Yaozu Yang

Due to the development of digital radio frequency memory (DRFM), active jamming against the main lobe of the radar has become mainstream in electronic warfare. The jamming infiltrates the radar receiver via the main lobe, covering up the target echo information. This greatly affects the detection, tracking, and localization of targets by radar. In this study, we consider jamming suppression based on the independence of RF features. First, two stacked sparse auto‐encoders (SSAEs) are built to extract the RF characteristics and signal features carried out by the actual radar signal for subsequent jamming suppression. This method can effectively separate RF features from signal features, making the extracted RF features more efficient and accurate. Then, an SSAE‐based jamming suppression auto‐encoder (JSAE) is proposed; the mixed signal, including the radar signal, jamming signal, and noise, is input to JSAE for dimensionality reduction. Therefore, the radar signal and RF features, extracted by the two SSAEs in the previous step, are used to constrain the features of the reduced mixed signal. Moreover, we integrate the feature level and signal level to jointly achieve jamming suppression. The original radar signal is used to assist the radar signal reconstructed by the decoder. By first filtering out interference‐related features and then reconstructing the signal, we can achieve better jamming suppression performance. Finally, the effectiveness of the proposed method is verified by simulating the actual collected data.

With the rapid development of modern military countermeasure technology, deep distinguish hostile radar is essential in electronic warfare. However, traditional radio frequency (RF) feature extraction methods can easily be interfered by signal information and fail due to the lack of research on RF feature extraction techniques for complex situations. Therefore, in this paper, first, the generation mechanism of RF structure information is discussed, and the influence of different signal information introduced by different operating parameters on RF structure feature extraction is analyzed. Then, an autoencoder (AE) network and an autoencoder metric (AEM) network are designed, introducing metric learning ideas, so that the extracted deep RF structure features have good stability and divisibility. Finally, radar emitter structure (RES) inversion is realized using the centroid-matching method. The experimental results demonstrate that this method exhibits good inversion performance under variable operating parameters (modulation type, frequency, bandwidth, input power). RES inversion including unknown operating parameters is realized for the first time, and it is shown that metric learning has the advantage of separability of RF feature extraction, which can provide an idea in emitter and RF feature extraction.