Casey M. Davis
Casey M. Davis has a total of 50 co-authors. Here are the top co-authors by number of shared publications:
- Jonathan R. Thurston
Department of Chemistry University of Colorado Boulder Boulder CO 80309 USA
4 shared publications - Michael F. Toney
Department of Chemical and Biological Engineering University of Colorado Boulder Boulder CO 80309 USA
4 shared publications - Aiswarya Abhisek Mohapatra
Renewable and Sustainable Energy Institute
3 shared publications - Erin L. Ratcliff
School of Materials Science and Engineering, Georgia Institute of Technology, Atlanta, USA
3 shared publications - Stephen Barlow
School of Chemistry and Biochemistry and Center for Organic Photonics and Electronics, Georgia Institute of Technology, Atlanta, GA 30332-0400, USA
3 shared publications - Andrew John Ferguson
National Renewable Energy Laboratory
2 shared publications
Latest Publications
- 22 December 2025
- Published by American Chemical Society (ACS) in ACS Energy Letters
- Vol. 11 (1) , 945-946
Correction to “Electrolyte Immersion Increases Photoconductivity in a Model Polymer Photocathode”
- 22 December 2025
- Published by American Chemical Society (ACS) in ACS Energy Letters
- Vol. 11 (1) , 945-946
Correction to “Electrolyte Immersion Increases Photoconductivity in a Model Polymer Photocathode”
- 13 December 2025
- Published by American Chemical Society (ACS) in Journal of the American Chemical Society
- Vol. 147 (51) , 46806-46811
Harnessing Truxone-Based Electrically Conductive Metal–Organic Framework for Electrochromism
Metal-organic frameworks (MOFs) can exhibit tunable electrochromic properties through redox-active metal nodes or linkers, yet their inherently poor electrical conductivity confines redox activity and requires high operating voltages (>1 V), limiting device integration. Electrically conductive MOFs (c-MOFs) can overcome this but often rely on specific metal-linker combinations, due to the limited redox-active organic functional groups available in c-MOFs. Here, we leverage Cu-truxone, a c-MOF featuring redox-active carbonyl (C═O) groups with a conductivity of 1.9 × 10-2 S cm-1 that realizes linker-centric electrochromism. We developed an in situ growth method in which Cu-truxone is directly synthesized on a mercaptobenzoic acid-functionalized fluorine-doped tin oxide (FTO) substrate. This enables pronounced and efficient electrochromic switching at a low voltage range (2 C-1. Our findings showcase the potential of c-MOFs with redox-active functional groups in linkers for electrochromic applications.
- 13 December 2025
- Published by American Chemical Society (ACS) in Journal of the American Chemical Society
- Vol. 147 (51) , 46806-46811
Harnessing Truxone-Based Electrically Conductive Metal–Organic Framework for Electrochromism
Metal-organic frameworks (MOFs) can exhibit tunable electrochromic properties through redox-active metal nodes or linkers, yet their inherently poor electrical conductivity confines redox activity and requires high operating voltages (>1 V), limiting device integration. Electrically conductive MOFs (c-MOFs) can overcome this but often rely on specific metal-linker combinations, due to the limited redox-active organic functional groups available in c-MOFs. Here, we leverage Cu-truxone, a c-MOF featuring redox-active carbonyl (C═O) groups with a conductivity of 1.9 × 10-2 S cm-1 that realizes linker-centric electrochromism. We developed an in situ growth method in which Cu-truxone is directly synthesized on a mercaptobenzoic acid-functionalized fluorine-doped tin oxide (FTO) substrate. This enables pronounced and efficient electrochromic switching at a low voltage range (2 C-1. Our findings showcase the potential of c-MOFs with redox-active functional groups in linkers for electrochromic applications.
- 28 July 2025
- Published by American Chemical Society (ACS) in ACS Energy Letters
- p. 4019-4026
Electrolyte Immersion Increases Photoconductivity in a Model Polymer Photocathode
- 28 July 2025
- Published by American Chemical Society (ACS) in ACS Energy Letters
- p. 4019-4026
Electrolyte Immersion Increases Photoconductivity in a Model Polymer Photocathode
- 25 November 2024
- Published by Springer Nature in Nature Chemistry
- Vol. 16 (12) , 1921-1926
The importance of integrating energy justice into chemistry graduate student research and the associated pathways and barriers
- 25 November 2024
- Published by Springer Nature in Nature Chemistry
- Vol. 16 (12) , 1921-1926
The importance of integrating energy justice into chemistry graduate student research and the associated pathways and barriers
- 20 December 2023
- Published by Royal Society of Chemistry (RSC) in Chemical Communications
- Vol. 60 (8) , 988-991
Reducing delamination of an electron-transporting polymer from a metal oxide for electrochemical applications
An azide-modified phosphonic acid can be used to covalently tether polymers to indium tin oxide, preventing delamination and dissolution.
- 20 December 2023
- Published by Royal Society of Chemistry (RSC) in Chemical Communications
- Vol. 60 (8) , 988-991
Reducing delamination of an electron-transporting polymer from a metal oxide for electrochemical applications
An azide-modified phosphonic acid can be used to covalently tether polymers to indium tin oxide, preventing delamination and dissolution.
- Open Access
Disparate Redox Potentials in Mixed Isomer Electrolytes Reduce Voltage Efficiency of Energy Dense Flow Batteries
Electrolytes containing multiple redox couples are promising for improving the energy density of flow batteries. Here, two chelated chromium complexes that are structural isomers are characterized and combined to generate electrolytes containing up to 2 M of active species, corresponding to 53.6 Ah L−1. The mixed isomer approach enables a significantly higher active material content than the individual materials would allow, affording energy dense cells with Coulombic efficiencies of ≥99.6% at 100 mA cm−2 and an open circuit voltage of 1.65 V at 50% state-of-charge. This high concentration, however, comes with a caveat; at a given concentration, an equimolar mixed electrolyte leads to lower voltage efficiency compared to using the individual isomers, while Coulombic efficiency remains constant. Our work demonstrates that exploiting structural isomerism is an efficient approach to improve capacity, but active materials must be selected carefully in mixed systems as differences in operating potentials negatively affect energy efficiency.
Open AccessDisparate Redox Potentials in Mixed Isomer Electrolytes Reduce Voltage Efficiency of Energy Dense Flow Batteries
Electrolytes containing multiple redox couples are promising for improving the energy density of flow batteries. Here, two chelated chromium complexes that are structural isomers are characterized and combined to generate electrolytes containing up to 2 M of active species, corresponding to 53.6 Ah L−1. The mixed isomer approach enables a significantly higher active material content than the individual materials would allow, affording energy dense cells with Coulombic efficiencies of ≥99.6% at 100 mA cm−2 and an open circuit voltage of 1.65 V at 50% state-of-charge. This high concentration, however, comes with a caveat; at a given concentration, an equimolar mixed electrolyte leads to lower voltage efficiency compared to using the individual isomers, while Coulombic efficiency remains constant. Our work demonstrates that exploiting structural isomerism is an efficient approach to improve capacity, but active materials must be selected carefully in mixed systems as differences in operating potentials negatively affect energy efficiency.
- Open Access
Molecular Engineering of Redox Couples for Non-Aqueous Redox Flow Batteries
Redox flow batteries (RFBs) have attracted significant attention as a promising electrochemical energy storage technology, offering various advantages such as grid-scale electricity production with variable intermittent electricity delivery, enhanced safety compared to metal-ion batteries, decoupled energy and power density, and simplified manufacturing processes. For this review, we exclusively focus on organic, non-aqueous redox flow batteries. Specifically, we address the most recent progress and the major challenges related to the design and synthesis of robust redox-active organic compounds. An extensive examination of the synthesis and characterization of a wide spectrum of redox-active molecules, focusing particularly on derivatives of posolytes such as quinone, nitroxyl radicals, dialkoxybenzenes, and phenothiazine and negolytes such as viologen and pyridiniums, is provided. We explore the incorporation of various functional groups as documented in the references, aiming to enhance the chemical and electrochemical stability, as well as the solubility, of both the neutral and radical states of redox-active molecules. Additionally, we offer a comprehensive assessment of the cell-cycling performance exhibited by these redox-active molecules.
Open AccessMolecular Engineering of Redox Couples for Non-Aqueous Redox Flow Batteries
Redox flow batteries (RFBs) have attracted significant attention as a promising electrochemical energy storage technology, offering various advantages such as grid-scale electricity production with variable intermittent electricity delivery, enhanced safety compared to metal-ion batteries, decoupled energy and power density, and simplified manufacturing processes. For this review, we exclusively focus on organic, non-aqueous redox flow batteries. Specifically, we address the most recent progress and the major challenges related to the design and synthesis of robust redox-active organic compounds. An extensive examination of the synthesis and characterization of a wide spectrum of redox-active molecules, focusing particularly on derivatives of posolytes such as quinone, nitroxyl radicals, dialkoxybenzenes, and phenothiazine and negolytes such as viologen and pyridiniums, is provided. We explore the incorporation of various functional groups as documented in the references, aiming to enhance the chemical and electrochemical stability, as well as the solubility, of both the neutral and radical states of redox-active molecules. Additionally, we offer a comprehensive assessment of the cell-cycling performance exhibited by these redox-active molecules.
- 21 September 2022
- Published by American Chemical Society (ACS) in Journal of the American Chemical Society
- Vol. 144 (39) , 17753-17757
Maximizing Vanadium Deployment in Redox Flow Batteries Through Chelation
By tailoring the coordination sphere of vanadium to accommodate a 7-coordinate geometry, a highly soluble (>1.3 M) and reducing (-1.2 V vs Ag/AgCl) flow battery electrolyte is generated from [V(DTPA)]2-/3- (DTPA = diethylenetriaminepentaacetate). Bulk spectroelectrochemistry is performed in situ to assess material properties in both oxidized and reduced states. Flow batteries are assembled in near neutral pH conditions and operated with discharge energy densities of 12.5 Wh L-1 and high efficiency. Further, the first chelated flow battery using the same aminopolycarboxylate ligand for both electrolytes is generated. The presented batteries demonstrate comparable performance to the iron-vanadium and all-vanadium flow batteries while doubling the effective discharge energy of vanadium (Wh per mol V) and minimizing safety and operating risks, offering grid-scale energy storage alternatives.
- 21 September 2022
- Published by American Chemical Society (ACS) in Journal of the American Chemical Society
- Vol. 144 (39) , 17753-17757
Maximizing Vanadium Deployment in Redox Flow Batteries Through Chelation
By tailoring the coordination sphere of vanadium to accommodate a 7-coordinate geometry, a highly soluble (>1.3 M) and reducing (-1.2 V vs Ag/AgCl) flow battery electrolyte is generated from [V(DTPA)]2-/3- (DTPA = diethylenetriaminepentaacetate). Bulk spectroelectrochemistry is performed in situ to assess material properties in both oxidized and reduced states. Flow batteries are assembled in near neutral pH conditions and operated with discharge energy densities of 12.5 Wh L-1 and high efficiency. Further, the first chelated flow battery using the same aminopolycarboxylate ligand for both electrolytes is generated. The presented batteries demonstrate comparable performance to the iron-vanadium and all-vanadium flow batteries while doubling the effective discharge energy of vanadium (Wh per mol V) and minimizing safety and operating risks, offering grid-scale energy storage alternatives.