Stael Senra
Research Subjects
Stael Senra has a total of 18 co-authors. Here are the top co-authors by number of shared publications:
- Alexandre Hansen
Petrobras
4 shared publications - Arthur Ayres Neto
Universidade Federal Fluminense
4 shared publications - Bruno R. M. da Cunha
Petrobras
4 shared publications - Claudio R. Mansur Barros
Petrobras
4 shared publications - Cláudia Martins Peri Machado dos Santos
Petrobras
4 shared publications Fabio B. Azevedo
Petrobras
4 shared publications
Latest Publications
- 16 October 2024
- Published by ASME International in Journal of Offshore Mechanics and Arctic Engineering
- Vol. 147 (4) , 1-17
FPSO Roll Motions Driven by Second-Order Forces and the Impacts on SLWR Riser Design
The dynamic behavior of risers is highly influenced by the floating production unit (FPU) motions, associated with environmental loads, caused by waves, current, and wind. Particularly, as well known, under potential flow modeling, wave loads may be represented through power series expansions, with respect to a small parameter ε. First-order wave forces pulsate in the frequency range of the incident wave spectra, whereas second-order wave forces are related to sum or difference frequencies of the same spectra. The so-called second-order difference frequencies forces may then be responsible by resonating motions of the vessel in that range. Significant low-frequency motions due to second-order forces are commonly observed in the horizontal plane, resonating low natural frequencies of moored floating systems characterized by low mooring stiffnesses. Recently, however, this phenomenon was also observed for roll motions in several new floating production storage and offloading (FPSOs) that will operate in the pre-salt of Santos Basin. The phenomenon had already been detected in a deep draft semi-submersible in Campos Basin, but only more recently in FPSOs. The new floating units are characterized by high roll natural periods, above the typical wave period range in the pre-salt region, and the roll response to the second-order difference frequencies forces can be significant. This phenomenon was indeed detected in model tests and confirmed by numerical studies. In fact, this additional FPSO roll behavior occurs in typical periods slightly above 20 s, imposing displacements and accelerations that can directly affect the dynamics of the riser top region. The present paper addresses this phenomenon and its possible impact on steel lazy-wave riser (SLWR) designs.
- 16 October 2024
- Published by ASME International in Journal of Offshore Mechanics and Arctic Engineering
- Vol. 147 (4) , 1-17
FPSO Roll Motions Driven by Second-Order Forces and the Impacts on SLWR Riser Design
The dynamic behavior of risers is highly influenced by the floating production unit (FPU) motions, associated with environmental loads, caused by waves, current, and wind. Particularly, as well known, under potential flow modeling, wave loads may be represented through power series expansions, with respect to a small parameter ε. First-order wave forces pulsate in the frequency range of the incident wave spectra, whereas second-order wave forces are related to sum or difference frequencies of the same spectra. The so-called second-order difference frequencies forces may then be responsible by resonating motions of the vessel in that range. Significant low-frequency motions due to second-order forces are commonly observed in the horizontal plane, resonating low natural frequencies of moored floating systems characterized by low mooring stiffnesses. Recently, however, this phenomenon was also observed for roll motions in several new floating production storage and offloading (FPSOs) that will operate in the pre-salt of Santos Basin. The phenomenon had already been detected in a deep draft semi-submersible in Campos Basin, but only more recently in FPSOs. The new floating units are characterized by high roll natural periods, above the typical wave period range in the pre-salt region, and the roll response to the second-order difference frequencies forces can be significant. This phenomenon was indeed detected in model tests and confirmed by numerical studies. In fact, this additional FPSO roll behavior occurs in typical periods slightly above 20 s, imposing displacements and accelerations that can directly affect the dynamics of the riser top region. The present paper addresses this phenomenon and its possible impact on steel lazy-wave riser (SLWR) designs.
- 26 July 2024
- Published by Springer Nature
- p. 581-648
Rigid Offshore Pipelines
- 9 March 2024
- Published by Springer Nature
- p. 1-69
Rigid Offshore Pipelines
- 17 October 2023
- Published by Springer Nature
- p. 1-69
Rigid Offshore Pipelines
- 15 September 2023
- Published by Springer Nature
- p. 1-69
Rigid Offshore Pipelines