I. El Khadiri
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
I. El Khadiri has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
A. Najm-Eddine
Research Laboratory in Physics and Sciences for Engineers (LRPSI), Polydisciplinary Faculty, Béni-Mellal, Morocco
1 shared publication- Ahmed Bahlaoui
Sultan Moulay Slimane University
1 shared publication - I. Chiguer
Reseaech Laboratory in physics and Sciences for Engineers (LRPSI), Polydisciplinary Faculty, Béni-Mellal, Morocco
1 shared publication - Ismail Arroub
Sultan Moulay Slimane University
1 shared publication - Manuel Lagache
Polytech Annecy Chambery, Univ. Savoie, SYMME F-74000 Annecy, France
1 shared publication - Maria Zemzami
Mohamed V University
1 shared publication
Latest Publications
- Open Access
- 1 January 2023
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 2761 (1)
Assessing the effect of 3D printing temperature on polymer materials behavior and its interaction with other parameters
The present study is aimed to investigate the effect of the 3D printing temperature on the mechanical behavior of polymer materials. For this purpose, three levels of 3D printing temperature were chosen according to the polymer melting temperature range. The commercial polylactic acid PLA 3D870 was used as polymer filaments. The effect of the processing temperature on the mechanical elasticity and resistance was studied using 3-point bending test. In addition, two other process parameters were taken into account to determine the interaction effect of each of them with the printing temperature. The experimental results show a considerable effect of temperature on the stiffness and strength of printed polymer parts. The mechanical properties were maximum for the low temperature levels. Moreover, the resistance presents a significant interaction effect between temperature and feed rate on the one hand, and deposit angle on the other hand. For the rigidity, no significant interaction was found.
- 1 January 2023
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 2761 (1)
Open AccessAssessing the effect of 3D printing temperature on polymer materials behavior and its interaction with other parameters
The present study is aimed to investigate the effect of the 3D printing temperature on the mechanical behavior of polymer materials. For this purpose, three levels of 3D printing temperature were chosen according to the polymer melting temperature range. The commercial polylactic acid PLA 3D870 was used as polymer filaments. The effect of the processing temperature on the mechanical elasticity and resistance was studied using 3-point bending test. In addition, two other process parameters were taken into account to determine the interaction effect of each of them with the printing temperature. The experimental results show a considerable effect of temperature on the stiffness and strength of printed polymer parts. The mechanical properties were maximum for the low temperature levels. Moreover, the resistance presents a significant interaction effect between temperature and feed rate on the one hand, and deposit angle on the other hand. For the rigidity, no significant interaction was found.