.4/4z-Compliant UWB System-on-Chip RF Transceiver Supporting Precision Positioning in a CMOS 28-nm Process
This article presents a fully integrated ultrawideband (UWB) system-on-chip (SoC) that complies with IEEE 802.15.4/4z standard, providing precise positioning and secure communication capabilities. The proposed UWB SoC includes a radio frequency (RF) transceiver, a modem, a microcontroller unit (MCU), an eFlash, a power management unit (PMU), clock generation IPs, and peripheral blocks. The RF transceiver integrates RF switches and comprises two transmitters and three receivers. The proposed nonuniform quantization digital-to-analog converter (NQ-DAC) is used in the transmitter to enhance the quality of pulse sidelobe, and a receiver I/Q mismatch estimation technique using a double-sideband (DSB) transmitter as a reference is proposed. The UWB SoC operates in the frequencies at 6.5 GHz (Ch5) and 8 GHz (Ch9), achieving a location estimation precision of a few centimeters. The prototype UWB SoC is fabricated in a CMOS 28-nm process, and the experimental results under base pulse repetition frequencies (BPRFs) 6.81 Mbps show a receiver sensitivity of $-$ 96.1 dBm and a transmitter output peak power of 14.25 dBm, achieving the state-of-the-art performance. The prototype UWB SoC demonstrates the power consumption of 198.6 mW during transmitter operation and 309.7, 442.5, and 528.9 mW for 1-RX, 2-RX, and 3-RX during packet reception. The proposed UWB SoC architecture and techniques provide a practical and efficient solution for IEEE 802.15.4/4z compliant UWB systems.
- 3 October 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 58 (12) , 3408-3420
A Fully Integrated IEEE 802.15.4/4z-Compliant UWB System-on-Chip RF Transceiver Supporting Precision Positioning in a CMOS 28-nm Process
This article presents a fully integrated ultrawideband (UWB) system-on-chip (SoC) that complies with IEEE 802.15.4/4z standard, providing precise positioning and secure communication capabilities. The proposed UWB SoC includes a radio frequency (RF) transceiver, a modem, a microcontroller unit (MCU), an eFlash, a power management unit (PMU), clock generation IPs, and peripheral blocks. The RF transceiver integrates RF switches and comprises two transmitters and three receivers. The proposed nonuniform quantization digital-to-analog converter (NQ-DAC) is used in the transmitter to enhance the quality of pulse sidelobe, and a receiver I/Q mismatch estimation technique using a double-sideband (DSB) transmitter as a reference is proposed. The UWB SoC operates in the frequencies at 6.5 GHz (Ch5) and 8 GHz (Ch9), achieving a location estimation precision of a few centimeters. The prototype UWB SoC is fabricated in a CMOS 28-nm process, and the experimental results under base pulse repetition frequencies (BPRFs) 6.81 Mbps show a receiver sensitivity of $-$ 96.1 dBm and a transmitter output peak power of 14.25 dBm, achieving the state-of-the-art performance. The prototype UWB SoC demonstrates the power consumption of 198.6 mW during transmitter operation and 309.7, 442.5, and 528.9 mW for 1-RX, 2-RX, and 3-RX during packet reception. The proposed UWB SoC architecture and techniques provide a practical and efficient solution for IEEE 802.15.4/4z compliant UWB systems.
- 18 August 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 55 (12) , 3400-3413
NB-IoT and GNSS All-In-One System-On-Chip Integrating RF Transceiver, 23-dBm CMOS Power Amplifier, Power Management Unit, and Clock Management System for Low Cost Solution
This article presents a fully integrated stand-alone narrowband Internet-of-Things (NB-IoT) and global navigation satellite system (GNSS) system-on-chip (SoC). It aims for an all-in-one system to integrate all necessary blocks such as an RF transceiver, a power management system (PMIP), and a clock management system and to save a bills-of-material (BOM) cost. An RF transceiver is integrated to support multi-band cellular IoT and GNSS with a CMOS RF power amplifier transmitting 23-dBm output power. A PMIP, including bucks, a boost, and low-dropout regulators (LDOs), is integrated to support coin cell or AAA battery and to support a wide input supply voltage range from 2.5 to 5 V. In addition, clock management system is embedded with a digitally controlled crystal oscillator (DCXO), a relaxation oscillator (RCO), and temperature sensor units (TSUs). It is fabricated in a standard 28-nm CMOS process and its size is 24.6 mm². The power consumption of always-on-block is 15 μW, and the sleep current consumption is less than 10 μA at 3.8 V.
- 18 August 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 55 (12) , 3400-3413
NB-IoT and GNSS All-In-One System-On-Chip Integrating RF Transceiver, 23-dBm CMOS Power Amplifier, Power Management Unit, and Clock Management System for Low Cost Solution
This article presents a fully integrated stand-alone narrowband Internet-of-Things (NB-IoT) and global navigation satellite system (GNSS) system-on-chip (SoC). It aims for an all-in-one system to integrate all necessary blocks such as an RF transceiver, a power management system (PMIP), and a clock management system and to save a bills-of-material (BOM) cost. An RF transceiver is integrated to support multi-band cellular IoT and GNSS with a CMOS RF power amplifier transmitting 23-dBm output power. A PMIP, including bucks, a boost, and low-dropout regulators (LDOs), is integrated to support coin cell or AAA battery and to support a wide input supply voltage range from 2.5 to 5 V. In addition, clock management system is embedded with a digitally controlled crystal oscillator (DCXO), a relaxation oscillator (RCO), and temperature sensor units (TSUs). It is fabricated in a standard 28-nm CMOS process and its size is 24.6 mm². The power consumption of always-on-block is 15 μW, and the sleep current consumption is less than 10 μA at 3.8 V.